Yujin Kang

Development of heat storage gypsum board with paraffin-based mixed SSPCM for application to buildings

Abstract Latent heat thermal energy storage using phase change materials (PCMs) is considered to be the method with the most potential to solve the energy shortage problem. In this study, paraffin-based mixed shape-stabilized PCM (SSPCM) (PBMS) was made by vacuum impregnation method. The prepared PBMS was added to gypsum powder as a fine aggregate. In the experiment, the n-hexadecane and n-octadecane was used as the PCM and the materials have latent heat capacities of 254.7 and 247.6 J/g, and melting points of 20.84 and 30.4 °C, respectively. The PBMS was prepared by an impregnation method in a vacuum, following the manufacturing process. The physical and thermal properties of the PBMS gypsum board were analyzed by Fourier transform infrared spectrometry (FTIS), differential scanning calorimetry, enthalpy analysis, and thermogravimetric analysis. From the Fourier transform infrared analysis, PBMS could be maintained in the structure of the gypsum board due to its physical rather than chemical bonding. From the specific heat and enthalpy analysis, the PBMS has high enthalpy and thermal inertia property. In addition, the gypsum board with PBMS has high latent heat capacity and high thermal efficiency.

Analysis of Hygrothermal Performance of Wood Frame Walls according to Position of Insulation and Climate Conditions

The insulation of a building envelope influences the hygrothermal performance as well as the thermal performance of the building. While most of Korean wood frame houses have an interior insulation system, the exterior insulation system with high thermal performance has recently been applied. While it can be effective in energy savings for better insulation performance, without consideration of the moisture, condensation and mould growth can occur. Therefore, in this study, hygrothermal behaviour, water content, and mould growth were analyzed using hygrothermal simulation of an exterior wall of a wood frame house with which the interior insulation and exterior insulation systems were applied. The wall layer included Wall A (Interior insulation) and Wall B (Exterior insulation). The U-values were identified as 0.173 and 0.157 W/m2K, respectively. The total water content and OSB absolute water content of Wall A were confirmed to be higher than those of Wall B, but the absolute water content did not exceed the reference value of 20%. The moisture content of the two walls was determined to be stable in the selected areas. However, mould growth risk analysis confirmed that both Wall A and Wall B were at risk of mould growth. It was confirmed that as the indoor setting temperature decreased, the mould index and growth rate in the same area increased. Therefore, the mould growth risk was affected more by indoor and outdoor climate conditions than by the position of the insulation. Consequently, the thermal performance of Wall B was superior to that of Wall A but the hygrothermal performances were confirmed to be similar.

Heating and Cooling Energy Demand Evaluating of Standard Houses According to Layer Component of Masonry, Concrete and Wood Frame Using PHPP

건축물에서 냉방과 난방에 많은 양의 에너지가 소요되고 있다. 건축은 CO2 발생을 줄이고 에너지 소비 저감을 위하여 냉·난방 부하를 최소화할 필요성이 있다. 그리고 최근 주거문화는 친환경적이고 실내 쾌적성을 중시하는 방향으로 변화하면서 단독주택의 수요가 증가하고 있다. 국내 단독주택의 구조는 크게 조적조, 콘크리트조, 목조 주택으로 구분할 수 있다. 따라서 본 논문은 세 가지 구조방식(조적, 콘크리트, 목조)으로 구성된 동일 면적 단독주택의 냉·난방 부하와 에너지 요구량을 분석하였다. 구조방식별 벽체, 지붕, 바닥 레이어를 구성하였고, 각 레이어의 열관류율(U-value)은 목조벽체와 같이 스터드를 고려해주기 위하여 PHPP 계산법을 이용하였다. 또한 스터드 유무에 따른 차이를 비교 분석하기 위하여 목조 벽체에서 스터드를 고려하지 않은 경우(비 스터드)를 분석하였다. 분석은 엑셀을 기반으로 자체 개발한 냉·난방 부하 산출 프로그램(CHLC)과 ECO2를 이용하였다. 냉·난방 부하와 에너지 요구량 결과, 목조 구조가 가장 높은 결과를 보였고 콘크리트 구조는 두 번째로 높은 값을 유지하는 것을 확인하였다. 두 구조방식은 에너지소비 측면에서 불리하다고 판단하였다. 결론적으로, 동일한 조건에서의 조적 구조는 다른 구조방식에 비하여 냉·난방 부하 및 에너지요구량에 있어 유리하며, 목조 구조에서 스터드로 인한 열교를 제외한다면 에너지소비를 줄일 수 있다고 판단되었다.

Analysis of Hygrothermal Performance for Standard Wood-frame Structures in Korea

본 연구는 WUFI Pro 5.3을 이용하여 한국농어촌공사에서 제시하고 있는 농어촌 표준 목조주택 설계를 기준으로 목조 벽체의 hygrothermal 거동에 대한 평가를 실시하였다. 그 결과, 2010년도에 제시된 벽체보다 2014년도에 개선된 벽체의 Total Water Contents (TWC)가 더 낮게 나타난 것을 확인하였고, 3년간의 평가에서 T...