YoungHwa An

Effects of discharge chamber length on the negative ion generation in volume-produced negative hydrogen ion source

In a volume-produced negative hydrogen ion source, control of electron temperature is essential due to its close correlation with the generation of highly vibrationally excited hydrogen molecules in the heating region as well as the generation of negative hydrogen ions by dissociative attachment in the extraction region. In this study, geometric effects of the cylindrical discharge chamber on negative ion generation via electron temperature changes are investigated in two discharge chambers with different lengths of 7.5 cm and 11 cm. Measurements with a radio-frequency-compensated Langmuir probe show that the electron temperature in the heating region is significantly increased by reducing the length of the discharge chamber due to the reduced effective plasma size. A particle balance model which is modified to consider the effects of discharge chamber configuration on the plasma parameters explains the variation of the electron temperature with the chamber geometry and gas pressure quite well. Accordingly, H(-) ion density measurement with laser photo-detachment in the short chamber shows a few times increase compared to the longer one at the same heating power depending on gas pressure. However, the increase drops significantly as operating gas pressure decreases, indicating increased electron temperatures in the extraction region degrade dissociative attachment significantly especially in the low pressure regime. It is concluded that the increase of electron temperature by adjusting the discharge chamber geometry is efficient to increase H(-) ion production as long as low electron temperatures are maintained in the extraction region in volume-produced negative hydrogen ion sources.

Design of a dual sensor probe array for internal field measurement in Versatile Experiment Spherical Torusa)

A dual sensor probe array is designed and constructed for internal magnetic field measurement at Versatile Experiment Spherical Torus (VEST) at the Seoul National University. Simultaneous use of Hall sensors and chip inductors allows cross-calibration among the measurements and compensation for each others weaknesses while their small sizes are expected to cause only mild plasma perturbations. Calibration of the dual sensor probe array, using a Helmholtz coil, shows good sensitivity for the magnetic field measurement of the VEST. Prior to Ohmic start-up, the magnetic field structure inside the vacuum chamber is measured by using the calibrated probe array. The dual sensor probe array is expected to be useful in analyzing the temporal magnetic field structure change during the magnetic reconnection and in reconstruction of the current profile during the discharge of the VEST device.

Efficient ECH-assisted plasma start-up using trapped particle configuration in the versatile experiment spherical torus

An efficient and robust ECH (electron cyclotron heating)-assisted plasma start-up scheme with a low loop voltage and low volt-second consumption utilizing the trapped particle configuration (TPC) has been developed in the versatile experiment spherical torus (VEST). The TPC is a mirror-like magnetic field configuration providing a vertical magnetic field in the same direction as the equilibrium field. It significantly enhances ECH pre-ionization with enhanced particle confinement due to its mirror effect, and intrinsically provides an equilibrium field with a stable decay index enabling prompt plasma current initiation. Consequently, the formation of TPC before the onset of the loop voltage allows the plasma to start up with a lower loop voltage and lower volt-second consumption as well as a wider operation range in terms of ECH pre-ionization power and H2 filling pressure. The TPC can improve the widely-used field null configuration significantly for more efficient start-up when ECH pre-ionization is used. This can then be utilized in superconducting tokamaks requiring a low loop voltage start-up, such as ITER, or in spherical tori with limited volt-seconds. The TPC can be particularly useful in superconducting tokamaks with a limited current slew-rate of superconducting PF coils, as it can save volt-second consumption before plasma current initiation by providing prompt initiation with an intrinsic stable equilibrium field.

Efficient pre-ionization by direct X-B mode conversion in VEST

Pre-ionization experiments with pure toroidal field have been carried out in VEST (Versatile Experiment Spherical Torus) to investigate the feasibility of direct XB mode conversion from perpendicular LFS (Low Field Side) injection for efficient pre-ionization. Pre-ionization plasmas are studied by measuring the electron density and temperature profiles with respect to microwave power and toroidal field strength, and 2D full wave cold plasma simulation using the COMSOL Multiphysics is performed for the comparison. It is experimentally figured out that exceeding the threshold microwave power (>3 kW), the parametric decay and localized collisional heating is observed near the UHR (Upper Hybrid Resonance), and the efficient XB mode conversion can be achieved in both short density scale length (Ln) and magnetic scale length (LB) region positioned at outboard and inboard sides, respectively. From the 2D full wave simulations, the reflection and tunneling of X-wave near the R-cutoff layer according to the measur...

