Véronique Riffault

VOC in an urban and industrial harbor on the French North Sea coast during two contrasted meteorological situations

Two measurement campaigns of volatile organic compounds (VOC) were carried out in the industrial city of Dunkerque, using Radiello passive samplers during winter (16-23 January) and summer (6-13 June) 2007. 174 compounds were identified belonging to six chemical families. Classifying sampling sites with similar chemical profiles by hierarchical ascending classification resulted in 4 groups that reflected the influence of the main industrial and urban sources of pollution. Also, the BTEX (Benzene, Toluene, Ethylbenzene and Xylenes) quantification allowed us to map their levels of concentration. Benzene and toluene (BT) showed high concentrations in Northern Dunkerque reflecting the influence of two industrial plants. Differences among spatial distributions of the BT concentrations over contrasted meteorological conditions were also observed. An atypical ratio of T/B in the summer samples led us to investigate the BTEX origins shedding light on the contribution of pollutants transported across various zones of VOC emissions situated in Europe.

Simultaneous determination by ultra-performance liquid chromatography–atmospheric pressure chemical ionization time-of-flight mass spectrometry of nitrated and oxygenated PAHs found in air and soot particles

An ultra-performance liquid chromatographic-atmospheric pressure chemical ionization time-of-flight mass spectrometric (UPLC-APCIToFMS) method for rapid analysis of twelve nitrated polycyclic aromatic hydrocarbons (NPAHs) and nine oxygenated polycyclic aromatic hydrocarbons (OPAHs) in particle samples has been developed. The extraction step using pressurized liquid extraction was optimized by experimental design methods and the concentrated extracts were analyzed without further clean-up. Matrix effects resulting in suppression or enhancement of the response during the ionization step were not observed. The suitability of the developed method is demonstrated by analysis of six different particle samples including standard reference materials, atmospheric particles collected by a high-volume sampler at an urban background site, and a soot sample from a burner. Results from these measurements showed clear differences between the different kinds of samples. Concentrations from reference materials are in good agreement with those from previous studies. Additionally a clear seasonal trend could be observed in atmospheric NPAH and OPAH concentrations found in real samples, with higher concentrations in winter.

Fine and Ultrafine Particles in the Vicinity of Industrial Activities: A Review

This review synthesizes the existing knowledge on the characteristics of PM2.5 at sites under the direct influence of industrial emissions, with a specific focus on their morphology, size distributions and chemical composition. Results from online and off-line analytical techniques indicate a high temporal and spatial variability of mass size distribution and chemical composition depending on the type of industrial processes, the sampling distances and frequencies, and the meteorological conditions. Tracers of specific activities have been identified in a number of studies and may help to provide estimates of the relative contribution of pollutant sources from heavily industrialized areas.

Development and validation of an ultra-high-performance liquid chromatography coupled to time-of-flight mass spectrometry method to quantify benzoic acid and long-chain monocarboxylic acids (C12-C28) in atmospheric aerosols.

An ultra-high-performance liquid chromatography/time-of-flight mass spectrometry (with negative ion electrospray ionization) methodology was developed for the simultaneous quantification of benzoic acid and 15 long-chain monocarboxylic acids (MCAs) in ambient aerosols. A fast and quantitative pressurized fluid extraction procedure was optimized using experimental design and the extracts were analyzed without any further clean-up step. Chromatographic separation was achieved on a BEH-C18 column with a mobile phase consisting of 5 mM formic acid in water/acetonitrile (90:10, v/v) and methanol. Excellent precision and accuracies in the MS mass measurements were observed. The method was validated using actual samples spiked with a solution containing either standards or 13C-surrogates. Matrix effects were observed for the C14 MCA only. It was then applied to air particulate reference materials and atmospheric samples collected by a low-volume sampler.

