J.L. Gómez-Ariza

Determination of polychlorinated biphenyls in biota samples using simultaneous pressurized liquid extraction and purification

In order to reduce time and cost of analysis, a new pressurised liquid extraction method that automatically and rapidly achieves quantitative and selective (i.e., lipid-free) extraction of polychlorinated biphenyls (PCBs) in biota tissues was optimized. It consists of on-line clean-up by inclusion of sorbents in the extraction cell. The freeze-dried sample is dispersed with Florisil and loaded in the extraction cell containing an extra amount of Florisil. The extraction is performed under mild conditions using 55 ml of a dichloromethane-pentane (15:85) mixture, a temperature of 40 degrees C, a static extraction time of 10 min and two extraction cycles. The Florisil retains coextracted lipids from the matrix, and the extract, after pre-concentration, is clean enough for direct injection into GC-MS and GC-electron-capture detection (ECD). Quantitative recoveries (from 90 to 106%) are obtained for both native and spiked PCB congeners in samples with a high lipidic content (up to 42% dry mass, in spoonbill eggs). The reproducibility of replicate extractions was better than 11% relative standard deviation. Method detection limits were in the ranges of 0.001-0.004 and 0.002-0.07 ng g(-1) dry mass for GC-ECD and GC-MS-MS, respectively. The method was validated using the standard reference material SRM 2974 (a mussel tissue) from the US National Institute of Standards and Technology, compared to Soxhlet and matrix solid-phase dispersion extraction methods, and used to evaluate the contamination by PCBs in bivalves from South of Spain.

Comparison of biota sample pretreatments for arsenicspeciation with coupled HPLC-HG-ICP-MS

Soxhlet extraction has been compared to sonication and microwave assisted extraction of arsenite, arsenate, dimethylarsenic, monomethylarsenic and arsenobetaine from biota samples (oyster, cockle, mussel and fresh water alga) and Certified Reference Materials TORT-1 and CRM 627, using methanol and methanol–water mixtures. A clean-up procedure using hexane partitioning was compared to the use of 0.45 μm filter membranes, ultrafiltration (10 kDa) and C-18 cartridges. Measurements were carried out using coupled HPLC-(UV)-HG-ICP-MS. The best results were obtained for Soxhlet extraction (150 ml of a (1∶1) methanol–water mixture for 16 h) compared to both sonication (20 ml of methanol or methanol–water mixtures (1∶3), (1∶1) and (3∶1) during 20 min) and microwave (20 ml of methanol or methanol–water mixtures (1∶3), (1∶1) and (3∶1) during 10 min at 150 W). Hexane partitioning was found to be superior to the other clean-up procedures. Recoveries higher than 71% were obtained depending on the type of sample. An unknown compound was found to be the main arsenic species in the marine samples.

Evaluation of atomic fluorescence spectrometry as a sensitive detection technique for arsenic speciation

The potential of coupling anion-exchange high-performance liquid chromatography, hydride generation and atomic fluorescence spectrometry (HPLC–HG–AFS) for arsenic speciation is considered. The effects of hydrochloric acid and sodium tetrahydroborate concentrations on signal-to-background ratio, as well as argon and hydrogen flow rates, were investigated. Detection limits for arsenite, dimethylarsinic acid (DMA), monomethylarsonic acid (MMA) and arsenate were 0.17, 0.45, 0.30 and 0.38 μg l−1, respectively, using a 20-μl loop. Linearity ranges were 0.1–500 ng for As(III) and MMA (as arsenic), and 0.1–800 ng for DMA and As(V) (as arsenic). Arsenobetaine (AsB) was also determined by introducing an on-line photo-oxidation step after the chromatographic separation. In this case the limits of detection and linear ranges for the different species studied were similar to the values obtained previously for As(V). The technique was tested with a human urine reference material and a volunteers sample.

