Zhidan Liu

Conversion efficiency and oil quality of low-lipid high-protein and high-lipid low-protein microalgae via hydrothermal liquefaction.

Hydrothermal liquefaction (HTL) is a promising technology for converting algae into biocrude oil. Here, HTL of a low-lipid high-protein microalgae (Nannochloropsis sp.) and a high-lipid low-protein microalgae (Chlorella sp.) was studied. An orthogonal design was applied to investigate the effects of reaction temperature (220-300°C), retention time (30-90 min), and total solid content (TS, 15-25%wt) of the feedstock. The highest biocrude yield for Nannochloropsis sp. was 55% at 260°C, 60 min and 25%wt, and for Chlorella sp. was 82.9% at 220°C, 90 min and 25%wt. The maximum higher heating values (HHV) of biocrude oil from both algae were ∼ 37 MJ/kg. GC-MS revealed a various distribution of chemical compounds in biocrude. In particular, the highest hydrocarbons content was 29.8% and 17.9% for Nannochloropsis and Chlorella sp., respectively. This study suggests that algae composition greatly influences oil yield and quality, but may not be in similar effects.

States and challenges for high-value biohythane production from waste biomass by dark fermentation technology.

Hythane (H2+CH4) has attracted growing attention due to its versatile advantages as, for instance vehicle fuel. Biohythane consisting of biohydrogen and biomethane via two-stage fermentation is a potential high-value solution for the valorization of waste biomass resources and probably an alternative to the fossil based hythane. However, the significance and application potential of biohythane have not yet been fully recognized. This review focuses on the progress of biohydrogen and subsequent biomethane fermentation in terms of substrate, microbial consortium, reactor configuration, as well as the H2/CH4 ratio from the perspective of the feasibility of biohythane production in the past ten years. The current paper also covers how controls of the microbial consortium and bioprocess, system integration influence the biohythane productivity. Challenges and perspectives on biohythane technology will finally be addressed. This review provides a state-of-the-art technological insight into biohythane production by two-stage dark fermentation from biomass.

Microbial fuel cell based biosensor for in situ monitoring of anaerobic digestion process.

A wall-jet microbial fuel cell (MFC) was developed for the monitoring of anaerobic digestion (AD). This biofilm based MFC biosensor had a character of being portable, short hydraulic retention time (HRT) for sample flow through and convenient for continuous operation. The MFC was installed in the recirculation loop of an upflow anaerobic fixed-bed (UAFB) reactor in bench-scale where pH of the fermentation broth and biogas flow were monitored in real time. External disturbances to the AD were added on purpose by changing feedstock concentration, as well as process configuration. MFC signals had good correlations with online measurements (i.e. pH, gas flow rate) and offline analysis (i.e. COD) over 6-month operation. These results suggest that the MFC signal can reflect the dynamic variation of AD and can potentially be a valuable tool for monitoring and control of bioprocess.

Effects of furan derivatives on biohydrogen fermentation from wet steam-exploded cornstalk and its microbial community

Understanding the role of furan derivatives, furfural (FUR) and 5-hydroxymethyl furfural (HMF), is important for biofuel production from lignocellulosic biomass. In this study, the effects of furan derivatives on hydrogen fermentation from wet steam-exploded cornstalk were investigated. The control experiments with only seed sludge indicated that HMF addition of up to 1g/L stimulated hydrogen production. Similar results were obtained using steam-exploded cornstalk as the feedstock. Hydrogen productivity was increased by up to 40% with the addition of HMF. In addition, over 90% of furan derivatives with an initial concentration below 1g/L were degraded. Pyosequencing showed that the addition of HMF and FUR resulted in different microbial communities. HMF led to a higher proportion of the genera Clostridium and Ruminococcaceae, supporting the increased hydrogen production. This study suggested that hydrogen fermentation could be a detoxifying step for steam-exploded cornstalk, and HMF and FUR exhibited different functions for hydrogen fermentation.

Hydrothermal liquefaction of harvested high-ash low-lipid algal biomass from Dianchi Lake: effects of operational parameters and relations of products.

Hydrothermal liquefaction (HTL) allows a direct conversion of algal biomass into biocrude oil, not only solving the environmental issues caused by the over-growing algae but also producing renewable energy. This study reports HTL of algae after separation from eutrophicated Dianchi Lake in China. Conversion efficiency was studied under different operational conditions via an orthogonal design, including holding temperature (HT) (260-340 °C), retention time (RT) (30-90 min) and total solid (TS) (10-20%). A highest biocrude oil yield (18.4%, dry ash-free basis, daf) was achieved at 300 °C, 60 min, and 20% (TS), due to the low contents of lipids (1.9%, daf) and proteins (24.8%, daf), and high contents of ash (41.6%, dry basis) and carbohydrates (71.8%, daf). Operational parameters significantly affected the biocrude yields, and chemical distribution of HTL products. The biocrude production also related to other HTL products, and involved chemical reactions, such as deoxygenation and/or denitrogenation.

