Jean-Stéphane Pic

Adsorption of Organic Pollutants from Water on High Silica Zeolites and Regeneration by Ozone

Abstract This work investigates the removal of nitrobenzene (NB), a model pollutant from water, by combining adsorption onto zeolites and regeneration with ozone. The adsorption equilibrium isotherms of NB onto zeolites enabled the best adsorbent to be selected and zeolites with a high Si/Al ratio were the most efficient. The adsorption capacity depended on the Si/Al ratio and on the pore size. In a sequential process coupling adsorption and oxidation by ozone, NB was completely removed from water and the initial adsorption capacity of the zeolite was totally restored. Although no catalytic effect was noticed, the adsorption produced locally high concentrations, thus enhancing the oxidation rate for NB.

Determination of struvite crystallization mechanisms in urine using turbidity measurement

Sanitation improvement in developing countries could be achieved through wastewater treatment processes. Nowadays alternative concepts such as urine separate collection are being developed. These processes would be an efficient way to reduce pollution of wastewater while recovering nutrients, especially phosphorus, which are lost in current wastewater treatment methods. The precipitation of struvite (MgNH(4)PO(4)∙6H(2)O) from urine is an efficient process yielding more than 98% phosphorus recovery with very high reaction rates. The work presented here aims to determine the kinetics and mechanisms of struvite precipitation in order to supply data for the design of efficient urine treatment processes. A methodology coupling the resolution of the population balance equation to turbidity measurement was developed, and batch experiments with synthetic and real urine were performed. The main mechanisms of struvite crystallization were identified as crystal growth and nucleation. A satisfactory approximation of the volumetric crystal size distribution was obtained. The study has shown the low influence on the crystallization process of natural organic matter contained in real urine. It has also highlighted the impact of operational parameters. Mixing conditions can create segregation and attrition which influence the nucleation rate, resulting in a change in crystals number, size, and thus final crystal size distribution (CSD). Moreover urine storage conditions can impact urea hydrolysis and lead to spontaneous struvite precipitation in the stock solution also influencing the final CSD. A few limits of the applied methodology and of the proposed modelling, due to these phenomena and to the turbidity measurement, are also discussed.

Removal of volatile organic compounds by heterogeneous ozonation on microporous synthetic alumina silicate

A hybrid process combining adsorption and ozonation was examined as an alternative treatment for odorous volatile organic compounds (VOCs). Methyl ethyl ketone (MEK) was chosen to study the influence of operating parameters. Two synthetic aluminosilicates (faujasite-Y and ZSM-5) were tested for adsorption and reactivity with ozone. The adsorption equilibrium measurement on both adsorbents showed that adsorption performance depends on temperature but is not sensitive to relative humidity, due to the hydrophobic properties of the materials. Adsorbed VOCs were oxidized at low temperature when ozonated flow was sent to the reactor. Regeneration of the fixed bed was achieved at the same time, releasing mainly CO(2) and H(2)O. Intermediates of oxidation, such as 2,3-butanedione and acetic acid, were identified, leading to incomplete mineralization. The influence of concentration and humidity are discussed. Four successive cycles were tested: after the first adsorption/ozonation cycle, the adsorption efficiency was not affected during subsequent cycles. These results show that the same sample of adsorbent can be used in the treatment process for a long time. Ozonation regeneration is a promising process for VOC removal.

Enhanced bio-recalcitrant organics removal by combined adsorption and ozonation

Removal of bio-recalcitrant and toxic compounds from wastewaters has been a major objective of industrial manufacturers for a few years. Due to the potential risk toward public health, regulations are becoming increasingly strict and classical treatments like biological treatments are not efficient. Other techniques such as incineration, oxidation or adsorption provide higher levels of removal but with a high energy and capital cost. A coupled process involving adsorption and oxidation is studied. Four adsorbents are tested and compared according to two objectives, their adsorption capacity and their capability to decompose ozone into powerful hydroxyl radicals. Two model compounds were chosen: 2,4-dichlorophenol and nitrobenzene. Experimental results allow comparing coupled process with results obtained during ozonation alone. Zeolite (Faujasite Y) gave disappointing results in term of both adsorption kinetics and ozone decomposition. On the contrary, activated carbons showed fast adsorptions and important capabilites to decompose ozone into radicals, almost in nitrobenzene experiments. S-23 activated carbon proved to be the most interesting adsorbent for better mechanical and chemical stabilities over time. Sequential adsorption/ozonation experiments were conducted, showing a strong loss of adsorption efficiency after the first operation, but the positive point is that the adsorption capacity remains almost constant during further cycles.

Comparison of Activated Carbon and Hydrophobic Zeolite Efficiencies in 2,4-Dichlorophenol Advanced Ozonation

This study aims at comparing the removal of 2,4-dichlorophenol (2,4-DCP) by 3 methods; adsorption using hydrophobic zeolite (faujasite) or activated carbon (S-23 and L-27), conventional ozonation and hybrid adsorption/ozonation treatment. On the one hand, the three materials correctly adsorb 2,4-DCP; however the adsorption kinetics using zeolite is very low. On the other hand, ozonation totally removes 2,4-DCP after 1 h experiment and the simultaneous combination of adsorbent and ozone does not change the 2,4-DCP degradation. But, though ozonation and hybrid process appear to be equivalent for 2,4-DCP removal, activated carbons are able to decompose ozone and to improve chemical oxygen demand (COD) removal, whereas the zeolite does not show this catalytic effect. Similar results were also observed in a former study with nitrobenzene. Adsorbent degradation is evaluated by Brunauer, Emmet and Teller (BET) and differential thermogravimetric (DTG) analysis, which evidence that Faujasite and S-23 activated carbon are resistant to ozone exposure whereas the pore volume and the surface area of L-27 activated carbon decrease during ozonation.