Investigating the Heterogeneous Interaction of VOCs with Natural Atmospheric Particles: Adsorption of Limonene and Toluene on Saharan Mineral Dusts

The heterogeneous interaction of limonene and toluene with Saharan dusts was investigated under dark conditions, pressure of 1 atm, and temperature 293 K. The mineral dust samples were collected from six different regions along the Sahara desert, extending from Tunisia to the western Atlantic coastal areas of Morocco, and experiments were carried out with the smallest sieved fractions, that is, inferior to 100 μm. N2 sorption measurements, granulometric analysis, and X-ray fluorescence and diffraction (XRF and XRD) measurements were conducted to determine the physicochemical properties of the particles. The chemical characterization showed that dust originating from mideastern Sahara has a significantly higher SiO2 content (∼ 82%) than dust collected from the western coastal regions where the SiO2 relative abundance was ∼ 50%. A novel experimental setup combining diffuse reflectance infrared Fourier transform spectroscopy (DRIFTS), selected-ion flow-tube mass spectrometry (SIFT-MS), and long path transmission Fourier transform infrared spectroscopy (FTIR) allowed us to follow both the adsorbed and gas phases. The kinetic adsorption/desorption measurements were performed using purified dry air as bath gas, exposing each dust surface to 10 ppm of the selective volatile organic compound (VOC). The adsorption of limonene was independent of the SiO2 content, given the experimental uncertainties, and the coverage measurements ranged between (10 and 18) × 10(13) molecules cm(-2). Experimental results suggest that other metal oxides that could possibly influence dust acidity may enhance the adsorption of limonene. On the contrary, in the case of toluene, the adsorption capacities of the Saharan samples increased with decreasing SiO2 content; however, the coverage measurements were significantly lower than those of limonene and ranged between (2 and 12) × 10(13) molecules cm(-2). Flushing the surface with purified dry air showed that VOC desorption is not a completely reversible process at room temperature. The reversibly adsorbed fraction and the rate coefficients of desorption, kdes, depended inversely on the SiO2 relative abundance for both VOCs.

Analysis of phthalic, isophthalic and long-chain (C4–C12) dicarboxylic acids in atmospheric aerosols by UPLC/ESI/ToF-MS

A new analytical method for the simultaneous determination of phthalic, isophthalic and 14 long-chain dicarboxylic acids in ambient aerosols by ultra-performance liquid chromatography/time-of-flight mass spectrometry with negative-ion electrospray ionization was developed and validated. A fast and quantitative pressurized fluid extraction procedure with water as solvent was optimized using sampling filters spiked with a standard solution and experimental design to determine the influential factors and interactions. The extracts were analyzed without any further clean-up step. Chromatographic separation was achieved with a mobile phase consisting of 20 mM formic acid in water and methanol/acetonitrile (60 : 40, v/v). Excellent precision and accuracies in the MS mass measurements were observed. Matrix effects were investigated by spiking actual samples with a solution containing standards. The method was applied to air particulate reference materials and atmospheric samples collected by a low-volume sampler at a French urban background site.

Reactive and nonreactive ozone uptake during aging of oleic acid particles.

The ozonolysis of submicrometer (150 nm) oleic acid (OL) particles in an aerosol flow tube has been studied for a wide range of initial ozone concentrations from 25 ppb to 1100 ppb. Both reactants were monitored, as well as the four main reaction products (nonanal, azelaic acid, nonanoic acid, and 9-oxononanoic), by gas chromatography-mass spectrometer, high resolution-time of flight-aerosol mass spectrometer, proton transfer reaction-time of flight-mass spectrometer, and ozone analyzer. The values for the initial uptake coefficients derived from each reactant decay are in the same range: γO3-0 = (1.5 ± 0.1) × 10(-3) and γOL-0 = (1.0 ± 0.2) × 10(-3). The ozone uptake coefficient is highly decreased when particles are in an advanced oxidized state (γO3-∞ = 5 × 10(-5)). Concerning reaction products, nonanal was mainly observed in the gas-phase (∼80%) with a carbon yield of ∼29%. Nonanoic, azelaic, and 9-oxonanonoic acids have been quantified in the condensed phase with carbon yields of respectively 6.6%, 5.3%, and 31.4%. The changes in chemical composition induce a slight rise in particle density, whereas the aerodynamic particle diameter increases by 10%. The initial molar quantities of ozone and OL were chosen to obtain different initial stoichiometries in order to explore conditions where either of them is the limiting reactant. Drastic changes in reactivity were observed as a function of the initial stoichiometry. In conditions where OL was the initial limiting reactant, up to a total of four molecules of O3 were lost from the gas phase, whereas only one OL molecule was consumed.

