Yoshinori Sasai

Performance of the SciBar cosmic ray telescope (SciCRT) toward the detection of high-energy solar neutrons in solar cycle 24

We plan to observe solar neutrons at Mt. Sierra Negra (4,600 m above sea level) in Mexico using the SciBar detector. This project is named the SciBar Cosmic Ray Telescope (SciCRT). The main aims of the SciCRT project are to observe solar neutrons to study the mechanism of ion acceleration on the surface of the sun and to monitor the anisotropy of galactic cosmic-ray muons. The SciBar detector, a fully active tracker, is composed of 14,848 scintillator bars, whose dimension is 300 cm × 2.5 cm × 1.3 cm. The structure of the detector enables us to obtain the particle trajectory and its total deposited energy. This information is useful for the energy reconstruction of primary neutrons and particle identification. The total volume of the detector is 3.0 m × 3.0 m × 1.7 m. Since this volume is much larger than the solar neutron telescope (SNT) in Mexico, the detection efficiency of the SciCRT for neutrons is highly enhanced. We performed the calibration of the SciCRT at Instituto Nacional de Astrofisica, Optica y Electronica (INAOE) located at 2,150 m above sea level in Mexico in 2012. We installed the SciCRT at Mt. Sierra Negra in April 2013 and calibrated this detector in May and August 2013. We started continuous observation in March 2014. In this paper, we report the detector performance as a solar neutron telescope and the current status of the SciCRT.

Development of faster front end electronics for the SciCRT detector at Sierra Negra, Mexico

The SciBar Cosmic ray telescope (SciCRT) is installed on the top of the Sierra Negra volcano with the main goal of observing solar neutrons to investigate the ion acceleration process during solar flares. Using scintillator bars as a medium to stop energetic particles, the SciCRT is capable of recording both energy deposited on the bars and direction of the incoming particles with high resolution. The original DAQ system was used in neutrino oscillation experiment (low event rate), therefore operation of the electronics on cosmic ray experiment is limited. To improve the SciCRT performance as a solar neutron telescope, development of custom made DAQ electronics is essential. Our first step onto this task was the design and construction of a new fast readout back-end board using SiTCP. The installation of this new system on Sierra Negra and its further improvement on the data acquisition for the detector will be analyzed on separate paper on this conference. The development of new front end electronics is the next stage of the upgrading process. To achieve this goal, we are developing new electronics applying the time over threshold (ToT) technique, using a FPGA to process the signal from one 64 channel multi anode photomutiplier tube (MAPMT). In this paper we will present the details of this new system and several tests performed to guarantee its proper operation to detect solar neutrons.

Sensitivity of the SciBar Cosmic Ray Telescope (SciCRT) to solar neutrons

The SciBar Cosmic Ray Telescope (SciCRT) is aimed to help elucidate the acceleration mechanism of high-energy ions that may produce neutrons at the Sun. It is a fully active scintillator tracker which consists of 14,848 plastic scintillator bars, originally constructed for accelerator neutrino oscillation experiments. The SciCRT; it has a huge detector volume compared with conventional Solar Neutron Telescopes (SNTs), e.g. 15 times larger than Mexico SNT. Furthermore, the SciCRT can measure the energy deposition of each particle as neutron ADC data which have not been registered before. Neutron ADC data provide us with a precise measurement of energies deposited at the detector. The SciCRT was deployed at the summit of Mt. Sierra Negra (4,600 m) and began to acquire data in September 2013. Then we partially upgraded the DAQ system developed originally for an accelerator experiment, as the readout rate of the DAQ system was significantly limited for our experiment. This paper highlights sensitivity numerical studies of solar neutrons that the SciCRT is able to register. At first, we focus in the accuracy to determine the spectrum power-law index, assuming an instantaneous emission of solar neutrons. This is required to determine the power-law index within an error of ±1.0 in order to discuss the efficiency of the acceleration. Then in the case of the fixed power-law index, we discuss the capability of discriminating three different lengths of emission times: 0 min, 5 min, and 8 min. Finally we evaluate whether it is possible to discriminate a different combination of these two parameters simultaneously. Thus, we show that data from the SciCRT will unlock the degeneracy problem amid the emission time and the energy spectrum of solar neutrons.

Current status of SciCRT experiment and its expected future performance

Solar neutron telescopes (SNT) were designed and installed on high mountains to study particle acceleration mechanisms in solar surface. Of these, SciBar cosmic ray telescope (SciCRT) is a brand new telescope installed on the top of the Sierra Negra volcano in eastern Mexico (

Development of a pattern recognition algorithm for particle identification on the SciCRT in the Sierra Negra Volcano Summit

19^{\circ}

Upgrade of a data acquisition system for SciBar Cosmic Ray Telescope (SciCRT) at Mt. Sierra Negra, Mexico

N,

First cosmic-ray measurements by the SciCRT solar neutron experiment in Mexico

97.3^{\circ}

A faster and more reliable data acquisition system for the full performance of the SciCRT

W) composed of roughly 15000 scintillator bars, capable of detecting solar particles with both high efficiency and energy resolution. SciCRT is also useful to study the anisotropy of galactic cosmic ray muons. The implementation of SciCRT as a cosmic ray telescope began on September 2013, with

Observation of cosmic ray hadrons at the top of the Sierra Negra volcano in Mexico with the SciCRT prototype

5/8

Observation of Cosmic Ray at the top of the Sierra Negra volcano in Mexico with the SciCRT prototype

of the complete detector operative. After that, further improvement of the operating conditions on the place were made in order to maintain a stable data acquisition on the severe atmospheric conditions on high mountain (4600 m). In July 2015 we partially upgrade the DAQ system, installing a