A. A. Fraeman

A Habitable Fluvio-Lacustrine Environment at Yellowknife Bay, Gale Crater, Mars

The Curiosity rover discovered fine-grained sedimentary rocks, which are inferred to represent an ancient lake and preserve evidence of an environment that would have been suited to support a martian biosphere founded on chemolithoautotrophy. This aqueous environment was characterized by neutral pH, low salinity, and variable redox states of both iron and sulfur species. Carbon, hydrogen, oxygen, sulfur, nitrogen, and phosphorus were measured directly as key biogenic elements; by inference, phosphorus is assumed to have been available. The environment probably had a minimum duration of hundreds to tens of thousands of years. These results highlight the biological viability of fluvial-lacustrine environments in the post-Noachian history of Mars.

Large wind ripples on Mars: A record of atmospheric evolution

Wind blowing over sand on Earth produces decimeter-wavelength ripples and hundred-meter– to kilometer-wavelength dunes: bedforms of two distinct size modes. Observations from the Mars Science Laboratory Curiosity rover and the Mars Reconnaissance Orbiter reveal that Mars hosts a third stable wind-driven bedform, with meter-scale wavelengths. These bedforms are spatially uniform in size and typically have asymmetric profiles with angle-of-repose lee slopes and sinuous crest lines, making them unlike terrestrial wind ripples. Rather, these structures resemble fluid-drag ripples, which on Earth include water-worked current ripples, but on Mars instead form by wind because of the higher kinematic viscosity of the low-density atmosphere. A reevaluation of the wind-deposited strata in the Burns formation (about 3.7 billion years old or younger) identifies potential wind-drag ripple stratification formed under a thin atmosphere.

A hematite-bearing layer in Gale Crater, Mars: Mapping and implications for past aqueous conditions

Oversampled Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) visible and near-infrared hyperspectral data over Mount Sharp in Gale Crater, Mars, were used to generate spatially sharpened maps of the location of red crystalline hematite within the uppermost stratum of an ∼6.5-km-long ridge on the mound’s northern flank. Finely layered strata underlie the ridge to the north and have dips consistent with the nearby Mount Sharp sedimentary sequence. Fe-Mg smectites are exposed in a valley to the south of the ridge. Emplacement of the hematite is hypothesized to result either from exposure of anoxic Fe^(2+)-rich groundwater to an oxidizing environment, leading to precipitation of hematite or its precursors, or from in-place weathering of precursor silicate materials under oxidizing conditions. These hypotheses and implications for habitability will be testable with in situ measurements by the Mars rover Curiosity when it reaches Mount Sharp.

Chemistry, mineralogy, and grain properties at Namib and High dunes, Bagnold dune field, Gale crater, Mars: A synthesis of Curiosity rover observations

Abstract The Mars Science Laboratory Curiosity rover performed coordinated measurements to examine the textures and compositions of aeolian sands in the active Bagnold dune field. The Bagnold sands are rounded to subrounded, very fine to medium sized (~45–500 μm) with ≥6 distinct grain colors. In contrast to sands examined by Curiosity in a dust‐covered, inactive bedform called Rocknest and soils at other landing sites, Bagnold sands are darker, less red, better sorted, have fewer silt‐sized or smaller grains, and show no evidence for cohesion. Nevertheless, Bagnold mineralogy and Rocknest mineralogy are similar with plagioclase, olivine, and pyroxenes in similar proportions comprising >90% of crystalline phases, along with a substantial amorphous component (35% ± 15%). Yet Bagnold and Rocknest bulk chemistry differ. Bagnold sands are Si enriched relative to other soils at Gale crater, and H2O, S, and Cl are lower relative to all previously measured Martian soils and most Gale crater rocks. Mg, Ni, Fe, and Mn are enriched in the coarse‐sieved fraction of Bagnold sands, corroborated by visible/near‐infrared spectra that suggest enrichment of olivine. Collectively, patterns in major element chemistry and volatile release data indicate two distinctive volatile reservoirs in Martian soils: (1) amorphous components in the sand‐sized fraction (represented by Bagnold) that are Si‐enriched, hydroxylated alteration products and/or H2O‐ or OH‐bearing impact or volcanic glasses and (2) amorphous components in the fine fraction (<40 μm; represented by Rocknest and other bright soils) that are Fe, S, and Cl enriched with low Si and adsorbed and structural H2O.

