Arno Klenke

High photon flux table-top coherent extreme-ultraviolet source

High photon flux with up to 1012 photons in the 25–40 eV range has been achieved in a new table-top coherent extreme ultraviolet (EUV) source based on phase-matched high-harmonic generation using a fibre laser. Intense and compact EUV sources are needed for certain types of spectroscopic and imaging applications.

Energy scaling of femtosecond amplifiers using actively controlled divided-pulse amplification

Divided-pulse amplification is a promising method for the energy scaling of femtosecond laser amplifiers, where pulses are temporally split prior to amplification and coherently recombined afterwards. We present a method that uses an actively stabilized setup with separated stages for splitting and combining. The additional degrees of freedom can be employed to mitigate the limitations originating from saturation of the amplifier that cannot be compensated in passive double-pass configurations using just one common stage for pulse splitting and combining. In a first proof-of-principle experiment, actively controlled divided pulses are applied in a fiber chirped-pulse amplification system resulting in combined and compressed pulses with an energy of 1.25 mJ and a peak power of 2.9 GW.

Coherently-combined two channel femtosecond fiber CPA system producing 3 mJ pulse energy

We present a fiber CPA system consisting of two coherently combined fiber amplifiers, which have been arranged in an actively stabilized Mach-Zehnder interferometer. Pulse durations as short as 470 fs and pulse energies of 3 mJ, corresponding to 5.4 GW of peak power, have been achieved at an average power of 30 W.

Coherent addition of fiber-amplified ultrashort laser pulses.

We report on a novel approach of performance scaling of ultra-fast lasers by means of coherent combination. Pulses from a single mode-locked laser are distributed to a number of spatially separated fiber amplifiers and coherently combined after amplification. Splitting and combination is achieved by polarization cubes, i.e. the approach bases on polarization combining. A Hänsch-Couillaud detector measures the polarization state at the output. The error signal (deviation from linear polarization) is used to stabilize the synchronization of different channels. In a proof-of-principle experiment the combination of two femtosecond fiber-based CPA systems is presented. A combining efficiency as high as 97% has been achieved. The technique offers a unique scaling potential and can be applied to all ultrafast amplification schemes independent of the architecture of the gain medium.

53 W average power few-cycle fiber laser system generating soft x rays up to the water window

We report on a few-cycle laser system delivering sub-8-fs pulses with 353 μJ pulse energy and 25 GW of peak power at up to 150 kHz repetition rate. The corresponding average output power is as high as 53 W, which represents the highest average power obtained from any few-cycle laser architecture so far. The combination of both high average and high peak power provides unique opportunities for applications. We demonstrate high harmonic generation up to the water window and record-high photon flux in the soft x-ray spectral region. This tabletop source of high-photon flux soft x rays will, for example, enable coherent diffractive imaging with sub-10-nm resolution in the near future.

Basic considerations on coherent combining of ultrashort laser pulses

Coherent combining is a novel approach to scale the performance of laser amplifiers. The use of ultrashort pulses in a coherent combining setup results in new challenges compared to continuous wave operation or to pulses on the nanosecond timescale, because temporal and spectral effects such as self-phase modulation, dispersion and the optical path length difference between the pulses have to be considered. In this paper the impact of these effects on the combining process has been investigated and simple analytical equations for the evaluation of this impact have been obtained. These formulas provide design guidelines for laser systems using coherent combining. The results show that, in spite of the temporal and spectral effects mentioned above, for a carefully adjusted and stabilized system an excellent efficiency of the combining process can still be achieved.

Analysis of passively combined divided-pulse amplification as an energy-scaling concept

The energy scaling of ultrashort-pulse systems employing simultaneously the techniques of chirped-pulse amplification and passively combined divided-pulse amplification is analyzed both experimentally and numerically. The maximum achievable efficiency is investigated and fundamental limitations originating from gain saturation, self-phase modulation and depolarization are discussed. A solution to these limitations could be an active stabilization scheme, which would allow for the operation of every single fiber amplifier at higher pulse energies.

Energetic sub-2-cycle laser with 216 W average power.

Few-cycle lasers are essential for many research areas such as attosecond physics that promise to address fundamental questions in science and technology. Therefore, further advancements are connected to significant progress in the underlying laser technology. Here, two-stage nonlinear compression of a 660 W femtosecond fiber laser system is utilized to achieve unprecedented average power levels of energetic ultrashort or even few-cycle laser pulses. In a first compression step, 408 W, 320 μJ, 30 fs pulses are achieved, which can be further compressed to 216 W, 170 μJ, 6.3 fs pulses in a second compression stage. To the best of our knowledge, this is the highest average power few-cycle laser system presented so far. It is expected to significantly advance the fields of high harmonic generation and attosecond science.

88 W 0.5 mJ femtosecond laser pulses from two coherently combined fiber amplifiers.

The generation of 0.5 mJ femtosecond laser pulses by coherent combining of two high power high energy fiber chirped-pulse amplifiers is reported. The system is running at a repetition frequency of 175 kHz producing 88 W of average power after the compressor unit. Polarizing beam splitters have been used to realize an amplifying Mach-Zehnder interferometer, which has been stabilized with a Hänsch-Couillaud measurement system. The stabilized system possesses a measured residual rms phase difference fluctuation between the two branches as low as λ/70 rad at the maximum power level. The experiment proves that coherent addition of femtosecond fiber lasers can be efficiently and reliably performed at high B-integral and considerable thermal load in the individual amplifiers.

BBO-sapphire sandwich structure for frequency conversion of high power lasers

We report on successful joining of a beta barium borate crystal by plasma-activated direct bonding. Based on this technology, a sandwich structure consisting of a beta barium borate crystal, joined with two sapphire heat spreaders has been fabricated. Due to the high thermal conductivity of sapphire, the sandwich structure possesses superior thermal properties compared to the single crystal. Simulations based on the finite element method indicate a significant reduction of thermal gradients and the resulting mechanical stresses. A proof of principle experiment demonstrates the high power capability of the fabricated structure. A pulsed fiber laser emitting up to 253 W average power has been frequency doubled with both a single BBO crystal and the fabricated sandwich structure. The bonded stack showed better heat dissipation and less thermo-optical beam distortion than the single crystal. The work demonstrates the huge potential of optical sandwich structures with enhanced functionality. In particular, frequency conversion at average powers in the kW range with excellent beam quality will be feasible in future.