Celia Domeño

The challenge of identifying non-intentionally added substances from food packaging materials: a review.

Packaged food can contain non-intentionally added substances (NIAS) as a result of reaction and degradation processes or the presence of impurities in the raw materials used for the packaging production. This manuscript reviews the evidence of NIAS and their possible origin. One of the most challenging and difficult tasks when a sample of packaging materials arrives at the laboratory is knowing the procedure to apply for identifying the unknown compounds. This work proposes an analytical procedure for sample treatment, applicable to polymers as well as to migration samples, and for NIAS identification. The identification protocol comprises the determination of both volatile and non-volatile compounds. A review is presented of the most novel analytical techniques used for identification purposes, particularly high resolution mass spectrometry (HRMS).

Determination of bile acids in human serum by on-line restricted access material–ultra high-performance liquid chromatography–mass spectrometry

This paper describes a new, fully automated on-line method combining restricted access material (RAM) extraction and ultra high-performance liquid chromatography (UHPLC) with mass spectrometric (MS) detection for determining congeners of bile acids (BAs) in human serum. In this method, low-pressure RAM and high-pressure UHPLC-MS are hyphenated by using a 2.5-mL loop-type interface. The compatibility problem between the large volume (1.2mL) of strong solvent (methanol) used for RAM elution and the need for a weak solvent in UHPLC injection has been addressed by using an auxiliary pre-column cross-flow of 0.1% aqueous formic acid. In this way, the complete 2.5mL loop volume can be injected into the UHPLC system, thereby maximizing sensitivity while maintaining good chromatographic performance. The optimised method allows the simultaneous analysis of 13 bile acids in a single run, including glycine- and taurine-conjugated bile acids, cholic acid (CA), deoxycholic acid (DCA), chenodeoxycholic acid (CDCA), ursodeoxycholic acid (UDCA), and litocholic acid. The complete analysis of a 100-microL single serum sample is performed in 30 min, providing detection limits in the pg range (corresponding with clinically relevant concentration levels) for all of the analytes except lithocholic acid, intra-day precision values (%R.S.D.) below 4% (except ursodeoxycholic acid) and inter-day precision lower than 15% (except ursodeoxycholic, glycoursodeoxycholic acid (GUDCA) and lithocholic acid).

Atmospheric pressure gas chromatography coupled to quadrupole-time of flight mass spectrometry as a powerful tool for identification of non intentionally added substances in acrylic adhesives used in food packaging materials

Acrylic adhesives are used to manufacture multilayer laminates that are used in food packaging to form the geometric shape of the package as well as to stick labels on the packages. Once applied on the packaging adhesives can supply potential migrants that could endanger the packaged food. Adhesives are complex matrices where intentionally and non intentionally added substances are present, but the identification of the migrants is required by law. In this study atmospheric pressure gas chromatography coupled to a quadrupole hyphenated to a time of flight mass spectrometer (APGC-MS/Q-TOF) has been explored for identification of unknowns coming from three different acrylic adhesives. The results are compared to those obtained by conventional GC-MS-Q (quadrupole). Sixteen compounds were identified by GC-MS/Q and five of them were confirmed by APGC-MS/Q-TOF as their molecular ions were found. Moreover, additional three new compounds were identified and their structure was elucidated working with the spectra obtained by APGC-MS/Q-TOF. This finding was very relevant as these compounds were biocides suspected to be allergenic and cytotoxic in humans. Migration studies were carried out using Tenax as solid food simulant and the results showed that the three acrylic adhesives tested in this work were safe for being used in food packaging materials since the migration of compounds previously identified was below the limit established in the current legislation.