Combined Ozonation Using Alumino-Silica Materials for the Removal of 2,4-Dimethylphenol from Water

This study deals with an advanced oxidation process combining adsorption and ozonation for treating petrochemical effluents. The compound 2,4-dimethylphenol (DMP) was the paradigm molecule and faujasite-Y, mordenite, ZSM-5 and γ-alumina were tested. Single ozonation showed rapid DMP degradation but limited by gas to liquid ozone transfer. No catalytic effect occurred during ozonation combined with any of the adsorbents: DMP removal was not accelerated. However, a good synergistic effect was observed for TOC removal with γ-alumina, yet the various zeolites are less efficient. Some specific oxidation by-products produced during ozonation are eliminated by adsorption in the presence of γ-alumina, although they persist in the other cases.

Urban Wastewater Treatment by Catalytic Ozonation

ABSTRACT This study focuses on the catalytic ozonation of organic matter recalcitrant to usual water treatment technologies. Experiments aimed to investigate the efficiency of the process TOCCATA®, which uses a granular catalyst coupled with ozonation. Comparison was made between single ozonation, single adsorption onto the catalyst and catalytic ozonation. Adsorption was proven to contribute to decreased dissolved organic carbon. Catalytic ozonation enhanced organic matter removal and ozone transfer compared to single ozonation. Catalytic ozonation was modeled with global apparent first-order kinetics and single adsorption with pseudo–second-order sorption kinetics.

Oxidation of nitrobenzene by ozone in the presence of faujasite zeolite in a continuous flow gas-liquid-solid reactor.

This work investigates the oxidation of nitrobenzene (NB) by ozone in the presence of faujasite zeolite. Experiments were carried out in a gas-liquid-solid reactor were ozone transfer and NB oxidation took place at the same time. Three configurations of the reactor were compared: empty, filled with inert glass beads and filled with faujasite pellets. First, ozone transfer coefficient (k(L)a) and decomposition rate constant (k(C)) were determined for each configuration. In presence of solid, k(L)a was 2.0 to 2.6 times higher and k(C) was 5.0 to 6.4 times higher compared to the empty reactor. Then, the various configurations were evaluated in terms of NB removal and chemical oxygen demand (COD) decrease. The faujasite reactor showed higher removal of NB and decrease of COD compared to other configurations under the same conditions suggesting that the faujasite increases the oxidation rate of NB. Oxidation of NB in presence of faujasite also proved to be limited by the transfer of ozone from the gas to the liquid phase.

Fixed-bed adsorption of toluene on high silica zeolites: experiments and mathematical modelling using LDF approximation and a multisite model.

The adsorption of toluene (TOL) as a target volatile organic compound has been studied experimentally and modelled on various hydrophobic zeolites: Faujasite (FAU), ZSM-5 (Z) and Mordenite (MOR). The influence of the nature of the compensating cation (H+ or Na+) has also been investigated for ZSM-5 zeolite, which is known to possess three kinds of adsorption sites (sinusoidal channels, straight channels and intersections). Type I isotherms observed on FAU, Na-Z and MOR fitted well with the Langmuir model. A deviation from a type I isotherm was observed for H-Z, because of the structure of this zeolite. The Successive Langmuir Model was more successful to fit the ‘bump’ of the experimental curve than the Double Langmuir. Classical shapes were found for MOR, FAU and Na-Z breakthrough curves that were fitted with good accuracy using the Linear Driving Force (LDF) approximation. In the case of H-Z, a change of profile was observed during the dynamic adsorption and the differences seen between the Na-Z and H-Z behaviours were explained by the strong interactions between Na+ and adsorbed TOL at the intersection sites. The Na+ cations prevented reorientation of TOL molecules at the intersection and thereby avoided the filling of the sinusoidal channel segments. Thus, a specific model was developed for fitting the breakthrough curve of H-Z. The model developed took into account these two types of adsorption sites with the overall uptake for each site being given by an LDF approximation.

Transformation characteristics of organic pollutants in Fered-Fenton process for dry-spun acrylic fiber wastewater treatment.

The Fered-Fenton process using Ti sheet as cathode and RuO2/Ti as anode was employed for the pretreatment of dry-spun acrylic fiber manufacturing wastewater. The effects of feeding mode and concentration of H2O2 on chemical oxygen demand (COD) removal efficiency as well as the biodegradability variation during the Fered-Fenton process were investigated. The feeding mode of H2O2 had significant influence on COD removal efficiency: the removal efficiency was 44.8% if all the 60.0 mM H2O2 was fed at once, while it could reach 54.1% if the total H2O2 was divided into six portions and fed six times. The biochemical oxygen demand/COD ratio increased from 0.29 to above 0.68 after 180 min treatment. The transformation characteristics of organic pollutants during the Fered-Fenton process were evaluated by using gas chromatography-mass spectrometry (GC-MS), Fourier transform infrared spectroscopy (FTIR) and fluorescence excitation-emission matrix (EEM) spectroscopy. Most of the refractory organic pollutants with aromatic structure or large molecular weight were decomposed during the Fered-Fenton process.