Daniel F. Santavicca

Tunable superconducting nanoinductors

We characterize inductors fabricated from ultra-thin, approximately 100 nm wide strips of niobium (Nb) and niobium nitride (NbN). These nanowires have a large kinetic inductance in the superconducting state. The kinetic inductance scales linearly with the nanowire length, with a typical value of 1 nH µm(-1) for NbN and 44 pH µm(-1) for Nb at a temperature of 2.5 K. We measure the temperature and current dependence of the kinetic inductance and compare our results to theoretical predictions. We also simulate the self-resonant frequencies of these nanowires in a compact meander geometry. These nanowire inductive elements have applications in a variety of microwave frequency superconducting circuits.

Reset dynamics and latching in niobium superconducting nanowire single-photon detectors

We study the reset dynamics of niobium(Nb)superconductingnanowire single-photon detectors (SNSPDs) using experimental measurements and numerical simulations. The numerical simulations of the detection dynamics agree well with experimental measurements, using independently determined parameters in the simulations. We find that if the photon-induced hotspot cools too slowly, the device will latch into a dc resistive state. To avoid latching, the time for the hotspot to cool must be short compared to the inductive time constant that governs the resetting of the current in the device after hotspot formation. From simulations of the energy relaxation process, we find that the hotspot cooling time is determined primarily by the temperature-dependent electron-phonon inelastic time. Latching prevents reset and precludes subsequent photon detection. Fast resetting to the superconducting state is, therefore, essential, and we demonstrate experimentally how this is achieved. We compare our results to studies of reset and latching in niobium nitride SNSPDs.

Niobium Superconducting Nanowire Single-Photon Detectors

We investigate the performance of superconducting nanowire photon detectors fabricated from ultra-thin Nb. A direct comparison is made between these detectors and similar nanowire detectors fabricated from NbN. We find that Nb detectors are significantly more susceptible than NbN to thermal instability (latching) at high bias. We show that the devices can be stabilized by reducing the input resistance of the readout. Nb detectors optimized in this way are shown to have approximately 2/3 the reset time of similar large-active-area NbN detectors of the same geometry, with approximately 6% detection efficiency for single photons at 470 nm.

Antenna-Coupled Niobium Bolometers for Terahertz Spectroscopy

We report characterizations of antenna-coupled hot electron bolometers designed for laboratory-based terahertz spectroscopy. These direct detectors combine sub-nanosecond response, high sensitivity, and the ability to operate below saturation when viewing a room temperature background. The optimum small-signal responsivity is 4.4 times 104 V/W, measured at a bath temperature Tb ap 0.9Tc. The corresponding saturation power is 7 nW. The saturation power increases and the small-signal responsivity decreases as the bath temperature is lowered. The measured noise equivalent power is 2.0 times 10-14 W/(Hz)frac12, near the predicted thermal fluctuation limit. The noise is white from approximately 100 Hz to 100 MHz.

Impedance-matched low-pass stripline filters

We have constructed several impedance-matched low-pass filters using a stripline geometry with a dissipative dielectric. The filters are compact, simple to construct, and operate in cryogenic environments. The dissipative dielectric consists of magnetically-loaded silicone or epoxy, which are commercially available under the trade name Eccosorb. For a stripline length of 32 mm, the filters have a passband that extends from dc to a 3 dB bandwidth between 0.3 and 0.8 GHz. The 3 dB bandwidth can be adjusted beyond this range by changing the filter length. An extremely broad stopband at higher frequencies, with attenuation exceeding 100 dB, is achieved along with a return loss greater than 10 dB measured up to 40 GHz. This combination of high attenuation and low reflected power across a broad stopband ensures that spurious or unwanted signals outside the passband do not reach or return to the device under test. This type of filter has applications in microwave frequency measurements of sensitive non-linear devices such as superconducting heterodyne mixers, quantum tunneling devices, and quantum computing elements.

Energy Loss of the Electron System in Individual Single-Walled Carbon Nanotubes

We characterize the energy loss of the nonequilibrium electron system in individual metallic single-walled carbon nanotubes at low temperature. Using Johnson noise thermometry, we demonstrate that, for a nanotube with Ohmic contacts, the dc resistance at finite bias current directly reflects the average electron temperature. This enables a straightforward determination of the thermal conductance associated with cooling of the nanotube electron system. In analyzing the temperature- and length-dependence of the thermal conductance, we consider contributions from acoustic phonon emission, optical phonon emission, and hot electron outdiffusion.

Terahertz detection mechanism and contact capacitance of individual metallic single-walled carbon nanotubes

We characterize the terahertz detection mechanism in antenna-coupled metallic single-walled carbon nanotubes. At low temperature, 4.2 K, a peak in the low-frequency differential resistance is observed at zero bias current due to non-Ohmic contacts. This electrical contact nonlinearity gives rise to the measured terahertz response. By modeling each nanotube contact as a nonlinear resistor in parallel with a capacitor, we determine an upper bound for the value of the contact capacitance that is smaller than previous experimental estimates. The small magnitude of this contact capacitance has favorable implications for the use of carbon nanotubes in high-frequency device applications.

Bolometric and nonbolometric radio frequency detection in a metallic single-walled carbon nanotube

We characterize radio frequency detection in a high-quality metallic single-walled carbon nanotube. At a bath temperature of 77 K, only bolometric (thermal) detection is seen. At a bath temperature of 4.2 K and low bias current, the response is due instead to the electrical nonlinearity of the non-Ohmic contacts. At higher bias currents, the contacts recover Ohmic behavior and the observed response agrees well with the calculated bolometric responsivity. The bolometric response is expected to operate at terahertz frequencies, and we discuss some of the practical issues associated with developing high frequency detectors based on carbon nanotubes.

Single-photon imager based on a superconducting nanowire delay line

Detecting spatial and temporal information of individual photons by using singlephoton-detector (SPD) arrays is critical to applications in spectroscopy, communication, biological imaging, astronomical observation, and quantum-information processing. Among the current SPDs, detectors based on superconducting nanowires have outstanding performance, but are limited in their ability to be integrated into large scale arrays due to the engineering difficulty of high-bandwidth cryogenic electronic readout. Here, we address this problem by demonstrating a scalable single-photon imager using a single continuous photon-sensitive superconducting nanowire microwave-plasmon transmission line. By appropriately designing the nanowire’s local electromagnetic environment so that the nanowire guides microwave plasmons, the propagating voltages signals generated by a photon-detection event were slowed down to ~ 2% of the speed of light. As a result, the time difference between arrivals of the signals at the two

Energy-resolved detection of single infrared photons with λ = 8 μm using a superconducting microbolometer

We report on the detection of single photons with λ = 8 μm using a superconducting hot-electron microbolometer. The sensing element is a titanium transition-edge sensor with a volume ∼0.1 μm3 fabricated on a silicon substrate. Poisson photon counting statistics including simultaneous detection of 3 photons was observed. The width of the photon-number peaks was 0.11 eV, 70% of the photon energy, at 50–100 mK. This achieved energy resolution is one of the best figures reported so far for superconducting devices. Such devices can be suitable for single-photon calorimetric spectroscopy throughout the mid-infrared and even the far-infrared.