Yanyan Feng

Ultrafast Saturable Absorption of Two-Dimensional MoS2 Nanosheets

Employing high-yield production of layered materials by liquid-phase exfoliation, molybdenum disulfide (MoS2) dispersions with large populations of single and few layers were prepared. Electron microscopy verified the high quality of the two-dimensional MoS2 nanostructures. Atomic force microscopy analysis revealed that ~39% of the MoS2 flakes had thicknesses of less than 5 nm. Linewidth and frequency difference of the E(1)2g and A1g Raman modes confirmed the effective reduction of flake thicknesses from the bulk MoS2 to the dispersions. Ultrafast nonlinear optical (NLO) properties were investigated using an open-aperture Z-scan technique. All experiments were performed using 100 fs pulses at 800 nm from a mode-locked Ti:sapphire laser. The MoS2 nanosheets exhibited significant saturable absorption (SA) for the femtosecond pulses, resulting in the third-order NLO susceptibility Imχ((3)) ~ 10(-15) esu, figure of merit ~10(-15) esu cm, and free-carrier absorption cross section ~10(-17) cm(2). Induced free carrier density and the relaxation time were estimated to be ~10(16) cm(-3) and ~30 fs, respectively. At the same excitation condition, the MoS2 dispersions show better SA response than the graphene dispersions.

Broadband ultrafast nonlinear absorption and nonlinear refraction of layered molybdenum dichalcogenide semiconductors

A series of layered molybdenum dichalcogenides, i.e., MoX₂ (X = S, Se and Te), were prepared in cyclohexyl pyrrolidinone by a liquid-phase exfoliation technique. The high quality of the two-dimensional nanostructures was verified by transmission electron microscopy and absorption spectroscopy. Open- and closed-aperture Z-scans were employed to study the nonlinear absorption and nonlinear refraction of the MoX₂ dispersions, respectively. All the three-layered nanostructures exhibit prominent ultrafast saturable absorption (SA) for both femtosecond (fs) and picosecond (ps) laser pulses over a broad wavelength range from the visible to the near infrared. While the dispersions treated with low-speed centrifugation (1500 rpm) have an SA response, and the MoS₂ and MoSe₂ dispersions after higher speed centrifugation (10,000 rpm) possess two-photon absorption for fs pulses at 1030 nm, which is due to the significant reduction of the average thickness of the nanosheets; hence, the broadening of band gap. In addition, all dispersions show obvious nonlinear self-defocusing for ps pulses at both 1064 nm and 532 nm, resulting from the thermally-induced nonlinear refractive index. The versatile ultrafast nonlinear properties imply a huge potential of the layered MoX2 semiconductors in the development of nanophotonic devices, such as mode-lockers, optical limiters, optical switches, etc.

Optical Limiting and Theoretical Modelling of Layered Transition Metal Dichalcogenide Nanosheets.

Nonlinear optical property of transition metal dichalcogenide (TMDC) nanosheet dispersions, including MoS2, MoSe2, WS2, and WSe2, was performed by using Z-scan technique with ns pulsed laser at 1064 nm and 532 nm. The results demonstrate that the TMDC dispersions exhibit significant optical limiting response at 1064 nm due to nonlinear scattering, in contrast to the combined effect of both saturable absorption and nonlinear scattering at 532 nm. Selenium compounds show better optical limiting performance than that of the sulfides in the near infrared. A liquid dispersion system based theoretical modelling is proposed to estimate the number density of the nanosheet dispersions, the relationship between incident laser fluence and the size of the laser generated micro-bubbles, and hence the Mie scattering-induced broadband optical limiting behavior in the TMDC dispersions.

Saturable absorption behavior of free-standing graphene polymer composite films over broad wavelength and time ranges

A comparative research on saturable absorption (SA) behavior dependence on wavelength and pulse duration was performed for graphene polymer composites. Free-standing graphene-polyvinyl alcohol (PVA) composite films were fabricated by using solution cast method in combination of liquid phase exfoliation. SA responses were observed by using an open-aperture Z-scan technique for 340 fs pulses at 1030 nm and 515 nm from a mode-locked fiber laser, and 6 ns pulses at 1064 nm and 532 nm from a Q-switched Nd:YAG laser. The graphene films possess better SA property, i.e., larger SA coefficient and figure of merit (FOM), and lower saturation intensity I(s), for ns pulses than that for fs pulses at the similar near infrared (NIR) wavelength. For fs pulses, the films show better SA response at 1030 nm than that at 515 nm. By employing slow and fast SA modelling, the excited state and ground state absorption cross sections were estimated to be ~10(-17) cm(2), and the ratio was ~0.6 at NIR for both fs and ns pulses.

Host matrix effect on the near infrared saturation performance of graphene absorbers

A comparative research on the near infrared performance of three kinds of widely used graphene saturable absorbers, namely, graphene polymer composite films, neat graphene films and graphene dispersions, was performed by using Z-scan technique with 340 fs pulses at 1030 nm. The polymer films and graphene films were fabricated through solution cast method and vacuum filtration technique based on the liquid-phase exfoliated graphene dispersions, respectively. The polymer films reveal the best saturable absorption (SA) response and the lowest saturation intensity Is, in comparison with the neat films and dispersions. The graphene films show the largest SA coefficient and figure of merit due to its highest linear absorption coefficient and refractive index. By employing slow SA modeling, the excited state and ground state absorption cross sections were estimated to be ~10−17 cm2, and the ratio were 0.61, 0.57 and 0.71 for the dispersions, polymer films and neat films, respectively.