Atmospheric pressure gas chromatography with quadrupole time of flight mass spectrometry for simultaneous detection and quantification of polycyclic aromatic hydrocarbons and nitro-polycyclic aromatic hydrocarbons in mosses☆

Within the family of polycyclic aromatic hydrocarbons (PAHs), nitrated derivatives are of particular interest in environmental science because they have well-known carcinogenic and mutagenic effects. They are in fact more toxic than their parent PAHs. One valuable diagnosis of atmospheric pollution can be obtained using biomonitors such as mosses. These biomonitors can provide information about air pollution over long periods of time in wilderness areas. Thus, they can serve as monitors of the atmospheric transport of pollutants. In this study, atmospheric pressure gas chromatography coupled to a quadrupole hyphenated to a time of flight mass spectrometer (APGC-MS/Q-TOF) has been examined for the identification of target analytes (15 PAHs and 8 NPAHs) for subsequent use in the analysis of mosses. Working ranges in low μg g(-1) concentration levels were obtained with most correlation coefficients higher than 0.999. All LODs were in the 0.007-0.035μg g(-1) range and higher LODs (0.035μg g(-1)) were obtained for the less volatile PAHs with higher mass and retention times: benzo(g,h,i)perylene, dibenz(a,h)anthracene and indeno(1,2,3-c,d)pyrene. These LODs are of importance for the intended use, biomonitoring, especially taking into account that NPAHs are commonly found at very low concentration levels. Recoveries from mosses ranged from 75 to 98%. Intraday and interday precision ranged from 1.8 to 11.1% RSD and from 2.4 to 16.7% RSD, respectively. Very low concentrations of NPAHs were found in mosses compared to those of PAHs. All these data were used for pattern recognition of the pollutant source. The results are shown and discussed.

VOC removal and deodorization of effluent gases from an industrial plant by photo-oxidation, chemical oxidation, and ozonization.

The efficiency of photo-oxidation, chemical oxidation by sodium hypochlorite, and ozonization for the industrial-scale removal of volatile organic compounds (VOCs) and odors from gaseous emissions was studied by applying these treatments (in an experimental system) to substances passing through an emission stack of a factory producing maize derivatives. Absorption and ozonization were the most efficient treatment, removing 75% and 98% of VOCs, respectively, while photo-oxidation only removed about 59%. The emitted chemical compounds and odors were identified and quantified by gas chromatography-mass spectrometry (in full-scan mode). In addition to presenting the results, their implications for selecting optimal processes for treating volatile emissions are discussed.

Characterization of wood plastic composites made from landfill-derived plastic and sawdust: Volatile compounds and olfactometric analysis

Application of wood plastic composites (WPCs) obtained from recycled materials initially intended for landfill is usually limited by their composition, mainly focused on release of volatile organic compounds (VOCs) which could affect quality or human safety. The study of the VOCs released by a material is a requirement for new composite materials. Characterization and quantification of VOCs of several WPC produced with low density polyethylene (LDPE) and polyethylene/ethylene vinyl acetate (PE/EVA) films and sawdust were carried out, in each stage of production, by solid phase microextraction in headspace mode (HS-SPME) and gas chromatography-mass spectrometry (GC-MS). An odor profile was also obtained by HS-SPME and GC-MS coupled with olfactometry analysis. More than 140 compounds were observed in the raw materials and WPC samples. Some quantified compounds were considered WPC markers such as furfural, 2-methoxyphenol, N-methylphthalimide and 2,4-di-tert-butylphenol. Hexanoic acid, acetic acid, 2-methoxyphenol, acetylfuran, diacetyl, and aldehydes were the most important odorants. None of the VOCs were found to affect human safety for use of the WPC.

Simultaneous determination of oxysterols, phytosterols and cholesterol precursors by high performance liquid chromatography tandem mass spectrometry in human serum

