Valeria Lanzilotto

Magnetic Bistability in a Submonolayer of Sublimated Fe4 Single-Molecule Magnets

We demonstrate that Fe4 molecules can be deposited on gold by thermal sublimation in ultra-high vacuum with retention of single molecule magnet behavior. A magnetic hysteresis comparable to that found in bulk samples is indeed observed when a submonolayer film is studied by X-ray magnetic circular dichroism. Scanning tunneling microscopy evidences that Fe4 molecules are assembled in a two-dimensional lattice with short-range hexagonal order and coexist with a smaller contaminant. The presence of intact Fe4 molecules and the retention of their bistable magnetic behavior on the gold surface are supported by density functional theory calculations.

Magnetic fingerprint of individual Fe4 molecular magnets under compression by a scanning tunnelling microscope

Single-molecule magnets (SMMs) present a promising avenue to develop spintronic technologies. Addressing individual molecules with electrical leads in SMM-based spintronic devices remains a ubiquitous challenge: interactions with metallic electrodes can drastically modify the SMMs properties by charge transfer or through changes in the molecular structure. Here, we probe electrical transport through individual Fe4 SMMs using a scanning tunnelling microscope at 0.5 K. Correlation of topographic and spectroscopic information permits identification of the spin excitation fingerprint of intact Fe4 molecules. Building from this, we find that the exchange coupling strength within the molecules magnetic core is significantly enhanced. First-principles calculations support the conclusion that this is the result of confinement of the molecule in the two-contact junction formed by the microscope tip and the sample surface.

Weakly interacting molecular layer of spinning C60 molecules on TiO2 (110) surfaces.

The adsorption of C(60), a typical acceptor organic molecule, on a TiO(2) (110) surface has been investigated by a multitechnique combination, including van der Waals density functional calculations. It is shown that the adsorbed molecules form a weakly interacting molecular layer, which sits on the fivefold-coordinated Ti that is confined between the prominent bridging oxygen rows (see figure).

High resolution NEXAFS of perylene and PTCDI: a surface science approach to molecular orbital analysis

We made use of synchrotron radiation to perform near edge X-ray absorption fine structure spectroscopy, NEXAFS, at the carbon K-edge of perylene and perylene-tetracarboxylic-diimide, PTCDI. Reference spectra measured for isolated molecules in the gas phase are compared with polarization dependent NEXAFS spectra measured on highly oriented thin films in order to study the symmetry of the molecular orbitals. The molecular overlayers are grown onto the rutile TiO2(110) surface for which the large anisotropic corrugation effectively drives the molecular orientation, while its dielectric nature prevents the rehybridization of the molecular orbitals. We employed density functional theory, DFT, calculations to disentangle the contribution of specific carbon atoms to the molecular density of states. Numerical simulations correctly predict the observed NEXAFS azimuthal dichroism of the σ* resonances above the ionization threshold, from which we determine the full geometric orientation of the overlayer molecules. A discrepancy observed for the spectral contribution of the imide carbon atom to the calculated unoccupied molecular orbitals has been explained in terms of initial state effects, as determined by Hartree-Fock corrections and in full agreement with the corresponding shift of the C 1s core level measured by X-ray photoelectron spectroscopy, XPS.

Valence electronic structure of sublimated Fe4 single-molecule magnets: an experimental and theoretical characterization

The valence electronic structures of two single-molecule magnets (SMMs), [Fe4(L)2(dpm)6] and [Fe4(L)2(pta)6], (Hdpm = dipivaloylmethane, Hpta = pivaloyltrifluoroacetone, L3− = Ph–C(CH2O)33−), are investigated by means of ultraviolet photoemission spectroscopy (UPS) and ab initio calculations. The experimental UPS spectra of both compounds are analysed and compared with the total density of states (TDOS) computed with the hybrid functional PBE0. The substitution of half of the methyl groups in [Fe4(L)2(dpm)6] with fluorine atoms in [Fe4(L)2(pta)6] unexpectedly affects the spectrum shape in the Fermi region, thus becoming a useful fingerprint of the two SMMs. Moreover, a computational protocol at DFT + U level of theory is assessed on both compounds, which is in good agreement with the experimental spectroscopic and magnetic data. The basis for the future modelling of the adsorption of Fe4 clusters on surfaces is established.