Development of a novel radio-frequency negative hydrogen ion source in conically converging configurationa)

Volume-produced negative ion source still requires enhancement of current density with lower input RF (radio-frequency) power in lower operating pressure for various applications. To confirm recent observation of efficient negative ion production with a short cylindrical chamber with smaller effective plasma size, the RF-driven transformer-coupled plasma H(-) ion source at Seoul National University is modified by adopting a newly designed quartz RF window to reduce the chamber length. Experiments with the reduced chamber length show a few times enhancement of H(-) ion beam current compared to that extracted from the previous chamber design, which is consistent with the measured H(-) ion population. Nevertheless, decrease in H(-) ion beam current observed in low pressure regime below ∼5 mTorr owing to insufficient filtering of high energy electrons in the extraction region needs to be resolved to address the usefulness of electron temperature control by the change of geometrical configuration of the discharge chamber. A new discharge chamber with conically converging configuration has been developed, in which the chamber diameter decreases as approaching to the extraction region away from the planar RF antenna such that stronger filter magnetic field can be utilized to prohibit high energy electrons from transporting to the extraction region. First experimental results for the H(-) ion beam extraction with this configuration show that higher magnetic filter field makes peak negative beam currents happen in lower operating pressure. However, overall decrease in H(-) ion beam current due to the change of chamber geometry still requires further study of geometrical effect on particle transport and optimization of magnetic field in this novel configuration.

Characterization of photo-multiplier tube as ex-vessel radiation detector in tokamak

Feasibility of using conventional photo-multiplier tubes (PMTs) without a scintillator as an ex-vessel radiation detector in a tokamak environment is studied. Basic irradiation tests using standard gamma ray sources and a d-d neutron generator showed that the PMT is responding both to gamma photons and neutrons, possibly due to the direct generation of secondary electrons inside the PMT by the impingement of high energy photons. Because of the selective sensitivity of the PMT to hard x-ray and neutrons in ohmic and neutral beam injected plasmas, respectively, it is shown that the PMT with certain configuration can be utilized either to monitor the fluctuation in the fusion neutron generation rate or to study the behavior of runaway electrons in tokamaks.

Design of interferometer system on Versatile Experiment Spherical Torus (VEST) at Seoul National University

A 94 GHz heterodyne interferometer system was designed to measure the plasma density of VEST (Versatile Experiment Spherical Torus), which was recently built at Seoul National University. Two 94 GHz Gunn oscillators with a frequency difference of 40 MHz were used in the microwave electronics part of a heterodyne interferometer system. A compact beam focusing system utilizing a pair of plano-convex lenses and a concave mirror was designed to maximize the effective beam reception and spatial resolution. Beam path analysis based on Gaussian optics was used in the design of the beam focusing system. The design of the beam focusing system and the beam path analysis were verified with a couple of experiments that were done within an experimental framework that considered the real dimensions of a vacuum vessel. Optimum distances between the optical components and the beam radii along the beam path obtained from the experiments were in good agreement with the beam path analysis using the Gaussian optics. Both experimentation and numerical calculations confirmed that the designed beam focusing system maximized the spatial resolution of the measurement; moreover, the beam waist was located at the center of the plasma to generate a phase shift more effectively in plasmas. The interferometer system presented in this paper is expected to be used in the measurements of line integrated plasma densities during the start-up phase of VEST.

VUV spectroscopy in impurity injection experiments at KSTAR using prototype ITER VUV spectrometer

The ITER vacuum ultra-violet (VUV) core survey spectrometer has been designed as a 5-channel spectral system so that the high spectral resolving power of 200-500 could be achieved in the wavelength range of 2.4-160 nm. To verify the design of the ITER VUV core survey spectrometer, a two-channel prototype spectrometer was developed. As a subsequent step of the prototype test, the prototype VUV spectrometer has been operated at KSTAR since the 2012 experimental campaign. From impurity injection experiments in the years 2015 and 2016, strong emission lines, such as Kr xxv 15.8 nm, Kr xxvi 17.9 nm, Ne vii 46.5 nm, Ne vi 40.2 nm, and an array of largely unresolved tungsten lines (14-32 nm) could be measured successfully, showing the typical photon number of 1013-1015 photons/cm2 s.

Observation of the loss of pre-disruptive runaway electrons in KSTAR ohmic plasma disruptions

A newly-developed fast neutron detector revealed a close relationship between the loss of pre-disruptive runaway electrons and the plasma disruption in KSTAR ohmic plasmas. It is observed that a burst of photoneutrons is generated exactly before the start of thermal quenches, indicating a bunch of runaway electrons which had existed before the disruption impacts the first wall at the time. The loss of runaway electrons could be identified also as a decrease in the measured electron temperature, forming a typical two-stage thermal quench trace. From the MHD pattern in the neutron signal during a low-q disruption, it could be identified that pre-disruptive runaway electrons are localized in the plasma, especially on the q = 2 drift surface. These new findings suggest the pre-disruptive runaway electrons might play an important role in the plasma disruption mechanism.