Y.M. Lin

Aerobic sludge granulation: A tale of two polysaccharides?

Aerobic sludge granules are suspended biofilms with the potential to reduce the cost and footprint of secondary wastewater treatment. Attempts to answer how and why they form leads to a consideration of the role of their extracellular polymeric substances (EPS) in determining their physical and microbiological properties. The exopolysaccharide components of this matrix, in particular, have received attention as putative structural, gel-forming agents. Two quite different exopolysaccharides have been proposed as the gel-forming constituents, with their gel properties clearly different from those of activated sludge EPS. This review aims to address the question of whether more than one gel-forming exopolysaccharide exist in granules. Based on the available structural data, it seems likely that they are different gel-forming polymers and their differences are not artifacts of the analytical methods used. Nonetheless, both proposed structural gel polymers are extracted and purified based on procedures selecting for anionic polar polysaccharides soluble at high pH, and both contain hexuronic acids. Granulation does not result from EPS synthesis by any single microbial population, nor from production of a single exopolysaccharide. Future studies using solvents suitable for recalcitrant polysaccharides are likely to reveal important structural roles for other polysaccharides. It is hoped that this article will serve as a guide for subsequent studies into understanding the roles of exopolysaccharides in aerobic granular sludge.

The chemical and mechanical differences between alginate-like exopolysaccharides isolated from aerobic flocculent sludge and aerobic granular sludge

This study aimed to investigate differences in the gel matrix of aerobic granular sludge and normal aerobic flocculent sludge. From both types of sludge that fed with the same municipal sewage, the functional gel-forming exopolysaccharides, alginate-like exopolysaccharides, were isolated. These two exopolysaccharides were chemically fractionated, and investigated by FT-IR spectroscopy. The isolated polymers were made into a gel by calcium addition and the mechanical properties of these reconstituted gels were measured by a low load compression tester. The viscoelastic behavior of the gels was described by a generalized Maxwell model. The alginate-like exopolysaccharides derived from aerobic granules had significantly higher amount of poly(guluronic acid) blocks but lower amount of poly(guluronic acid-manuronic acid) blocks in the chemical structure, while the alginate-like exopolysaccharides derived from aerobic flocculent sludge had equal amount of poly(guluronic acid) blocks and poly(guluronic acid-manuronic acid) blocks. These differences result in a perfect gel-forming capability of alginate-like exopolysaccharides derived from aerobic granules and bestowed this exopolysaccharides gel a stronger mechanical property as compared to alginate-like exopolysaccharides derived from aerobic flocculent sludge. The different chemical and mechanical properties of these two exopolysaccharides contributed to the distinguished characteristics between aerobic granular sludge and aerobic flocculent sludge.

The contribution of exopolysaccharides induced struvites accumulation to ammonium adsorption in aerobic granular sludge.

Aerobic granular sludge from a lab-scale reactor with simultaneous nitrification/denitrification and enhanced biological phosphorus removal processes exhibited significant amount of ammonium adsorption (1.5 mg NH4+-N/g TSS at an ammonium concentration of 30 mg N/L). Potassium release accompanied ammonium adsorption, indicating an ion exchange process. The existence of potassium magnesium phosphate (K-struvite) as one of potassium sources in the granular sludge was studied by X-ray diffraction analysis (XRD). Artificially prepared K-struvite was indeed shown to adsorb ammonium. Alginate-like exopolysaccharides were isolated and their inducement for struvite formation was investigated as well. Potassium magnesium phosphate proved to be a major factor for ammonium adsorption on the granular sludge. Struvites (potassium/ammonium magnesium phosphate) accumulate in aerobic granular sludge due to inducing of precipitation by alginate-like exopolysaccharides.

Apatite accumulation enhances the mechanical property of anammox granules

The strength of granular sludge is essential for the mechanical stability of the granules. Inorganic precipitants form a major factor influencing the strength of the granules. To check the possibility of apatite accumulation in anammox granules, and study its contribution to the mechanical strength of granules, anammox granular sludge was collected from Dokhaven municipal wastewater treatment plant, the Netherlands. Mineral precipitation inside the granules was visualized by micro-computed tomography, and apatite was identified by electron probe microanalysis and X-ray powder diffraction. The mechanical strength of anammox granules was measured by a low load compression tester. The contribution of apatite to the mechanical strength was evaluated by the generalized Maxwell model. Ca-PO4 minerals are reported to accumulate in anammox granules. A transformation of Ca-PO4 happens, and apatite is the final stable form. The accumulation of apatite increases the mechanical strength of anammox granules. A fast method to monitor and evaluate the accumulation of minerals in anammox granules was proposed.

The acid soluble extracellular polymeric substance of aerobic granular sludge dominated by Defluviicoccus sp.

