Alessandro Chini

Surface-related drain current dispersion effects in AlGaN-GaN HEMTs

Drain current dispersion effects are investigated in AlGaN-GaN HEMTs by means of pulsed, transient, and small-signal measurements. Gate- and drain-lag effects characterized by time constants in the order of 10/sup -5/-10/sup -4/ s cause dispersion between dc and pulsed output characteristics when the gate or the drain voltage are pulsed. An activation energy of 0.3 eV is extracted from temperature-dependent gate-lag measurements. We show that two-dimensional numerical device simulations accounting only for polarization charges and donor-like traps at the ungated AlGaN surface can quantitatively reproduce all dispersion effects observed experimentally in the different pulsing modes, provided that the measured activation energy is adopted as the energetic distance of surface traps from the valence-band edge. Within this hypothesis, simulations show that surface traps behave as hole traps during transients, interacting with holes attracted at the AlGaN surface by the negative polarization charge.

High breakdown voltage AlGaN-GaN HEMTs achieved by multiple field plates

High-voltage Al/sub 0.22/Ga/sub 0.78/N-GaN high-electron mobility transistors have been fabricated using multiple field plates over dielectric passivation layers. The device breakdown voltage was found to increase with the addition of the field plates. With two field plates, the device showed a breakdown voltage as high as 900 V. This technique is easy to apply, based on the standard planar transistor fabrication, and especially attractive for the power switching applications.

N-polar GaN/AlGaN/GaN high electron mobility transistors

We describe the development of N-polar GaN-based high electron mobility transistors grown by N2 plasma-assisted molecular beam epitaxy on C-face SiC substrates. High mobility AlGaN∕GaN modulation-doped two-dimensional electron gas channels were grown, and transistors with excellent dc and small-signal performance were fabricated on these wafers. Large-signal dispersion was observed, and the trap states responsible for this were identified, and layer designs to remove the dispersive effects of these traps were demonstrated. Finally, an AlGaN-cap layer was used to reduce gate leakage in these devices, and a low-dispersion high breakdown voltage device was achieved. This detailed study of dispersion and leakage in N-polar GaN-based transistors establishes a technological base for further development of field effect devices based on N-polar III-nitrides.

Deep-Level Characterization in GaN HEMTs-Part I: Advantages and Limitations of Drain Current Transient Measurements

This paper critically investigates the advantages and limitations of the current-transient methods used for the study of the deep levels in GaN-based high-electron mobility transistors (HEMTs), by evaluating how the procedures adopted for measurement and data analysis can influence the results of the investigation. The article is divided in two parts within Part I. 1) We analyze how the choice of the measurement and analysis parameters (such as the voltage levels used to induce the trapping phenomena and monitor the current transients, the duration of the filling pulses, and the method used for the extrapolation of the time constants of the capture/emission processes) can influence the results of the drain current transient investigation and can provide information on the location of the trap levels responsible for current collapse. 2) We present a database of defects described in more than 60 papers on GaN technology, which can be used to extract information on the nature and origin of the trap levels responsible for current collapse in AlGaN/GaN HEMTs. Within Part II, we investigate how self-heating can modify the results of drain current transient measurements on the basis of combined experimental activity and device simulation.

High-power polarization-engineered GaN/AlGaN/GaN HEMTs without surface passivation

In this paper, a high-power GaN/AlGaN/GaN high electron mobility transistor (HEMT) has been demonstrated. A thick cap layer has been used to screen surface states and reduce dispersion. A deep gate recess was used to achieve the desired transconductance. A thin SiO/sub 2/ layer was deposited on the drain side of the gate recess in order to reduce gate leakage current and improve breakdown voltage. No surface passivation layer was used. A breakdown voltage of 90 V was achieved. A record output power density of 12 W/mm with an associated power-added efficiency (PAE) of 40.5% was measured at 10 GHz. These results demonstrate the potential of the technique as a controllable and repeatable solution to decrease dispersion and produce power from GaN-based HEMTs without surface passivation.

