Chunyan Yao

Aptamer-based piezoelectric quartz crystal microbalance biosensor array for the quantification of IgE.

The aim of this study was to develop a rapid method to measure IgE in human serum by use of a direct aptamer-based biosensor based on a quartz crystal microbalance (QCM). An avidin monolayer was applied to immobilize aptamers specific for IgE on the gold surface of a quartz crystal. The frequency shifts (FS) of the QCM were measured and related to IgE concentrations. We could demonstrate that aptamers were able to detect IgE with high specificity and sensitivity in 15 min. A linear relationship existed between the FS (Hz) and the IgE concentrations from 2.5 to 200 microg/L in buffer and human serum. The regression equation was y = 1.03x - 0.06 for this QCM method and chemiluminescence in 50 clinical human serum samples. In addition, the aptamer receptors tolerated repeated affine layer regeneration after ligand binding and recycling of the biosensor with little loss of sensitivity. When stored for 3 weeks, the FS were all greater than 90% of those on the response at the first day. The QCM biosensor can measure IgE and offer advantages of high specificity, reusability, low detection limit, no label or sample pretreatment, and low sample requirement. The aptamer QCM biosensor was suitable for sensitive and specific protein detection, representing an innovative tool for future proteomics.

Development of a Quartz Crystal Microbalance Biosensor with Aptamers as Bio-recognition Element

The ultimate goal in any biosensor development project is its use for actual sample detection. Recently, there has been an interest in biosensors with aptamers as bio-recognition elements, but reported examples all deal with standards, not human serum. In order to verify the differences of aptamer-based biosensor and antibody-based biosensor in clinical detection, a comparison of the performance of aptamer-based and antibody-based quartz crystal microbalance (QCM) biosensors for the detection of immunoglobulin E (IgE) in human serum was carried out. Aptamers (or antibodies) specific to IgE were immobilized on the gold surface of a quartz crystal. The frequency shifts of the QCM were measured. The linear range with the antibody (10–240 μg/L) compared to that of the aptamer (2.5–200 μg/L), but a lower detection limit could be observed in the aptamer-based biosensor. The reproducibility of the two biosensors was comparable. The aptamers were equivalent or superior to antibodies in terms of specificity and sensitivity. In addition, the aptamer receptors could tolerate repeated affine layer regeneration after ligand binding and recycling of the biosensor with little loss of sensitivity. When stored for three weeks, the frequency shifts of the aptamer-coated crystals were all greater than 90% of those on the response at the first day.

Isothermal detection of multiple point mutations by a surface plasmon resonance biosensor with Au nanoparticles enhanced surface-anchored rolling circle amplification

In this study, we developed a surface plasmon resonance (SPR) DNA biosensor method using surface-anchored rolling circle amplification (RCA) and Au nanoparticles modified probes (AuNPs) to isothermally detect multiple point mutations associated with drug-resistance in multidrug-resistant Mycobacterium Tuberculosis (MDRTB). A set of probes contains an allele-specific padlock probe (PLP), a capture probe and an AuNPs. The linear PLPs, circularized by ligation upon the recognition of the point mutation on DNA targets, hybridize to the capture probes via the specific tag/anti-tag recognition. Upon recognition each point mutation is identified by locating into the corresponding channel on the chip. Then the immobilized primer (capture probe)-template (circular PLP) complex are amplified isothermally as RCA and further amplified by AuNPs. The RCA products immobilized on the chip surface cause great SPR angle changes consequently. The 5 pM synthetic oligonucleotides and 8.2 pg uL(-1) of genomic DNA from clinical samples can be detected by the method. The positive mutation detection is achieved with a wild-type to mutant ratio of 5000:1. The method was demonstrated by targeting five clinically meaningful mutations in MDRTB. Thirty clinical samples were identified and they were in good agreement with the results from sequencing.

Detection of Staphylococcus epidermidis by a Quartz Crystal Microbalance Nucleic Acid Biosensor Array Using Au Nanoparticle Signal Amplification

Staphylococcus epidermidis is a critical pathogen of nosocomial blood infections, resulting in significant morbidity and mortality. A piezoelectric quartz crystal microbalance (QCM) nucleic acid biosensor array using Au nanoparticle signal amplification was developed to rapidly detect S. epidermidis in clinical samples. The synthesized thiolated probes specific targeting S. epidermidis 16S rRNA gene were immobilized on the surface of QCM nucleic acid biosensor arrays. Hybridization was induced by exposing the immobilized probes to the PCR amplified fragments of S. epidermidis, resulting in a mass change and a consequent frequency shift of the QCM biosensor. To further enhance frequency shift results from above described hybridizations, streptavidin coated Au nanoparticles were conjugated to the PCR amplified fragments. The results showed that the lowest detection limit of current QCM system was 1.3×103 CFU/mL. A linear correlation was found when the concentration of S. epidermidis varied from 1.3×103 to 1.3×107 CFU/mL. In addition, 55 clinical samples were detected with both current QCM biosensor system and conventional clinical microbiological method, and the sensitivity and specificity of current QCM biosensor system were 97.14% and 100%, respectively. In conclusion, the current QCM system is a rapid, low-cost and sensitive method that can be used to identify infection of S. epidermidis in clinical samples.

