L. Solier

Tracking of Airborne Radionuclides from the Damaged Fukushima Dai-Ichi Nuclear Reactors by European Networks

Radioactive emissions into the atmosphere from the damaged reactors of the Fukushima Dai-ichi nuclear power plant (NPP) started on March 12th, 2011. Among the various radionuclides released, iodine-131 ((131)I) and cesium isotopes ((137)Cs and (134)Cs) were transported across the Pacific toward the North American continent and reached Europe despite dispersion and washout along the route of the contaminated air masses. In Europe, the first signs of the releases were detected 7 days later while the first peak of activity level was observed between March 28th and March 30th. Time variations over a 20-day period and spatial variations across more than 150 sampling locations in Europe made it possible to characterize the contaminated air masses. After the Chernobyl accident, only a few measurements of the gaseous (131)I fraction were conducted compared to the number of measurements for the particulate fraction. Several studies had already pointed out the importance of the gaseous (131)I and the large underestimation of the total (131)I airborne activity level, and subsequent calculations of inhalation dose, if neglected. The measurements made across Europe following the releases from the Fukushima NPP reactors have provided a significant amount of new data on the ratio of the gaseous (131)I fraction to total (131)I, both on a spatial scale and its temporal variation. It can be pointed out that during the Fukushima event, the (134)Cs to (137)Cs ratio proved to be different from that observed after the Chernobyl accident. The data set provided in this paper is the most comprehensive survey of the main relevant airborne radionuclides from the Fukushima reactors, measured across Europe. A rough estimate of the total (131)I inventory that has passed over Europe during this period was <1% of the released amount. According to the measurements, airborne activity levels remain of no concern for public health in Europe.

Transfer of tritium released into the marine environment by French nuclear facilities bordering the English Channel.

Controlled amounts of liquid tritium are discharged as tritiated water (HTO) by the nuclear industry into the English Channel. Because the isotopic discrimination between 3H and H is small, organically bound tritium (OBT) and HTO should show the same T/H ratio under steady-state conditions. We report data collected from the environment in the English Channel. Tritium concentrations measured in seawater HTO, as well as in biota HTO and OBT, confirm that tritium transfers from HTO to OBT result in conservation of the T/H ratio (ca. 1 × 10(-16)). The kinetics of the turnover of tritium between seawater HTO, biota HTO, and OBT was investigated. HTO in two algae and a mollusk is shown to exchange rapidly with seawater HTO. However, the overall tritium turnover between HTO and the whole-organism OBT is a slow process with a tritium biological half-life on the order of months. Nonsteady-state conditions exist where there are sharp changes in seawater HTO. As a consequence, for kinetic reasons, the T/H ratio in OBT may deviate transiently from that observed in HTO of samples from the marine ecosystem. Dynamic modeling is thus more realistic for predicting tritium transfers to biota OBT under nonsteady-state conditions.

A study of the atmospheric dispersion of a high release of krypton-85 above a complex coastal terrain, comparison with the predictions of Gaussian models (Briggs, Doury, ADMS4)

Atmospheric releases of krypton-85, from the nuclear fuel reprocessing plant at the AREVA NC facility at La Hague (France), were used to test Gaussian models of dispersion. In 2001-2002, the French Institute for Radiological Protection and Nuclear Safety (IRSN) studied the atmospheric dispersion of 15 releases, using krypton-85 as a tracer for plumes emitted from two 100-m-high stacks. Krypton-85 is a chemically inert radionuclide. Krypton-85 air concentration measurements were performed on the ground in the downwind direction, at distances between 0.36 and 3.3 km from the release, by neutral or slightly unstable atmospheric conditions. The standard deviation for the horizontal dispersion of the plume and the Atmospheric Transfer Coefficient (ATC) were determined from these measurements. The experimental results were compared with calculations using first generation (Doury, Briggs) and second generation (ADMS 4.0) Gaussian models. The ADMS 4.0 model was used in two configurations; one takes account of the effect of the built-up area, and the other the effect of the roughness of the surface on the plume dispersion. Only the Briggs model correctly reproduced the measured values for the width of the plume, whereas the ADMS 4.0 model overestimated it and the Doury model underestimated it. The agreement of the models with measured values of the ATC varied according to distance from the release point. For distances less than 2 km from the release point, the ADMS 4.0 model achieved the best agreement between model and measurement; beyond this distance, the best agreement was achieved by the Briggs and Doury models.

The VATO project: An original methodology to study the transfer of tritium as HT and HTO in grassland ecosystem

Tritium (3H) is mainly released into the environment by nuclear power plants, military nuclear facilities and nuclear reprocessing plants. The construction of new nuclear facilities in the world as well as the evolution of nuclear fuel management might lead to an increase of 3H discharges from the nuclear industry. The VATO project was set up by IRSN (Institut de Radioprotection et de Sûreté Nucléaire) and EDF (Electricité de France) to reduce the uncertainties in the knowledge about transfers of 3H from an atmospheric source (currently releasing HT and HTO) to a grassland ecosystem. A fully instrumented technical platform with specifically designed materials was set up downwind of the AREVA NC La Hague reprocessing plant (Northwest of the France). This study, started in 2013, was conducted in four main steps to provide an hourly data set of 3H concentrations in the environment, adequate to develop and/or validate transfer models. It consisted first in characterizing the physico-chemical forms of 3H present in the air around the plant. Then, 3H transfer kinetics to grass were quantified regarding contributions from various compartments of the environment. For this purpose, an original experimental procedure was provided to take account for biases due to rehydration of freeze-dried samples for the determination of OBT activity concentrations in biological samples. In a third step, the 3H concentrations measured in the air and in rainwater were reconstructed at hourly intervals. Finally, a data processing technique was used to determine the biological half-lives of OBT in grass.