Time-dependent degradation of AlGaN/GaN high electron mobility transistors under reverse bias

This paper describes a detailed analysis of the time-dependent degradation kinetics of GaN-based high electron mobility transistors submitted to reverse-bias stress. We show that: (1) exposure to reverse-bias may induce recoverable changes in gate leakage and threshold voltage, due to the accumulation of negative charge within the AlGaN layer, and of positive charge at the AlGaN/GaN interface. (2) Permanent degradation consists in the generation of parasitic leakage paths. Several findings support the hypothesis that permanent degradation is due to a defect percolation process: (2(a)) for sufficiently long stress times, degradation occurs even below the “critical voltage” estimated by step stress experiments; (2(b)) before permanent degradation, gate current becomes noisy, indicating an increase in defect concentration; and (2(c)) time to breakdown strongly depends on the initial defectiveness of the samples.

Power and linearity characteristics of field-plated recessed-gate AlGaN-GaN HEMTs

Record power density and high-efficiency operation with AlGaN-GaN high-electron mobility transistor (HEMT) devices have been achieved by adopting a field-plated gate-recessed structure. Devices grown on SiC substrate yielded very high power density (18.8 W/mm with 43% power-added efficiency (PAE) as well as high efficiency (74% with 6 W/mm) under single-tone continuous-wave testing at 4 GHz. Devices also showed excellent linearity characteristics when measured under two-tone continuous-wave signals at 4 GHz. When biased in deep-class AB (33 mA/mm, 3% I/sub max/) device maintained a carrier to third-order intermodulation ratio of 30 dBc up to a power level of 2.4 W/mm with 53% PAE; increasing bias current to 66 mA/mm (6% I/sub max/) allowed high linear operation (45 dBc) up to a power level of 1.4 W/mm with 38% PAE.

Reliability issues of Gallium Nitride High Electron Mobility Transistors

In the present paper we review the most recent degradation modes and mechanisms recently observed in AlGaN/GaN (Aluminum Gallium Nitride/Gallium Nitride). High Electron-Mobility Transistors (HEMTs), as resulting from a detailed accelerated testing campaign, based on reverse bias tests and DC accelerated life tests at various temperatures. Despite the large efforts spent in the last few years, and the progress in mean time to failure values, reliability of GaN HEMTs, and millimeter microwave integrated circuits still represent a relevant issue for the market penetration of these devices. The role of temperature in promoting GaN HEMT failure is controversial, and the accelerating degradation factors are largely unknown. The present paper proposes a methodology for the analysis of failure modes and mechanisms of GaN HEMTs, based on (i) DC and RF stress tests accompanied by an (ii) extensive characterization of traps using deep level transient spectroscopy and pulsed measurements, (iii) detailed analysis of electrical characteristics, and (iv) comparison with two-dimensional device simulations. Results of failure analysis using various microscopy and spectroscopy techniques are presented and failure mechanisms observed at the high electric field values typical of the operation of these devices are reviewed.

A C-band high-dynamic range GaN HEMT low-noise amplifier

A C-band low-noise amplifier (LNA) is designed and fabricated using GAN HEMT power devices. The one-stage amplifier has a measured noise figure of 1.6 dB at 6 GHz, with an associated gain of 10.9 dB and IIP3 of 13 dBm. it also exhibits broadband operation from 4-8 GHz with noise figure less than 1.9 dB. The circuit can endure up to 31 dBm power from the input port. Compared to circuits based on other material and technology, the circuit shows comparable noise figure with improved dynamic range and survivability.

Mechanisms of RF Current Collapse in AlGaN–GaN High Electron Mobility Transistors

The physical mechanisms underlying RF current- collapse effects in AlGaN-GaN high-electron-mobility transistors are investigated by means of measurements and numerical device simulations. This paper suggests the following conditions: 1) both surface and buffer traps can contribute to RF current collapse through a similar physical mechanism involving capture and emission of electrons tunneling from the gate; 2) surface passivation strongly mitigates RF current collapse by reducing the surface electric field and inhibiting electron injection into traps; 3) for surface-trap densities lower than 9 x 1012 cm-2, surface-potential barriers in the 1-2-eV range can coexist with surface traps having much a shallower energy and, therefore, inducing RF current-collapse effects characterized by relatively short time constants.