Experimental study of the reactions of limonene with OH and OD radicals: kinetics and products.

The kinetics of the reactions of limonene with OH and OD radicals has been studied using a low-pressure flow tube reactor coupled with a quadrupole mass spectrometer: OH + C10H16 → products (1), OD + C10H16 → products (2). The rate constants of the title reactions were determined using four different approaches: either monitoring the kinetics of OH (OD) radicals or limonene consumption in excess of limonene or of the radicals, respectively (absolute method), and by the relative rate method using either the reaction OH (OD) + Br2 or OH (OD) + DMDS (dimethyl disulfide) as the reference one and following HOBr (DOBr) formation or DMDS and limonene consumption, respectively. As a result of the absolute and relative measurements, the overall rate coefficients, k1 = (3.0 ± 0.5) × 10(-11) exp((515 ± 50)/T) and k2 = (2.5 ± 0.6) × 10(-11) exp((575 ± 60)/T) cm(3) molecule(-1) s(-1), were determined at a pressure of 1 Torr of helium over the temperature ranges 220-360 and 233-353 K, respectively. k1 was found to be pressure independent over the range 0.5-5 Torr. There are two possible pathways for the reaction between OH (OD) and limonene: addition of the radical to one of the limonene double bonds (reactions 1a and 2a ) and abstraction of a hydrogen atom (reactions 1b and 2b ), resulting in the formation of H2O (HOD). Measurements of the HOD yield as a function of temperature led to the following branching ratio of the H atom abstraction channel: k2b/k2 = (0.07 ± 0.03) × exp((460 ± 140)/T) for T = (253-355) K.

Development of a New Flow Reactor for Kinetic Studies. Application to the Ozonolysis of a Series of Alkenes

A new flow reactor has been developed to study ozonolysis reactions at ambient pressure and room temperature (297 ± 2 K). The reaction kinetics of O(3) with 4-methyl-1-pentene (4M1P), 2-methyl-2-pentene (2M2P), 2,4,4-trimethyl-1-pentene (tM1P), 2,4,4-trimethyl-2-pentene (tM2P) and α-pinene have been investigated under pseudo-first-order conditions. Absolute measurements of the rate coefficients have been carried out by recording O(3) consumption in excess of organic compound. Alkene concentrations have been determined by sampling adsorbent cartridges that were thermodesorbed and analyzed by gas-chromatography coupled to flame ionization detection. Complementary experimental data have been obtained using a 250 L Teflon smog chamber. The following ozonolysis rate coefficients can be proposed (in cm(3) molecule(-1) s(-1)): k(4M1P) = (8.23 ± 0.50) × 10(-18), k(2M2P) = (4.54 ± 0.96) × 10(-16), k(tM1P) = (1.48 ± 0.11) × 10(-17), k(tM2P) = (1.25 ± 0.10) × 10(-16), and k(α-pinene) = (1.29 ± 0.16) × 10(-16), in very good agreement with literature values. The products of tM2P ozonolysis have been investigated, and branching ratios of (21.4 ± 2.8)% and (73.9 ± 7.3)% have been determined for acetone and 2,2-dimethyl-propanal, respectively. Additionally, a new nonoxidized intermediate, 2-methyl-1-propene, has been identified and quantified. A topological SAR analysis was also performed to strengthen the consistency of the kinetic data obtained with this new flow reactor.