Yuhuan Liu

Microwave-assisted pyrolysis of microalgae for biofuel production

The pyrolysis of Chlorella sp. was carried out in a microwave oven with char as microwave reception enhancer. The results indicated that the maximum bio-oil yield of 28.6% was achieved under the microwave power of 750 W. The bio-oil properties were characterized with elemental, GC-MS, GPC, FTIR, and thermogravimetric analysis. The algal bio-oil had a density of 0.98 kg/L, a viscosity of 61.2 cSt, and a higher heating value (HHV) of 30.7 MJ/kg. The GC-MS results showed that the bio-oils were mainly composed of aliphatic hydrocarbons, aromatic hydrocarbons, phenols, long chain fatty acids and nitrogenated compounds, among which aliphatic and aromatic hydrocarbons (account for 22.18% of the total GC-MS spectrum area) are highly desirable compounds as those in crude oil, gasoline and diesel. The results in this study indicate that fast growing algae are a promising source of feedstock for advanced renewable fuel production via microwave-assisted pyrolysis (MAP).

A hetero-photoautotrophic two-stage cultivation process to improve wastewater nutrient removal and enhance algal lipid accumulation

A hetero-photoautotrophic algal growth model was studied for improved wastewater treatment and low cost algal biofuel feedstock production. The microalga, Auxenochlorella protothecoides UMN280, was grown heterotrophically on concentrated municipal wastewater and then autotrophically with CO(2) supplementation (air, 1% and 5%, respectively). Strain UMN280 was harvested by self-sedimentation after the heterotrophic stage and the supernatant was aerated with different levels of CO(2) to facilitate autotrophic growth in the second stage. The maximal biomass concentration and lipid content at the first and second stages reached 1.12g/L and 28.90%, and 1.16g/L and 33.22%, respectively. The nutrient removal efficiencies for total phosphorus, ammonia, nitrogen and chemical oxygen demand at the end of the two-stage cultivation were 98.48%, 100%, 90.60% and 79.10%, respectively. The above process can be used to treat organic-rich wastewaters (e.g. industrial and animal manure wastewaters) to achieve the dual purpose of low-cost wastewater treatment and biofuel feedstock production.

Physical and Chemical Properties of Bio-Oils From Microwave Pyrolysis of Corn Stover

This study was aimed to understand the physical and chemical properties of pyrolytic bio-oils produced from microwave pyrolysis of corn stover regarding their potential use as gas turbine and home heating fuels. The ash content, solids content, pH, heating value, minerals, elemental ratio, moisture content, and viscosity of the bio-oils were determined. The water content was approx 15.2 wt%, solids content 0.22 wt%, alkali metal content 12 parts per million, dynamic viscosity 185 mPa·s at 40°C, and gross high heating value 17.5 MJ/kg for a typical bio-oil produced. Our aging tests showed that the viscosity and water content increased and phase separation occurred during the storage at different temperatures. Adding methanol and/or ethanol to the bio-oils reduced the viscosity and slowed down the increase in viscosity and water content during the storage. Blending of methanol or ethanol with the bio-oils may be a simple and cost-effective approach to making the pyrolytic bio-oils into a stable gas turbine or home heating fuels.

Catalytic pyrolysis of microalgae and their three major components: Carbohydrates, proteins, and lipids

To better understand the pyrolysis of microalgae, the different roles of three major components (carbohydrates, proteins, and lipids) were investigated on a pyroprobe. Cellulose, egg whites, and canola oil were employed as the model compounds of the three components, respectively. Non-catalytic pyrolysis was used to identify and quantify some major products and several reaction pathways were proposed for the pyrolysis of each model compound. Catalytic pyrolysis was then carried out with HZSM-5 for the production of aromatic hydrocarbons at different temperatures and catalyst to feed ratios. The aromatic yields of all feedstocks were significantly improved when the catalyst to biomass ratio increased from 1:1 to 5:1. Egg whites had the lowest aromatic yield among the model compounds under all reaction conditions, which suggests that proteins can hardly be converted to aromatics with HZSM-5. Lipids, although only accounted for 12.33% of Chlorella, contributed about 40% of aromatic production from algal biomass.

Fast microwave assisted pyrolysis of biomass using microwave absorbent

A novel concept of fast microwave assisted pyrolysis (fMAP) in the presence of microwave absorbents was presented and examined. Wood sawdust and corn stover were pyrolyzed by means of microwave heating and silicon carbide (SiC) as microwave absorbent. The bio-oil was characterized, and the effects of temperature, feedstock loading, particle sizes, and vacuum degree were analyzed. For wood sawdust, a temperature of 480°C, 50 grit SiC, with 2g/min of biomass feeding, were the optimal conditions, with a maximum bio-oil yield of 65 wt.%. For corn stover, temperatures ranging from 490°C to 560°C, biomass particle sizes from 0.9mm to 1.9mm, and vacuum degree lower than 100mmHg obtained a maximum bio-oil yield of 64 wt.%. This study shows that the use of microwave absorbents for fMAP is feasible and a promising technology to improve the practical values and commercial application outlook of microwave based pyrolysis.

