Yoshio Aikawa

Promising System for Selecting Healthy In Vitro –Fertilized Embryos in Cattle

Conventionally, in vitro–fertilized (IVF) bovine embryos are morphologically evaluated at the time of embryo transfer to select those that are likely to establish a pregnancy. This method is, however, subjective and results in unreliable selection. Here we describe a novel selection system for IVF bovine blastocysts for transfer that traces the development of individual embryos with time-lapse cinematography in our developed microwell culture dish and analyzes embryonic metabolism. The system can noninvasively identify prognostic factors that reflect not only blastocyst qualities detected with histological, cytogenetic, and molecular analysis but also viability after transfer. By assessing a combination of identified prognostic factors—(i) timing of the first cleavage; (ii) number of blastomeres at the end of the first cleavage; (iii) presence or absence of multiple fragments at the end of the first cleavage; (iv) number of blastomeres at the onset of lag-phase, which results in temporary developmental arrest during the fourth or fifth cell cycle; and (v) oxygen consumption at the blastocyst stage—pregnancy success could be accurately predicted (78.9%). The conventional method or individual prognostic factors could not accurately predict pregnancy. No newborn calves showed neonatal overgrowth or death. Our results demonstrate that these five predictors and our system could provide objective and reliable selection of healthy IVF bovine embryos.

Time-Lapse Cinematography-Compatible Polystyrene-Based Microwell Culture System: A Novel Tool for Tracking the Development of Individual Bovine Embryos

We have developed a polystyrene-based well-of-the-well (WOW) system using injection molding to track individual embryos throughout culture using time-lapse cinematography (TLC). WOW culture of bovine embryos following in vitro fertilization was compared with conventional droplet culture (control). No differences between control- and WOW-cultured embryos were observed during development to the blastocyst stage. Morphological quality and inner cell mass (ICM) and trophectoderm (TE) cell numbers were not different between control- and WOW-derived blastocysts; however, apoptosis in both the ICM and TE cells was reduced in WOW culture (P < 0.01). Oxygen consumption in WOW-derived blastocysts was closer to physiological level than that of control-derived blastocysts. Moreover, WOW culture improved embryo viability, as indicated by increased pregnancy rates at Days 30 and 60 after embryo transfer (P < 0.05). TLC monitoring was performed to evaluate the cleavage pattern and the duration of the first cell cycle of embryos from oocytes collected by ovum pickup; correlations with success of pregnancy were determined. Logistic regression analysis indicated that the cleavage pattern correlated with success of pregnancy (P < 0.05), but cell cycle length did not. Higher pregnancy rates (66.7%) were observed for animals in which transferred blastocysts had undergone normal cleavage, identified by the presence of two blastomeres of the same size without fragmentation, than among those with abnormal cleavage (33.3%). These results suggest that our microwell culture system is a powerful tool for producing and selecting healthy embryos and for identifying viability biomarkers.

Culture of bovine embryos in polyester mesh sections: the effect of pore size and oxygen tension on in vitro development.

The purpose of this study was to assess the feasibility of polyester mesh culture for the in vitro production of bovine embryos, as polyester mesh is an alternative way for tracking individual embryos throughout culture using time-lapse cinematography (TLC). Bovine embryos were isolated during in vitro culture using sections of three different polyethylene terephthalate (PET) mesh products. In vitro matured and fertilized bovine oocytes were cultured in the 217u2003×u2003217, 230u2003×u2003230 or 238u2003×u2003238-μm openings of PET mesh sections or in simple micro-drops (control) for 7u2003days under either 20% or 5% O(2) tensions. No difference in embryo developmental rates was found between the culture groups in terms of cleavage, blastocyst formation and blastocyst expansion irrespective of O(2) tension. In contrast, under 20% O(2) tension, blastocysts that developed in PET mesh with 217u2003×u2003217-μm opening had significantly higher numbers of total and trophectoderm (TE) cells than control embryos; however, the numbers and proportions of inner cell mass (ICM) cells did not differ. Under 5% O(2) tension, no difference was found among the culture groups in the numbers of total, ICM and TE cells in embryos. All three PET mesh products investigated in this study were proven to be effective to prevent embryo movement. The results demonstrate that bovine embryos can be cultured in PET mesh sections without negative side-effects and suggest that embryo distance determined by the mesh affects embryo quality at atmospheric oxygen tension. Polyethylene terephthalate mesh with 217u2003×u2003217-μm openings was found to be the most suitable for further application in TLC.

Follicular growth-stimulated cows provide favorable oocytes for producing cloned embryos.

We examined the influence of recipient oocytes on in vitro development, oxygen consumption, and gene expression in the resulting cloned bovine embryos. Oocytes derived from slaughterhouse ovaries and ovum pickup (OPU)-derived oocytes were used as recipient cytoplasts for the production of cloned embryos. A series of OPU sessions was conducted on Holstein cows without follicular growth treatment (FGT). In the same cows, we then performed dominant follicle ablation and subsequently administered follicle-stimulating hormone and prostaglandin F(2α) with controlled internal drug release device before a second series of OPU. Cumulus cells collected from single Holstein cows were used as donor cells. After measurement of oxygen consumption at the blastocyst stage with modified scanning electrochemical microscopy, analysis of 10 genes (CDX2, IFN-tau, PLAC8, OCT4, SOX2, NANOG, ATP5A1, GLUT1, AKR1B1, and IGF2R) was performed with real-time RT-PCR. Rates of fusion, cleavage, and blastocyst formation were not different among the treatment groups. Levels of oxygen consumption in cloned blastocysts derived from slaughterhouse ovaries or OPU without FGT were significantly lower than in blastocysts derived from artificial insemination (AI). However, oxygen consumption was increased in cloned blastocysts derived from OPU with FGT, depending on the individual oocyte donor. Furthermore, gene expression of IFN-tau and OCT4 in cloned blastocysts derived from OPU with FGT was similar to that in AI-derived blastocysts, whereas expression of those genes in cloned blastocysts derived from slaughterhouse ovaries or OPU without FGT was significantly different from that in AI-derived blastocysts. Thus, recipient oocytes collected by OPU in combination with manipulation of follicular growth in donor cows are suitable for producing cloned embryos.