Mineralogy of the MSL Curiosity landing site in Gale crater as observed by MRO/CRISM

Orbital data acquired by the Compact Reconnaissance Imaging Spectrometer for Mars (CRISM) and High Resolution Imaging Science Experiment instruments on the Mars Reconnaissance Orbiter (MRO) provide a synoptic view of compositional stratigraphy on the floor of Gale crater surrounding the area where the Mars Science Laboratory (MSL) Curiosity landed. Fractured, light-toned material exhibits a 2.2 µm absorption consistent with enrichment in hydroxylated silica. This material may be distal sediment from the Peace Vallis fan, with cement and fracture fill containing the silica. This unit is overlain by more basaltic material, which has 1 µm and 2 µm absorptions due to pyroxene that are typical of Martian basaltic materials. Both materials are partially obscured by aeolian dust and basaltic sand. Dunes to the southeast exhibit differences in mafic mineral signatures, with barchan dunes enhanced in olivine relative to pyroxene-containing longitudinal dunes. This compositional difference may be related to aeolian grain sorting.

Visible/near-infrared spectral diversity from in situ observations of the Bagnold Dune Field sands in Gale Crater, Mars

As part of the Bagnold Dune campaign conducted by Mars Science Laboratory rover Curiosity, visible/near-infrared reflectance spectra of dune sands were acquired using Mast Camera (Mastcam) multispectral imaging (445–1013 nm) and Chemistry and Camera (ChemCam) passive point spectroscopy (400–840 nm). By comparing spectra from pristine and rover-disturbed ripple crests and troughs within the dune field, and through analysis of sieved grain size fractions, constraints on mineral segregation from grain sorting could be determined. In general, the dune areas exhibited low relative reflectance, a weak ~530 nm absorption band, an absorption band near 620 nm, and a spectral downturn after ~685 nm consistent with olivine-bearing sands. The finest grain size fractions occurred within ripple troughs and in the subsurface and typically exhibited the strongest ~530 nm bands, highest relative reflectances, and weakest red/near-infrared ratios, consistent with a combination of crystalline and amorphous ferric materials. Coarser-grained samples were the darkest and bluest and exhibited weaker ~530 nm bands, lower relative reflectances, and stronger downturns in the near-infrared, consistent with greater proportions of mafic minerals such as olivine and pyroxene. These grains were typically segregated along ripple crests and among the upper surfaces of grain flows in disturbed sands. Sieved dune sands exhibited progressive decreases in reflectance with increasing grain size, as observed in laboratory spectra of olivine size separates. The continuum of spectral features observed between the coarse- and fine-grained dune sands suggests that mafic grains, ferric materials, and air fall dust mix in variable proportions depending on aeolian activity and grain sorting.

Compositional variations in sands of the Bagnold Dunes, Gale crater, Mars, from visible‐shortwave infrared spectroscopy and comparison with ground truth from the Curiosity rover

During its ascent up Mount Sharp, the Mars Science Laboratory Curiosity rover traversed the Bagnold Dune Field. We model sand modal mineralogy and grain size at four locations near the rover traverse, using orbital shortwave infrared single-scattering albedo spectra and a Markov chain Monte Carlo implementation of Hapkes radiative transfer theory to fully constrain uncertainties and permitted solutions. These predictions, evaluated against in situ measurements at one site from the Curiosity rover, show that X-ray diffraction-measured mineralogy of the basaltic sands is within the 95% confidence interval of model predictions. However, predictions are relatively insensitive to grain size and are nonunique, especially when modeling the composition of minerals with solid solutions. We find an overall basaltic mineralogy and show subtle spatial variations in composition in and around the Bagnold Dunes, consistent with a mafic enrichment of sands with cumulative aeolian-transport distance by sorting of olivine, pyroxene, and plagioclase grains. Furthermore, the large variations in Fe and Mg abundances (~20 wt %) at the Bagnold Dunes suggest that compositional variability may be enhanced by local mixing of well-sorted sand with proximal sand sources. Our estimates demonstrate a method for orbital quantification of composition with rigorous uncertainty determination and provide key constraints for interpreting in situ measurements of compositional variability within Martian aeolian sandstones.