A novel configuration of microbial fuel cell stack bridged internally through an extra cation exchange membrane.

This paper reports a novel configuration of stacked microbial fuel cells (MFCs) bridged internally through an extra cation exchange membrane (CEM). The MFC stack (MFCstack), assembled from two single MFCs (MFCsingle), resulted in double voltage output and half optimal external resistance. COD removal rate was increased from 32.4% to 54.5%. The performance improvement could be attributed to the smaller internal resistance and enhanced cations transfer. A result from a half cell study further confirmed the important role of the extra CEM. This study also demonstrated MFCs where the anode and cathode were sandwiched between two CEMs possessed significantly high power outputs

Recovery of reducing sugars and volatile fatty acids from cornstalk at different hydrothermal treatment severity

This study focused on the degradation of cornstalk and recovery of reducing sugars and volatile fatty acids (VFAs) at different hydrothermal treatment severity (HTS) (4.17-8.28, 190-320°C). The highest recovery of reducing sugars and VFAs reached 92.39% of aqueous products, equal to 34.79% based on dry biomass (HTS, 6.31). GC-MS and HPLC identified that the aqueous contained furfural (0.35-2.88 g/L) and 5-hydroxymethyl furfural (0-0.85 g/L) besides reducing sugars and VFAs. Hemicellulose and cellulose were completely degraded at a HTS of 5.70 and 7.60, respectively. SEM analysis showed that cornstalk was gradually changed from rigid and highly ordered fibrils to molten and grainy structure as HTS increased. FT-IR and TGA revealed the significant changes of organic groups for cornstalk before and after hydrothermal treatment at different HTS. Hydrothermal treatment might be promising for providing feedstocks suitable for biohythane production.

Effects of inoculation strategy and cultivation approach on the performance of microbial fuel cell using marine sediment as bio-matrix

Aims:  To investigate the effects of inoculation strategy and cultivation approach on the performance of microbial fuel cell (MFC).

Elemental migration and characterization of products during hydrothermal liquefaction of cornstalk

Biofuel production from lignocellulosic biomass through hydrothermal liquefaction (HTL) is a promising direction. This study characterized the products and investigated the elemental migration during the HTL of cornstalk at seven different operation temperatures (210-375°C). The biocrude oil yield significantly increased from 7.04% (210°C) to 23.32% (290°C) as the temperature increased, and decreased to 21.07% when further increased to 375°C. A carbon recovery of 11.03-38.69%, and a hydrogen recovery of 7.77-25.61% were achieved in the biocrude oil. Hydrogen (27.87-70.94%) and nitrogen (74.56-81.76%) were effectively recovered in the aqueous phase. GC-MS, HPLC, TGA and FT-IR analysis indicated that major organic compounds in the biocrude oil were interestingly similar between 210°C and 270°C. The identified compounds included hydrocarbons, esters and carboxylic acid. The calculative yields of biocrude, hydrogen, methane and biochar reached 7.04-23.32, 0.07-0.29, 7.12-12.08 and 3.01-22.42t/100t cornstalks, respectively.

Performance and microbial community of carbon nanotube fixed-bed microbial fuel cell continuously fed with hydrothermal liquefied cornstalk biomass

Hydrothermal liquefaction (HTL) is a green technology for biomass pretreatment with the omission of hazardous chemicals. This study reports a novel integration of HTL and carbon nanotubes (CNTs) fixed-bed microbial fuel cell (FBMFC) for continuous electricity generation from cornstalk biomass. Two FBMFCs in parallel achieved similar performance fed with cornstalk hydrolysate at different organic loading rates (OLRs) (0.82-8.16g/L/d). About 80% of Chemical oxygen demand (COD) and Total organic carbon (TOC) was removed from low-Biochemical oxygen demand (BOD)/COD (0.16) cornstalk hydrolysate at 8.16g/L/d, whereas a maximum power density (680mW/m(3)) was obtained at 2.41g/L/d, and a smallest internal resistance (Rin) (28Ω) at 3.01g/L/d. Illumina MiSeq sequencing reveals the diverse microbial structure induced by the complex composition of cornstalk hydrolysate. Distinguished from Proteobacteria, which a number of exoelectrogens belong to, the identified dominant genus Rhizobium in FBMFC was closely related to degradation of cellulosic biomass.