Sample treatment in chromatography-based speciation of organometallic pollutants

Speciation analysis is nowadays performed routinely in many laboratories to control the quality of the environment, food and health. Chemical speciation analyses generally include the study of different oxidation state of elements or individual organometallic compounds. The determination of the different chemical forms of elements is still an analytical challenge, since they are often unstable and concentrations in different matrices of interest are in the microg l(-1) or even in the ng l(-1) range (e.g., estuarine waters) or ng g(-1) in sediments and biological tissues. For this reason, sensitive and selective analytical atomic techniques are being used as available detectors for speciation, generally coupled with chromatography for the time-resolved introduction of analytes into the atomic spectrometer. The complexity of these instrumental couplings has a straightforward consequence on the duration of the analysis, but sample preparation to separate and transfer the chemical species present in the sample into a solution to be accepted readily by a chromatographic column is the more critical step of total analysis, and demands considerable operator skills and time cost. Traditionally, liquid-liquid extraction has been employed for sample treatment with serious disadvantages, such as consumption, disposal and long-term exposure to organic solvent. In addition, they are usually cumbersome and time-consuming. Therefore, the introduction of new reagents such as sodium tetraethylborate for the simultaneous derivatization of several elements has been proposed. Other possibilities are based in the implementation of techniques for efficient and accelerated isolation of species from the sample matrix. This is the case for microwave-assisted extraction, solid-phase extraction and microextraction, supercritical fluid extraction or pressurized liquid extraction, which offer new possibilities in species treatment, and the advantages of a drastic reduction of the extraction time and the embodiment into on-line flow analysis systems. This new generation of treatment techniques constitutes a good choice as fast extraction methods for feasible species-selective analysis of organometallic compounds under the picogram level, that can be used for national regulatory agencies, governmental and industrial quality control laboratories, and consequently, for manufacturers of analytical instrumentation.

Comparative study of electrospray and photospray ionization sources coupled to quadrupole time-of-flight mass spectrometer for olive oil authentication

The use of fast and reliable analytical procedures for olive oil authentication is a priority demand due to its wide consumption and healthy benefits. Olive oil adulteration with other cheaper vegetable oils is a common practice that has to be detected and controlled. Rapid screening methods based on high resolution tandem mass spectrometry constitute today the option of choice due to sample handling simplicity and the elimination of the chromatographic step. The selection of the ionization source is critical and the comparison of their reliability necessary. The possibilities of the direct infusion electrospray ionization (ESI) and the recently introduced atmospheric pressure photospray ionization source (APPI), coupled to quadrupole time-of-flight (QqTOF), have been critically studied and compared to control olive oil adulteration. These techniques are very rapid (approximately 1min per sample) and have high discrimination power to elucidate key components in the edible oils studied (olive, hazelnut, sunflower and corn). Nevertheless, both sources are complementary, being APPI more sensitive for monoacyl- and diacylglycerol fragment ions and ESI for triacylglycerols. In addition, methods reproducibilitys are very high, especially for APPI source. Mixtures of olive oil with the others vegetable oils can be easily discriminated which has been tested by using principal components analysis (PCA) with both ESI-MS and APPI-MS spectra. Analogously, linear discriminant analysis (LDA) confirms methods reproducibility and detection of other oils used as adulterants, in particular hazelnut oil, which is especially difficult given its chemical similarity with olive oil.

Metabolomic study of lipids in serum for biomarker discovery in Alzheimer's disease using direct infusion mass spectrometry

In this study, we demonstrated the potential of direct infusion mass spectrometry for the lipidomic characterization of Alzheimers disease. Serum samples were extracted for lipids recovery, and directly analyzed using an electrospray source. Metabolomic fingerprints were subjected to multivariate analysis in order to discriminate between groups of patients and healthy controls, and then some key-compounds were identified as possible markers of Alzheimers disease. Major differences were found in lipids, although some low molecular weight metabolites also showed significant changes. Thus, important metabolic pathways involved in neurodegeneration could be studied on the basis of these perturbations, such as membrane breakdown (phospholipids and diacylglycerols), oxidative stress (prostaglandins, imidazole and histidine), alterations in neurotransmission systems (oleamide and putrescine) and hyperammonaemia (guanidine and arginine). Moreover, it is noteworthy that some of these potential biomarkers have not been previously described for Alzheimers disease.