A new acid soluble extracellular polymeric substance (acid soluble EPS) was extracted from an acetate fed aerobic granular sludge reactor operated at 35xa0°C. Acid soluble EPS dominated granules exhibited a remarkable and distinctive tangled tubular morphology. These granules are dominated by Defluviicoccus Cluster II organisms. Acetic acid instead of the usually required alkaline extraction medium was needed to dissolve the granules and solubilise the polymeric matrix. The extracted acid soluble EPS was analysed and identified using various instrumental analysis including 1H and 13C Nuclear Magnetic Resonance, Fourier Transform Infrared Spectroscopy and Raman spectroscopy. In addition, the glycoconjugates were characterized by fluorescence lectin-binding analysis. The acid soluble EPS is α-(1xa0→xa04) linked polysaccharide, containing both glucose and galactose as monomers. There are OCH3 groups connected to the glucose monomer. Transmission and scanning electron microscopy (TEM, SEM) as well as confocal laser scanning microscopy (CLSM) showed that the acid soluble EPS was present as a tightly bound capsular EPS around bacterial cells ordered into a sarcinae-like growth pattern. The special granule morphology is decided by the acid soluble EPS produced by Defluviicoccus Cluster II organisms. This work shows that no single one method can be used to extract all possible extracellular polymeric substances. Results obtained here can support the elucidation of biofilm formation and structure in future research.

Extraction of structural extracellular polymeric substances from aerobic granular sludge

To evaluate and develop methodologies for the extraction of gel-forming extracellular polymeric substances (EPS), EPS from aerobic granular sludge (AGS) was extracted using six different methods (centrifugation, sonication, ethylenediaminetetraacetic acid (EDTA), formamide with sodium hydroxide (NaOH), formaldehyde with NaOH and sodium carbonate (Na2CO3) with heat and constant mixing). AGS was collected from a pilot wastewater treatment reactor. The ionic gel-forming property of the extracted EPS of the six different extraction methods was tested with calcium ions (Ca2+). From the six extraction methods used, only the Na2CO3 extraction could solubilize the hydrogel matrix of AGS. The alginate-like extracellular polymers (ALE) recovered with this method formed ionic gel beads with Ca2+. The Ca2+-ALE beads were stable in EDTA, formamide with NaOH and formaldehyde with NaOH, indicating that ALE are one part of the structural polymers in EPS. It is recommended to use an extraction method that combines physical and chemical treatment to solubilize AGS and extract structural EPS.

Glycosylated amyloid-like proteins in the structural extracellular polymers of aerobic granular sludge enriched with ammonium-oxidizing bacteria

A new type of structural extracellular polymers (EPS) was extracted from aerobic granular sludge dominated by ammonium‐oxidizing bacteria. It was analyzed by Raman and FTIR spectroscopy to characterize specific amino acids and protein secondary structure, and by SDS‐PAGE with different stains to identify different glycoconjugates. Its intrinsic fluorescence was captured to visualize the location of the extracted EPS in the nitrifying granules, and its hydrogel‐forming property was studied by rheometry. The extracted EPS is abundant with cross ß‐sheet secondary structure, contains glycosylated proteins/polypeptides, and rich in tryptophan. It forms hydrogel with high mechanical strength. The extraction and discovery of glycosylated proteins and/or amyloids further shows that conventionally used extraction and characterization techniques are not adequate for the study of structural extracellular polymers in biofilms and/or granular sludge. Confirming amyloids secondary structure in such a complex sample is challengeable due to the possibility of amyloids glycosylation and self‐assembly. A new definition of extracellular polymers components which includes glycosylated proteins and a better approach to studying them is required to stimulate biofilm research.

Identification of glycoproteins isolated from extracellular polymeric substances of full-scale anammox granular sludge

ANaerobic AMMonium OXidation (anammox) is an established process for efficient nitrogen removal from wastewater, relying on anammox bacteria to form stable biofilms or granules. To understand the formation, structure, and stability of anammox granules, it is important to determine the composition of the extracellular polymeric substances (EPS). The aim of this research was to elucidate the nature of the proteins, which are the major fraction of the EPS and were suspected to be glycosylated. EPS were extracted from full-scale anammox granular sludge, dominated by “Candidatus Brocadia”, and subjected to denaturing polyacrylamide gel electrophoresis. By further analysis with mass spectrometry, a high abundant glycoprotein, carrying a heterogeneous O-glycan structure, was identified. The potential glycosylation sequence motif was identical to that proposed for the surface layer protein of “Candidatus Kuenenia stuttgartiensis”. The heavily glycosylated protein forms a large fraction of the EPS and was also located by lectin staining. Therefore, we hypothesize an important role of glycoproteins in the structuring of anammox granules, comparable to the importance of glycans in the extracellular matrix of multicellular organisms. Furthermore, different glycoconjugates may have distinct roles in the matrix of granular sludge, which requires more in-depth characterization of different glycoconjugates in future EPS studies.

Effect of Mg/Ca molar ratios on characteristics of anaerobic-anoxic denitrifying dephosphatation

In this study, the effect of three Mg/Ca molar ratios (5.0, 3.8 and 1.7) on denitrifying phosphate removal performance, biomass morphology, and Extracellular Polymeric Substances (EPS) were examined. Results showed that when the influent Mg/Ca molar ratio was 3.8, the anaerobic-anoxic EBPR performed complete phosphate removal. The microbial bacterial population was a mixed culture comprised of 81±3% DPAO and 13±2% denitrifying glycogen accumulating organisms (DGAO). A higher influent Mg/Ca molar ratio (5.0) had a distinct impact on phosphate removal, biomass morphology, and EPS. This probably induced the deterioration of the anaerobic-anoxic Enhanced Biological Phosphorus Removal (EBPR). The results of this study may inform the proper operation of an anaerobic-anoxic EBPR, and contribute to its application in the real world.