Hydrothermal pretreatment of microalgae for production of pyrolytic bio-oil with a low nitrogen content.

Microalgae can be converted to an energy-dense bio-oil via pyrolysis; however, the relatively high nitrogen content of this bio-oil presents a challenge for its direct use as fuels. Therefore, hydrothermal pretreatment was employed to reduce the N content in Nannochloropsis oculata feedstock by removing proteins without requiring significant energy inputs. The effects of reaction conditions on the yield and composition of pretreated algae were investigated by varying the temperature (150-225°C) and reaction time (10-60 min). Compared with untreated algae, pretreated samples had higher carbon contents and enhanced heating values under all reaction conditions and 6-42% lower N contents at 200-225°C for 30-60 min. The pyrolytic bio-oil from pretreated algae contained less N-containing compounds than that from untreated samples and the bio-oil contained mainly (44.9% GC-MS peak area) long-chain fatty acids (C14-C18) which can be more readily converted into hydrocarbon fuels in the presence of simple catalysts.

Cultivation of a microalga Chlorella vulgaris using recycled aqueous phase nutrients from hydrothermal carbonization process

This study investigated the feasibility of using recovered nutrients from hydrothermal carbonization (HTC) for cultivation of microalga Chlorella vulgaris. Different dilution multiples of 50, 100 and 200 were applied to the recycled process water from HTC and algal growth was compared among these media and a standard growth medium BG-11. Algae achieved a biomass concentration of 0.79 g/L on 50 × process water after 4 days. Algae removed total nitrogen, total phosphorus and chemical oxygen demand by 45.5-59.9%, 85.8-94.6% and 50.0-60.9%, respectively, on differently diluted process water. The fatty acid methyl ester yields for algae grown on the process water were 11.2% (50 ×), 11.2% (100 ×) and 9.7% (200 ×), which were significantly higher than 4.5% for BG-11. In addition, algae cultivated on process water had 18.9% higher carbon and 7.8% lower nitrogen contents than those on BG-11, indicating that they are very suitable as biofuel feedstocks.

Fast microwave-assisted catalytic pyrolysis of sewage sludge for bio-oil production.

In this study, fast microwave-assisted catalytic pyrolysis of sewage sludge was investigated for bio-oil production, with HZSM-5 as the catalyst. Pyrolysis temperature and catalyst to feed ratio were examined for their effects on bio-oil yield and composition. Experimental results showed that microwave is an effective heating method for sewage sludge pyrolysis. Temperature has great influence on the pyrolysis process. The maximum bio-oil yield and the lowest proportions of oxygen- and nitrogen-containing compounds in the bio-oil were obtained at 550°C. The oil yield decreased when catalyst was used, but the proportions of oxygen- and nitrogen-containing compounds were significantly reduced when the catalyst to feed ratio increased from 1:1 to 2:1. Essential mineral elements were concentrated in the bio-char after pyrolysis, which could be used as a soil amendment in place of fertilizer. Results of XRD analyses demonstrated that HZSM-5 catalyst exhibited good stability during the microwave-assisted pyrolysis of sewage sludge.

Production of aromatic hydrocarbons by catalytic pyrolysis of microalgae with zeolites: catalyst screening in a pyroprobe.

Catalytic pyrolysis of microalgae and egg whites was investigated to evaluate the performance of different zeolites for the production of aromatic hydrocarbons. Three zeolites with different structures (H-Y, H-Beta and H-ZSM5) were used to study the effect of catalyst type on the aromatic yield. All three catalysts significantly increased the aromatic yields from pyrolysis of microalgae and egg whites compared with non-catalytic runs, and H-ZSM5 was most effective with a yield of 18.13%. Three H-ZSM5 with silica-to-alumina ratios of 30, 80 and 280 were used to study the effect of Si/Al ratio on the aromatic yield. The maximum yield was achieved at the Si/Al ratio of 80, which provides moderate acidity to achieve high aromatic production and reduce coke formation simultaneously. Aromatic production increased with the incorporation of copper or gallium to HZSM-5. However, other studied metals either had no significant influence or led to a lower aromatic yield.

Effect of wastewater-borne bacteria on algal growth and nutrients removal in wastewater-based algae cultivation system.

Centrate, a type of nutrient-rich municipal wastewater was used to determine the effect of wastewater-borne bacteria on algal growth and nutrients removal efficiency in this study. The characteristics of algal and bacterial growth profiles, wastewater nutrient removal and effect of initial algal inoculums were systematically examined. The results showed that initial algal concentration had apparent effect on bacterial growth, and the presence of bacteria had a significant influence on algal growth pattern, suggesting symbiotic relationship between algae and bacteria at the initial stage of algae cultivation. The maximum algal biomass of 2.01 g/L with 0.1g/L initial algal inoculums concentration can be obtained during algae cultivation in raw centrate medium. The synergistic effect of centrate-borne bacteria and microalgae on algae growth and nutrient removal performance at initial fast growth stage has great potential to be applied to pilot-scale wastewater-based algae wastewater system cultivated in continuous or semi-continuous mode.