Yikai Zhou

Highly selective and sensitive determination of dopamine by the novel molecularly imprinted poly(nicotinamide)/CuO nanoparticles modified electrode.

A novel electrochemical sensor was proposed for the determination of dopamine (DA) based on the molecularly imprinted electropolymers (MIPs)/copper oxide (CuO) nanoparticles modified electrode. MIPs were firstly prepared by using nicotinamide as an environment-friendly monomer to selectively recognize the template molecules. CuO nanoparticles were used to enhance the number of imprinted sites per unit surface area of the electrode and then improve the selectivity and sensitivity of the electrochemical sensor. Thus, the obtained electrochemical sensor could effectively minimize the interferences caused by ascorbic acid (AA), uric acid (UA) and sample matrix. The linear range for the detection of DA was changed from 0.02 μmol L(-1) to 25 μmol L(-1) with the detection limit of 8 nmol L(-1) (S/N=3), which was lower than those of the reported MIPs-based sensor. Finally, the proposed method was applied to measure dopamine in serum samples. The spiked recoveries were changed from 96.9% to 105.9% and the RSD was not higher than 8.8%. It was shown that the proposed sensor exhibited significant promise as a reliable technique for the detection of DA in human serum samples.

Rapid and selective extraction of multiple macrolide antibiotics in foodstuff samples based on magnetic molecularly imprinted polymers

Magnetic molecularly imprinted polymers (MMIPs) were prepared based on surface molecular imprinting using erythromycin (ERY) as template molecule and Fe3O4 nanoparticles as support substrate. The MMIPs possessed high adsorption capacity of 94.1 mg/g for ERY and the imprinting factor was 11.9 indicating good imprinted effect for ERY. Selective evaluation demonstrated favorable selectivity of MMIPs for multiple macrolide antibiotics (MACs). Using MMIPs as adsorptive material, a rapid and convenient magnetic solid-phase extraction (MSPE) procedure was established for simultaneous and selective separation of six MACs in pork, fish and shrimp samples, then the MACs was subjected to high-performance liquid chromatography-ultraviolet (HPLC-UV) analysis. At different fortified concentrations, the extraction recoveries could reach 89.1% and the relative standard deviations were lower than 12.4%. Chromatogram revealed the response signals of MACs in spiked samples were greatly enhanced and matrix interferences were effectively eliminated after treatment with MSPE. The proposed MSPE procedure coupled with HPLC-UV realized selective and sensitive determination of multiple MACs in foodstuff samples.

Rapid and selective determination of urinary lysozyme based on magnetic molecularly imprinted polymers extraction followed by chemiluminescence detection.

A rapid, low cost and selective chemiluminescence method coupled with magnetic molecularly imprinted polymers extraction was developed to detect lysozyme in human urine samples. Compared with traditional solid-phase extraction, this method could achieve selective extraction for the lysozyme, avoid the time consuming elution from a column or centrifugation steps, and then showed great potential in the high-throughput screening of clinical samples. The parameters affecting the performance of extraction and chemiluminescence were investigated. Under optimal conditions, the whole analytical procedure was completed within 12 min and spiked recovery ranged from 90.1% to 103.7% (R.S.D.≤6.7%). The limit of quantitation was 5 ng mL(-1). Furthermore, the results obtained by the proposed method were linearly correlated to those by commercial lysozyme detection kit (r=0.9595). Finally, the validated method was used to measure the urinary lysozyme of renal disease patients and healthy controls. The results confirmed the reliability and practicality of the protocol and revealed a good perspective of this method for biological sample analysis.