Solid partitioning and solid-liquid distribution of 210Po and 210Pb in marine anoxic sediments: roads of Cherbourg at the northwestern France

A sequential extraction protocol has been used to determine the solid-phase partition of (210)Po and (210)Pb in anoxic marine sediment from the roads of Cherbourg (France) in the central English Channel. Measurements were also obtained in pore waters, in which (210)Po activities range between 1 and 20 mBq L(-1) and (210)Pb activities between 2.4 and 3.8 mBq L(-1), with highest activities in the topmost layer. These activities are higher than in seawater, suggesting that sediment act as a source of both (210)Po and (210)Pb for overlying water. The (210)Po profile in the pore waters is apparently correlated with those obtained for Fe, Mn and SO(4)(2)(-), suggesting an influence of early diagenetic processes on the (210)Po solid-liquid distribution. In the sediment, (210)Po is predominantly bound to organic matter or chromium reducible sulphides, and residuals (clay minerals and refractory oxides). Our results indicate that (210)Po is not significantly bound to AVS, i.e. acid volatile sulphides: bioturbation could play a role by the early redistribution of (210)Po bound to acid volatile sulphides in the sediment. (210)Po, (210)Pb and Pb exhibit differences in terms of distribution, probably due to a different mode of penetration in the sediment. This work provides information on solid and liquid distribution of (210)Po and (210)Pb in marine sediment. These data are very scarce in the literature.

In situ measurements of tritium evapotranspiration (3H-ET) flux over grass and soil using the gradient and eddy covariance experimental methods and the FAO-56 model

The behaviour of tritium in the environment is linked to the water cycle. We compare three methods of calculating the tritium evapotranspiration flux from grassland cover. The gradient and eddy covariance methods, together with a method based on the theoretical Penmann-Monteith model were tested in a study carried out in 2013 in an environment characterised by high levels of tritium activity. The results show that each of the three methods gave similar results. The various constraints applying to each method are discussed. The results show a tritium evapotranspiration flux of around 15 mBq m(-2) s(-1) in this environment. These results will be used to improve the entry parameters for the general models of tritium transfers in the environment.

Dating of sediment record at two contrasting sites of the Seine River using radioactivity data and hydrological time series

Sediment cores were collected at the outlet of the highly anthropogenized catchment of the Seine River at two contrasting sites: a flood plain of the lower Seine River and a quasi-permanently submerged harbour basin (or wet dock) in the upper tidal estuary. Analyses of artificial radionuclides ((137)Cs and plutonium isotopes), coupled with hydrological and bathymetric data, lead to a precise dating of the sediment cores collected at the two sites. (137)Cs signals originating from global fallout (early 1960s) and from the Chernobyl accident (1986) are identified, but at different levels due to the incomplete nature or variable continuity of the records. Anomalous (238)Pu concentrations found at both sites (1-2 Bq kg(-1)) are attributed to unknown industrial releases originating from upstream. Interpolating (137)Cs sediment activities under the assumption of a constant sediment rate, those releases were dated back to 1975 ± 1, thus providing a local but reliable time-marker. Age models have highlighted a very contrasting sediment filling dynamics in these two sites. This study presents the first sediment record of alpha- and gamma-emitting artificial radionuclides obtained at the outlet of the huge catchment area of the River Seine, over a period covering the last 50 years.

Water to atmosphere fluxes of 131I in relation with alkyl-iodide compounds from the Seine Estuary (France)

This study presents an original work on measurements of stable and radioactive iodinated species in the Seine estuary (France), with estimates fluxes of volatile gaseous species from water to the atmosphere. Various iodinated compounds were identified in water and air in particular 131I in water, what is unusual. Concentrations and behaviour of iodinated elements in the Seine estuary seem similar to what has been observed in other European estuaries. MeI (Methyl Iodide) and Total Volatile Iodine (TVI) fluxes from water to air vary between 392 and 13949 pmol m(-2) d(-1) and between 1279 and 16484 pmol m(-2) d(-1), respectively. Water to air flux of TVI for the Seine river was estimated in the range 4-46 kg y(-1). Measurements of (131)I in water varying between 0.4 and 11.9 Bq m(-3). Fluxes of (131)I from water to atmosphere are in the range 2.4 x 10(5)-1.3 x 10(7)Bq y(-1), close to an annual discharge of (131)I by a nuclear reactor.

In situ metrology of 85Kr plumes released by the COGEMA La Hague nuclear reprocessing plant

The IRSN (Institut de Radioprotection et de Sûreté Nucléaire, France) has started an in situ study of the behaviour of atmospheric releases close-by the COGEMA La Hague nuclear reprocessing plant. The study is designed to improve information on the dispersion of radioactive pollutants very close to the emission point--a 100 m height chimney. In this situation, close to the emission and height of the emission, Gaussian models generally used to predict the behaviour of atmospheric releases are not well adapted. The study is based on the characterisation of the 85Kr emitted during normal operations of the reprocessing process. Temporal and spatial variations of the plume shape were investigated with intensive in situ measurements. Live in situ techniques to measure the electrons and the photons emitted by the 85Kr have been implemented and will be described. Preliminary results showing the interest of the techniques were presented. Variations of the dose rates created by the photon flux of a plume were directly measured and correlated to other quantities.

Modeling And Validating Tritium Transfer In A Grassland Ecosystem In Response To 3H Release

In this paper a radioecological model for tritium transfer in a grassland ecosystem developed on an hourly time-step basis is proposed and compared with the first data set obtained in the vicinity of the AREVA NC reprocessing plant of La Hague (France).