Simultaneous analysis of mercury and selenium species including chiral forms of selenomethionine in human urine and serum by HPLC column-switching coupled to ICP-MS

The simultaneous speciation of elements is of great concern, especially in the study of the interactions of species in living organisms. Here we report a method based on the coupling of HPLC-ICP-MS that is capable of separating and analyzing different selenium and mercury species (Se-methylselenocysteine, selenite, selenate, L-selenomethionine, D-selenomethionine, methylmercury and inorganic mercury). The proposed method uses two different mobile phases that are suitable for selenium and mercury speciation and leads to a successful determination of all the species in less than 27 min with good efficiency and resolution. The method was efficiently applied for simultaneous speciation of mercury and selenium in urine and in serum, the latter from umbilical cord samples. Selenocystine has been successfully identified in the former sample. Detection limits obtained were between 0.30 and 2.46 ng. Recovery studies of samples spiked with all species were performed to check the reliability of the method, and satisfactory recoveries (93-110%) were obtained in all cases. The relative standard deviations (RSDs) for species with ten replicate determinations of 80 μg L(-1) were between 4.5 and 9.2%. The proposed method offers a deeper insight into selenium and mercury interactions in the human body.

Spatial distribution of butyltin and phenyltin compounds on the Huelva Coast (Southwest Spain)

Six organotin species -tributyltin (TBT), dibutyltin (DBT), monobutyltin (MBT), triphenyltin (TPT), diphenyltin (DPT) and monophenyltin (MPT)- have been determined in seawater and sediments collected from some representative enclosed areas of the southwest Spain. No phenyltin species were found in waters showing the absence of recent inputs of these species. However, butyltin species were present in all the stations along the Huelva coast. The highest TBT levels were found in sediments (up to 195 ng g−1 as Sn, dry weight basis) and seawater (up to 100 ng L−1) in harbours and marinas, closely related with boating activity and decreasing according to the distance from the potential sources. Results make possible to establish conclusions about the critical ecological consequences of organotin presence in this area, where shell-fish farms, fishery activity and migrating birds might be at risk. Different TBT degradation rates were found in sediments collected in winter (Cadiz coast) and in summer (Huelva coast).

Simultaneous speciation and preconcentration of ultra trace concentrations of mercury and selenium species in environmental and biological samples by hollow fiber liquid phase microextraction prior to high performance liquid chromatography coupled to inductively coupled plasma mass spectrometry

Nowadays, hollow fiber membrane extraction techniques are widely used due to the high enrichment factors obtained with many different types of analytes and samples. In this paper, we propose a new analytical method that allows the simultaneous extraction of methylmercury, inorganic mercury and Se(4+) and determination by high performance liquid chromatography coupled to inductively coupled plasma mass spectrometry (HPLC-ICP-MS). The detection limits obtained are very low (110-230ng/L) with relative standard deviations below 15% for all the analytes and averaged recoveries in fortified samples in the range of 71-99%. The precision of the analytical method is very good which overcomes one of the most important shortcomings of membrane extraction techniques. Several variables were studied to get optimal extraction conditions for the analytes. This method has been validated with real world samples such as water (tap, river and estuarine) and human blood plasma.

Determination of an arsenosugar in oyster extracts by liquid chromatography-electrospray mass spectrometry and liquid chromatography-ultraviolet photo-oxidation-hydride generation atomic fluorescence spectrometry

HPLC-UV-HG-AFS analysis of aqueous extracts of oysters (Crassostrea gigas) taken from the southwestern Atlantic coast of Spain showed the presence of arsenite, arsenate, dimethylarsinic acid and an unidentified arsenic peak. Subsequent analysis of the oyster samples by LC-electrospray MS and comparison with four standard dimethylarsinoylribosides (arsenosugars), showed that the previously unidentified peak was an arsenosugar (arsenosugar 2). When the arsenosugar in the oyster was quantified using the two detection methods and external calibration with standard arsenosugar, there was a large discrepancy between the two sets of results. The LC-MS analysis was strongly affected by the sample matrix and gave concentrations 50% lower than those obtained by AFS detection. When the method of standard addition was applied to the LC-MS analysis, the results were comparable to the AFS data. The matrix effects were eliminated by subjecting the extract to a clean-up procedure with anion-exchange and gel permeation preparative chromatography before the LC-MS analysis. The arsenosugars gave a small signal without photo-oxidation when they were analysed by HPLC-HG-AFS. Possibly this resulted from partial decomposition of the arsenosugar to dimethylarsinic acid under the acidic conditions employed in the hydride generation step.