Development of bovine embryos cultured in CR1aa and IVD101 media using different oxygen tensions and culture systems

The aim of the present study was to optimise the culture conditions for the in vitro production of bovine embryos. The development of in vitro fertilised bovine oocytes in CR1aa supplemented with 5% calf serum and IVD101 culture media were compared using traditional microdrops and Well of the Well (WOW) culture systems either under 5% or 20% oxygen tension. After 7 days of culture, a significantly higher blastocyst formation rate was obtained for embryos cultured in CR1aa medium compared to those cultured in IVD101, irrespective of O2 tensions and culture systems. The blastocyst formation in IVD101 was suppressed under 20% O2 compared to 5% O2 . Despite their similar total cell numbers, higher rates of inner cell mass (ICM) cells were observed in blastocysts developed in IVD101 medium than in those developed in CR1aa, irrespective of O2 tensions. There was no significant difference in blastocyst formation, total, ICM and trophectoderm (TE) cell numbers between embryos obtained by microdrop and WOW culture systems irrespective of the culture media and O2 tensions used. In conclusion, CR1aa resulted in higher blastocyst formation rates irrespective of O2 tension, whereas IVD101 supported blastocyst formation only under low O2 levels but enhanced the proliferation of ICM cells.

Optimizing production of in vivo-matured oocytes from superstimulated Holstein cows for in vitro production of embryos using X-sorted sperm

The present study aimed to establish an efficient system for the production of female embryos from dairy cows by in vitro fertilization (IVF) using X-sorted sperm and in vivo-matured oocytes collected by ovum pick up (OPU). Nonlactating Holstein cows (n = 36) were administered a controlled intravaginal progesterone-releasing (controlled internal drug release) device (d 0), underwent dominant follicle ablation (DFA) or ovulation by administration of 100 μg of GnRH on d 5, and were superstimulated with FSH and PGF2α, following standard procedures. Controlled internal drug release devices were removed on the evening of d 8 or on the morning of d 9, depending on the experiment. For LH surge induction, 200 μg of GnRH was administered on the morning of d 10 (0 h). In experiment 1, the peak (48.1%) of ovulating follicles was detected at 29 to 32 h after GnRH injection (0 h), and the range in the timing of the initiation of ovulation was less by timing from GnRH administration (30.0 ± 2.8h) rather than by timing the onset of estrus (32.7 ± 4.7h). Only 0.9% of total ovulated follicles were recorded before 26 h after GnRH injection. Therefore, OPU was carried out at 26 h and IVF occurred at 30 h after GnRH in experiments 2 and 3. In experiment 2, 83.3 ± 10.8% of oocytes with expanded cumulus cells had extruded the first polar body at 30 h after GnRH injection. The aim of experiment 3 was to compare the effect of either DFA or GnRH-induced LH surge before superstimulation on the efficiency of embryo production by IVF following superstimulation. Progesterone concentrations from d 10 to 12 in the DFA group were lower than those in the GnRH group. A greater proportion of recovered oocytes with expanded cumulus cells from ≥ 8-mm follicles was observed in the DFA group than in the GnRH group (95.9 and 77.4%, respectively). Blastocyst rates in the DFA and GnRH groups (58.0 and 52.8%, respectively) did not differ from those of oocytes collected from nonstimulated OPU and matured in vitro (49.9%). However, the proportion of high-quality blastocysts was higher in the DFA group compared with the GnRH group (54.9 vs. 21.5%). Our results demonstrate that high rates of good-quality blastocysts can be produced by IVF with X-sorted frozen sperm using in vivo-matured oocytes collected by OPU from cows after DFA and superstimulation combined with ovulation induction.

Comparison of Cryotop and micro volume air cooling methods for cryopreservation of bovine matured oocytes and blastocysts.

This study was designed to compare the efficiency of the Cryotop method and that of two methods that employ a micro volume air cooling (MVAC) device by analyzing the survival and development of bovine oocytes and blastocysts vitrified using each method. In experiment I, in vitro-matured (IVM) oocytes were vitrified using an MVAC device without direct contact with liquid nitrogen (LN2; MVAC group) or directly plunged into LN2 (MVAC in LN2 group). A third group of IVM oocytes was vitrified using a Cryotop device (Cryotop group). After warming, vitrified oocytes were fertilized in vitro. There were no significant differences in cleavage and blastocyst formation rates among the three vitrified groups, with the rates ranging from 53.1% to 56.6% and 20.0% to 25.5%, respectively; however, the rates were significantly lower (P < 0.05) than those of the fresh control group (89.3% and 43.3%, respectively) and the solution control group (87.3% and 42.0%, respectively). In experiment II, in vitro-produced (IVP) expanded blastocysts were vitrified using the MVAC, MVAC in LN2 and Cryotop methods, warmed and cultured for survival analysis and then compared with the solution control group. The rate of development of vitrified-warmed expanded blastocysts to the hatched blastocyst stage after 24 h of culture was lower in the MVAC in LN2 group than in the solution control group; however, after 48–72 h of culture, the rates did not significantly differ between the groups. These results indicate that the MVAC method without direct LN2 contact is as effective as the standard Cryotop method for vitrification of bovine IVM oocytes and IVP expanded blastocysts.