Electrochemical sensing chemical oxygen demand based on the catalytic activity of cobalt oxide film

Cobalt oxide sensing film was in situ prepared on glassy carbon electrode surface via constant potential oxidation. Controlling at 0.8 V in NaOH solution, the high-valence cobalt catalytically oxidized the reduced compounds, decreasing its surface amount and current signal. The current decline was used as the response signal of chemical oxygen demand (COD) because COD represents the summation of reduced compounds in water. The surface morphology and electrocatalytic activity of cobalt oxide were readily tuned by variation of deposition potential, time, medium and Co(2+) concentration. As confirmed from the atomic force microscopy measurements, the cobalt oxide film, that prepared at 1.3 V for 40 s in pH 4.6 acetate buffer containing 10 mM Co(NO(3))(2), possesses large surface roughness and numerous three-dimensional structures. Electrochemical tests indicated that the prepared cobalt oxide exhibited high electrocatalytic activity to the reduced compounds, accompanied with strong COD signal enhancement. As a result, a novel electrochemical sensor with high sensitivity, rapid response and operational simplicity was developed for COD. The detection limit was as low as 1.1 mg L(-1). The analytical application was studied using a large number of lake water samples, and the accuracy was tested by standard method.

A simple and sensitive immunoassay for the determination of human chorionic gonadotropin by graphene-based chemiluminescence resonance energy transfer

In this study, we report a strategy of chemiluminescence resonance energy transfer (CRET) using graphene as an efficient long-range energy acceptor. Magnetic nanoparticles were also used in CRET for simple magnetic separation and immobilization of horseradish peroxidase (HRP)-labeled anti-HCG antibody. In the design of CRET system, the sandwich-type immunocomplex was formed between human chorionic gonadotropin (HCG, antigen) and two different antibodies bridged the magnetic nanoparticles and graphene (acceptors), which led to the occurrence of CRET from chemiluminescence light source to graphene. After optimizing the experimental conditions, the quenching of chemiluminescence signal depended linearly on the concentration of HCG in the range of 0.1 mIU mL(-1)-10 mIU mL(-1) and the detection limit was 0.06 mIU mL(-1). The proposed method was successfully applied for the determination of HCG levels in saliva and serum samples, and the results were in good agreement with the plate ELISA with colorimetric detection. It could also be developed for detection of other antigen-antibody immune complexes by using the corresponding antigens and respective antibodies.

δ-Aminolevulinic acid dehydratase activity, urinary δ-aminolevulinic acid concentration and zinc protoporphyrin level among people with low level of lead exposure

To evaluate the relationship of delta-aminolevulinic acid dehydratase (ALAD) activity, urinary delta-aminolevulinic acid (ALAU) level and blood zinc protoporphyrin (ZPP) concentration to low blood lead (PbB) levels, these biomarkers were determined for all subjects enrolled from a rural area of southeast China where people had low levels of exposure to lead. The mean values of PbB, ALAD, ALAU and ZPP were 67.11 microg/L (SD: 1.654, range: 10.90-514.04), 339.66 nmol ml(-1)h(-1) (1.419, 78.33-793.13), 20.64 microg/L (1.603, 2.00-326.00), and 0.14 micromol/L (3.437, 0.01-2.26), respectively. ALAD was inversely associated with low levels of PbB. ZPP was inversely related to low levels of PbB but positively related to relatively higher levels of PbB. Alcohol drinking contributed to low ALAD in men. Women had higher ZPP than men. ALAU had no significant association with PbB. In conclusion, ALAD possibly has a non-linear relation with low to moderate levels of PbB. At moderate levels of PbB, ZPP increases with increasing levels of PbB. ALAU is not suitable as an indicator for low levels of lead exposure.

Analysis of phthalate esters in soils near an electronics manufacturing facility and from a non-industrialized area by gas purge microsyringe extraction and gas chromatography