A fast and sensitive high performance liquid chromatography with atmospheric pressure chemical ionization tandem mass spectrometry (HPLC-APCI-MS/MS) method to identify and quantify oxysterols, phytosterols and non-cholesterol sterols at the pico-molar concentration level in human serum in only one run was developed in this study. This method allows the simultaneous separation and quantitation of individual phytosterols, cholesterol precursors and oxidized derivatives of cholesterol without a derivatization step in a single run, thus providing a more confident quantitation of sterols in serum. After saponification, solid-phase extraction (SPE) used as a clean-up step and HPLC separation, detection by MS was developed using APCI and multiple ion monitoring modes. This method employs reversed-phase C18 SPE cartridges and serum calibrators, as well as isotopically labelled cholesterol as an internal standard added before sample processing. The time consumed for a single sample is reduced from the 4 hours of conventional sterol analysis to 1 hour including the chromatographic run time. The method has been evaluated by analyzing a certified cholesterol sample as well as by comparison to other two methods used as reference, based on GC and enzymatic reaction, respectively. Serum from 14 individuals was successfully analyzed. Detection limits for oxysterols, phytosterols and non-cholesterol sterols, all determined in a single run in small serum volumes, were between 0.47 and 1.69 pM. Intra-day precision was <7% for all sterols in in-house-made lipoprotein-deficient serum. The limits of detection showed high sensitivity with very good intraday- and interday-precision for all sterols. The recoveries of the phytosterols, cholesterol precursors and cholestanol ranged from 77% to 92%. These analytical parameters provide a reliable and reproducible method for the identification and quantitation of human sterols.

Distribution of Pb, V, Cr, Ni, Cd, Cu and Fe in particles formed from the combustion of waste oils.

The determination of Pb, V, Cr, Ni, Cd, Cu and Fe in particles of different size obtained from the combustion of waste oils has been carried out. The study consists of the separation of several fractions according to the size of particles, the wet digestion and the individual analysis by graphite furnace atomic absorption spectrometry of the mentioned metals. Taking into account the volatilization temperature of different compounds containing the metals and their distribution on the size fractions, the mineral speciation of metals is proposed.

Multivariate analysis applied to the study of the distribution of chlorobiphenyls (CBs), including the non-ortho-CBs, in fish and sea mammals

Twenty-one individual chlorobiphenyls (CBs), including the most toxic non-ortho-CBs, were determined in 52 samples of sea mammals, harbour porpoise (Phoceana phoceana), dabs (Limanda limanda), seals (Phoca vitulina) and dolphins (Tursiops truncatus). The toxic non-ortho-CBs and mono-ortho-CBs were isolated from the di- and tri-ortho-CBs using a pyrenylsilica HPLC column prior to the final determination by GC with electron-capture detection. The distribution of the CBs in the different species were studied by principal component analysis. Separations of males and females, young and adult individuals and the different species of sea mammals were obtained based on the degree of accumulation of CBs.

Atmospheric pressure solid analysis probe coupled to quadrupole-time of flight mass spectrometry as a tool for screening and semi-quantitative approach of polycyclic aromatic hydrocarbons, nitro-polycyclic aromatic hydrocarbons and oxo-polycyclic aromatic hydrocarbons in complex matrices

A new screening and semi-quantitative approach has been developed for direct analysis of polycyclic aromatic hydrocarbons (PAHs) and their nitro and oxo derivatives in environmental and biological matrices using atmospheric pressure solid analysis probe (ASAP) quadrupole-time of flight mass spectrometry (Q-TOF-MS). The instrumental parameters were optimized for the analysis of all these compounds, without previous sample treatment, in soil, motor oil, atmospheric particles (ashes) and biological samples such as urine and saliva of smokers and non-smokers. Ion source parameters in the MS were found to be the key parameters, with little variation within PAHs families. The optimized corona current was 4 µA, sample cone voltage 80 V for PAHs, nitro-PAHs and oxo-PAHs, while the desolvation temperatures varied from 300°C to 500°C. The analytical method performance was checked using a certified reference material. Two deuterated compounds were used as internal standards for semi-quantitative purposes together with the pure individual standard for each compound and the corresponding calibration plot. The compounds nitro PAH 9-nitroanthracene and oxo-PAH 1,4-naphthalenedione, were found in saliva and urine in a range below 1 µg/g while the range of PAHs in these samples was below 2 µg/g. Environmental samples provided higher concentration of all pollutants than urine and saliva.