Real-time monitoring of the strand displacement amplification (SDA) of human cytomegalovirus by a new SDA-piezoelectric DNA sensor system

Nucleic acid amplification has long been used in biosensor technologies, such as DNA sensors, DNA chips and microarrays, due to its advantage of high sensitivity in detecting target DNA. However, dynamic monitoring of nucleic acid amplifications with traditional DNA sensors in real-time is difficult since a constant temperature must be maintained during detection. Thus, the piezoelectric sensor, one type of traditional DNA sensor, is not applicable in real-time monitoring PCR due to the dramatic change in temperature that occurs during reaction. In this study, we introduced strand displacement amplification (SDA), an well-developed nucleic acid amplification technique that can work under conditions of constant temperature, into the development of a novel piezoelectric sensor. Using the new SDA-piezoelectric DNA sensor, we designed a stable system for liquid-phase detection, in which the crystal oscillator plate was fixed by an easily adjustable screw-threaded clamping mechanism and successfully applied the new sensor system to real-time SDA monitoring of human cytomegalovirus (HCMV). This new technique overcomes the shortcomings of traditional DNA sensors in real-time monitoring of nucleic acid amplification. The technique has proved to be a markedly simplified procedure with a number of advantages, such as higher sensitivity, better time efficiency, and the ability of dynamic real-time detection.

A SPR biosensor based on signal amplification using antibody-QD conjugates for quantitative determination of multiple tumor markers

The detection of tumor markers is very important in early cancer diagnosis; however, tumor markers are usually present at very low concentrations, especially in the early stages of tumor development. Surface plasmon resonance (SPR) is widely used to detect biomolecular interactions; it has inherent advantages of being high-throughput, real-time, and label-free technique. However, its sensitivity needs essential improvement for practical applications. In this study, we developed a signal amplification strategy using antibody-quantum dot (QD) conjugates for the sensitive and quantitative detection of α-fetoprotein (AFP), carcinoembryonic antigen (CEA) and cytokeratin fragment 21-1 (CYFRA 21-1) in clinical samples. The use of a dual signal amplification strategy using AuNP-antibody and antibody-QD conjugates increased the signal amplification by 50-folds. The constructed SPR biosensor showed a detection limit as low as 0.1 ng/mL for AFP, CEA, and CYFRA 21-1. Moreover, the results obtained using this SPR biosensor were consistent with those obtained using the electrochemiluminescence method. Thus, the constructed SPR biosensor provides a highly sensitive and specific approach for the detection of tumor markers. This SPR biosensor can be expected to be readily applied for the detection of other tumor markers and can offer a potentially powerful solution for tumor screening.

Detection of hybridization of single-strand DNA PCR products in temperature change process by a novel metal-clamping piezoelectric sensor

Oligonucleotide probes on the sensor surface can be hybridized with single-strand DNA (ssDNA) that is formed from PCR products in ice bath after degeneration. Thus, detection of PCR products by piezoelectric sensors requires the participation of ssDNA PCR products in ice bath. When PCR products in ice bath are added into the buffer of the sensor well at room temperature, there will be a temperature change process during mixing. However, it still remains unclear whether the temperature change affects the frequency baseline stability of the sensor and the result judgment, which is the basic condition for detecting hybridization of nucleic acid. In this study, we detected the hybridization of HPV PCR products during temperature change process by a self-designed adjustable metal-clamping piezoelectric sensor. The study mainly involves sensor adjustment, probe immobilization and ice bath sample addition (at different concentrations and different volumes). The response curve of basic frequency in temperature change process showed three stages, i.e., increase, decrease to baseline, and continuous decrease to stability. The early increase of frequency and duration of the time can reach 55+/-7.4 Hz and 39 min when 40 microL sample (0-1 degrees C) was added into 110 microL buffer (25 degrees C). The frequency increase effect caused by temperature difference at early stage depends on the volume ratio of two liquids and on the temperature difference. The results indicate that we should pay more attention to possibly small volume of PCR products in ice bath and minor temperature difference of two liquids in operation.