Here, a novel technique is described for the extraction and quantitative determination of six phthalate esters (PAEs) from soils by gas purge microsyringe extraction and gas chromatography. Recovery of PAEs ranged from 81.4% to 120.3%, and the relative standard deviation (n=6) ranged from 5.3% to 10.5%. Soil samples were collected from roadsides, farmlands, residential areas, and non-cultivated areas in a non-industrialized region, and from the same land-use types within 1 km of an electronics manufacturing facility (n=142). Total PAEs varied from 2.21 to 157.62 mg kg(-1) in non-industrialized areas and from 8.63 to 171.64 mg kg(-1) in the electronics manufacturing area. PAE concentrations in the non-industrialized area were highest in farmland, followed (in decreasing order) by roadsides, residential areas, and non-cultivated soil. In the electronics manufacturing area, PAE concentrations were highest in roadside soils, followed by residential areas, farmland, and non-cultivated soils. Concentrations of dimethyl phthalate (DMP), diethyl phthalate (DEP), and di-n-butyl phthalate (DnBP) differed significantly (P<0.01) between the industrial and non-industrialized areas. Principal component analysis indicated that the strongest explanatory factor was related to DMP and DnBP in non-industrialized soils and to butyl benzyl phthalate (BBP) and DMP in soils near the electronics manufacturing facility. Congener-specific analysis confirmed that diethylhexyl phthalate (DEHP) was a predictive indication both in the non-industrialized area (r(2)=0.944, P<0.01) and the industrialized area (r(2)=0.860, P<0.01). The higher PAE contents in soils near the electronics manufacturing facility are of concern, considering the large quantities of electronic wastes generated with ongoing industrialization.

Selective Solid-Phase Extraction of Lead Ions in Water Samples Using Three-Dimensional Ion-Imprinted Polymers

Ion-imprinted polymers (IIPs) have drawn much attention in the selective determination of heavy metals. In this study, 8-hydroxyquinoline-grafted gelatin with different types of functional groups was first introduced as a biomolecular monomer to enhance the selectivity of imprinted cavities. Based on its swelling and film-forming properties, a simple strategy containing formation of the hydrogel film, swelling/folding followed by cross-linking, was proposed to prepare three-dimensional IIPs with high adsorption capacity (235.7 mg g(-1)), strong selectivity (imprinted factor was 2.9), and rapid kinetics. Based on the different swelling container, different morphologies of IIPs could be prepared to satisfy the requirements of practical application. Consequently, the IIPs extraction coupled with a spectrophotometric method was applied for determination of lead ions, and the limit of detection was 0.2 ng mL(-1), which could be used for monitoring of Pb(II) in drinking water and surface water.

Application of IEUBK model in lead risk assessment of children aged 61-84 months old in central China.

Few studies have focused on the accuracy of using the Integrated Exposure Uptake Biokinetic (IEUBK) model in Chinese children with site- and age-specific exposure data. This study aimed to validate the accuracy and sensitivity of the IEUBK model in lead risk assessment of Chinese children aged 61-84 months old. A total of 760 children were enrolled from two respective counties in Central China by using random cluster sampling method. Blood lead levels (BLLs) of all subjects were determined using graphite furnace atomic absorption spectrometry, as well as that in the environmental media, such as air, drinking water, soil, dust and food. Age- and site-specific time-activity patterns and water consumption were evaluated by using questionnaires for children. Exposure parameters including outdoor and indoor activity time, ventilation rate and water consumption in this study were different from the default values of the IEUBK model. Statistical analysis revealed no significant differences between the predicted and observed BLLs. Diet and soil/dust lead intake contributed approximately 83.39% (57.40%-93.84% range) and 15.18% (3.25%-41.60% range) of total lead intake, respectively. These findings showed that the IEUBK model is suitable for lead risk assessment of Chinese children aged 61-84 months old and diet acts as an important lead source.

Rapid determination of the chemical oxygen demand of water using a thermal biosensor.

In this paper we describe a thermal biosensor with a flow injection analysis system for the determination of the chemical oxygen demand (COD) of water samples. Glucose solutions of different concentrations and actual water samples were tested, and their COD values were determined by measuring the heat generated when the samples passed through a column containing periodic acid. The biosensor exhibited a large linear range (5 to 3000 mg/L) and a low detection limit (1.84 mg/L). It could tolerate the presence of chloride ions in concentrations of 0.015 M without requiring a masking agent. The sensor was successfully used for detecting the COD values of actual samples. The COD values of water samples from various sources were correlated with those obtained by the standard dichromate method; the linear regression coefficient was found to be 0.996. The sensor is environmentally friendly, economical, and highly stable, and exhibits good reproducibility and accuracy. In addition, its response time is short, and there is no danger of hazardous emissions or external contamination. Finally, the samples to be tested do not have to be pretreated. These results suggest that the biosensor is suitable for the continuous monitoring of the COD values of actual wastewater samples.