Terrain Physical Properties Derived From Orbital Data and the First 360 Sols of Mars Science Laboratory Curiosity Rover Observations in Gale Crater

Physical properties of terrains encountered by the Curiosity rover during the first 360 sols of operations have been inferred from analysis of the scour zones produced by Sky Crane Landing System engine plumes, wheel touch down dynamics, pits produced by Chemical Camera (ChemCam) laser shots, rover wheel traverses over rocks, the extent of sinkage into soils, and the magnitude and sign of rover-based slippage during drives. Results have been integrated with morphologic, mineralogic, and thermophysical properties derived from orbital data, and Curiosity-based measurements, to understand the nature and origin of physical properties of traversed terrains. The hummocky plains (HP) landing site and traverse locations consist of moderately to well-consolidated bedrock of alluvial origin variably covered by slightly cohesive, hard-packed basaltic sand and dust, with both embedded and surface-strewn rock clasts. Rock clasts have been added through local bedrock weathering and impact ejecta emplacement and form a pavement-like surface in which only small clasts (<5 to 10 cm wide) have been pressed into the soil during wheel passages. The bedded fractured (BF) unit, site of Curiositys first drilling activity, exposes several alluvial-lacustrine bedrock units with little to no soil cover and varying degrees of lithification. Small wheel sinkage values (<1 cm) for both HP and BF surfaces demonstrate that compaction resistance countering driven-wheel thrust has been minimal and that rover slippage while traversing across horizontal surfaces or going uphill, and skid going downhill, have been dominated by terrain tilts and wheel-surface material shear modulus values.

Mars Science Laboratory Curiosity Rover Megaripple Crossings up to Sol 710 in Gale Crater

After landing in Gale Crater on August 6, 2012, the Mars Science Laboratory Curiosity rover traveled across regolith-covered, rock-strewn plains that transitioned into terrains that have been variably eroded, with valleys partially filled with windblown sands, and intervening plateaus capped by well-cemented sandstones that have been fractured and shaped by wind into outcrops with numerous sharp rock surfaces. Wheel punctures and tears caused by sharp rocks while traversing the plateaus led to directing the rover to traverse in valleys where sands would cushion wheel loads. This required driving across a megaripple (windblown, sand-sized deposit covered by coarser grains) that straddles a narrow gap and several extensive megaripple deposits that accumulated in low portions of valleys. Traverses across megaripple deposits led to mobility difficulties, with sinkage values up to approximately 30% of the 0.50 m wheel diameter, resultant high compaction resistances, and rover-based slip up to 77%. Analysis of imaging and engineering data collected during traverses across megaripples for the first 710 sols (Mars days) of the mission, laboratory-based single-wheel soil experiments, full-scale rover tests at the Dumont Dunes, Mojave Desert, California, and numerical simulations show that a combination of material properties and megaripple geometries explain the high wheel sinkage and slip events. Extensive megaripple deposits have subsequently been avoided and instead traverses have been implemented across terrains covered with regolith or thin windblown sand covers and megaripples separated by bedrock exposures.

The stratigraphy and evolution of lower Mount Sharp from spectral, morphological, and thermophysical orbital data sets

Abstract We have developed a refined geologic map and stratigraphy for lower Mount Sharp using coordinated analyses of new spectral, thermophysical, and morphologic orbital data products. The Mount Sharp group consists of seven relatively planar units delineated by differences in texture, mineralogy, and thermophysical properties. These units are (1–3) three spatially adjacent units in the Murray formation which contain a variety of secondary phases and are distinguishable by thermal inertia and albedo differences, (4) a phyllosilicate‐bearing unit, (5) a hematite‐capped ridge unit, (6) a unit associated with material having a strongly sloped spectral signature at visible near‐infrared wavelengths, and (7) a layered sulfate unit. The Siccar Point group consists of the Stimson formation and two additional units that unconformably overlie the Mount Sharp group. All Siccar Point group units are distinguished by higher thermal inertia values and record a period of substantial deposition and exhumation that followed the deposition and exhumation of the Mount Sharp group. Several spatially extensive silica deposits associated with veins and fractures show that late‐stage silica enrichment within lower Mount Sharp was pervasive. At least two laterally extensive hematitic deposits are present at different stratigraphic intervals, and both are geometrically conformable with lower Mount Sharp strata. The occurrence of hematite at multiple stratigraphic horizons suggests redox interfaces were widespread in space and/or in time, and future measurements by the Mars Science Laboratory Curiosity rover will provide further insights into the depositional settings of these and other mineral phases.