Partially Reversible Photoinduced Chemical Changes in a Mixed-Ion Perovskite Material for Solar Cells

Metal halide perovskites have emerged as materials of high interest for solar energy-to-electricity conversion, and in particular, the use of mixed-ion structures has led to high power conversion efficiencies and improved stability. For this reason, it is important to develop means to obtain atomic level understanding of the photoinduced behavior of these materials including processes such as photoinduced phase separation and ion migration. In this paper, we implement a new methodology combining visible laser illumination of a mixed-ion perovskite ((FAPbI3)0.85(MAPbBr3)0.15) with the element specificity and chemical sensitivity of core-level photoelectron spectroscopy. By carrying out measurements at a synchrotron beamline optimized for low X-ray fluxes, we are able to avoid sample changes due to X-ray illumination and are therefore able to monitor what sample changes are induced by visible illumination only. We find that laser illumination causes partially reversible chemistry in the surface region, including enrichment of bromide at the surface, which could be related to a phase separation into bromide- and iodide-rich phases. We also observe a partially reversible formation of metallic lead in the perovskite structure. These processes occur on the time scale of minutes during illumination. The presented methodology has a large potential for understanding light-induced chemistry in photoactive materials and could specifically be extended to systematically study the impact of morphology and composition on the photostability of metal halide perovskites.

UHV deposition and characterization of a mononuclear iron(III) β-diketonate complex on Au(111)

Summary The adsorption of the sterically hindered β-diketonate complex Fe(dpm)3, where Hdpm = dipivaloylmethane, on Au(111) was investigated by ultraviolet photoelectron spectroscopy (UPS) and scanning tunnelling microscopy (STM). The high volatility of the molecule limited the growth of the film to a few monolayers. While UPS evidenced the presence of the β-diketonate ligands on the surface, the integrity of the molecule on the surface could not be assessed. The low temperature STM images were more informative and at submonolayer coverage they showed the presence of regular domains characterized by a flat morphology and height of ≈0.3 nm. Along with these domains, tetra-lobed features adsorbed on the kinks of the herringbone were also observed. DFT-simulated images of the pristine molecule and its possible decomposition products allowed to assess the partial fragmentation of Fe(dpm)3 upon adsorption on the Au(111) surface. Structural features with intact molecules were only observed for the saturation coverage. An ex situ prepared thick film of the complex was also investigated by X-ray magnetic circular dichroism (XMCD) and features typical of high-spin iron(III) in octahedral environment were observed.

X-Ray Photoelectron Spectroscopy for Understanding Molecular and Hybrid Solar Cells

X-ray photoelectron spectroscopy is a powerful tool for the characterization of molecular and hybrid solar cells. This technique allows for atomic-level characterization of their components as well as for the determination of the electronic structure that governs the key conversion processes. In this chapter, we introduce the basic concepts of electronic structure in molecules and semiconducting materials followed by a description of the concepts of photoelectron spectroscopy and how they relate to electronic structure. Finally, we give examples of the application of photoelectron spectroscopy to different types of molecular and hybrid solar cell materials demonstrating the type of information that can be obtained, to gain fundamental understanding and to further develop such devices.

Defect induced water bilayer growth on anatase TiO2(101)

Preparing an anatase TiO2(101) surface with a high density of oxygen vacancies and associated reduced Ti species in the near-surface region results in drastic changes in the water adsorption chemistry compared to adsorption on a highly stoichiometric surface. Using synchrotron radiation excited photoelectron spectroscopy, we observe a change in the water growth mode, from layer-by-layer growth on the highly stoichiometric surface to bilayer growth on the reduced surface. Furthermore, we have been able to observe Ti3+ enrichment at the surface upon water adsorption. The Ti3+ enrichment occurs concomitant with effective water dissociation into hydroxyls with a very high thermal stability. The water bilayer on the reduced surface is thermally more stable than that on the stoichiometric surface, and it is more efficient in promoting further water dissociation upon heating. The results thus show how the presence of subsurface defects can alter the wetting mechanism of an oxide surface.

Spectroscopic Fingerprints of Intermolecular H-Bonding Interactions in Carbon Nitride Model Compounds

The effect of intermolecular H-bonding interactions on the local electronic structure of N-containing functional groups (amino group and pyridine-like N) that are characteristic of polymeric carbon nitride materials p-CN(H), a new class of metal-free organophotocatalysts, was investigated. Specifically, the melamine molecule, a building block of p-CN(H), was characterized by X-ray photoelectron (XPS) and near edge X-ray absorption fine structure (NEXAFS) spectroscopy. The molecule was studied as a noninteracting system in the gas phase and in the solid state within a H-bonded network. With the support of DFT simulations of the spectra, it was found that the H-bonds mainly affect the N 1s level of the amino group, leaving the N 1s level of the pyridine-like N mostly unperturbed. This is responsible for a reduction of the chemical shift between the two XPS N 1s levels relative to free melamine. Consequently, N K-edge NEXAFS resonances involving the amino N 1s level also shift to lower photon energies. Moreover, the solid-state absorption spectra showed significant modification/quenching of resonances related to transitions from the amino N 1s level to σ* orbitals involving the NH2 termini.