Marie Magnusson

Biocrude yield and productivity from the hydrothermal liquefaction of marine and freshwater green macroalgae

Six species of marine and freshwater green macroalgae were cultivated in outdoor tanks and subsequently converted to biocrude through hydrothermal liquefaction (HTL) in a batch reactor. The influence of the biochemical composition of biomass on biocrude yield and composition was assessed. The freshwater macroalgae Oedogonium afforded the highest biocrude yield of all six species at 26.2%, dry weight (dw). Derbesia (19.7%dw) produced the highest biocrude yield for the marine species followed by Ulva (18.7%dw). In contrast to significantly different yields across species, the biocrudes elemental profiles were remarkably similar with higher heating values of 33-34MJkg(-1). Biocrude productivity was highest for marine Derbesia (2.4gm(-2)d(-1)) and Ulva (2.1gm(-2)d(-1)), and for freshwater Oedogonium (1.3gm(-2)d(-1)). These species were therefore identified as suitable feedstocks for scale-up and further HTL studies based on biocrude productivity, as a function of biomass productivity and the yield of biomass conversion to biocrude.

Comparative effects of herbicides on photosynthesis and growth of tropical estuarine microalgae

Pulse amplitude modulation (PAM) fluorometry is ideally suited to measure the sub-lethal impacts of photosystem II (PSII)-inhibiting herbicides on microalgae, but key relationships between effective quantum yield [Y(II)] and the traditional endpoints growth rate (micro) and biomass increase are unknown. The effects of three PSII-inhibiting herbicides; diuron, hexazinone and atrazine, were examined on two tropical benthic microalgae; Navicula sp. (Heterokontophyta) and Nephroselmis pyriformis (Chlorophyta). The relationships between Y(II), micro and biomass increase were consistent (r2 > or =0.90) and linear (1:1), validating the utility of PAM fluorometry as a rapid and reliable technique to measure sub-lethal toxicity thresholds of PSII-inhibiting herbicides in these microalgae. The order of toxicity (EC50 range) was: diuron (16-33 nM) > hexazinone (25-110 nM) > atrazine (130-620 nm) for both algal species. Growth rate and photosynthesis were affected at diuron concentrations that have been detected in coastal areas of the Great Barrier Reef.

Additive toxicity of herbicide mixtures and comparative sensitivity of tropical benthic microalgae

Natural waters often contain complex mixtures of unknown contaminants potentially posing a threat to marine communities through chemical interactions. Here, acute effects of the photosystem II-inhibiting herbicides diuron, tebuthiuron, atrazine, simazine, and hexazinone, herbicide breakdown products (desethyl-atrazine (DEA) and 3,4-dichloroaniline (3,4-DCA)) and binary mixtures, were investigated using three tropical benthic microalgae; Navicula sp. and Cylindrotheca closterium (Ochrophyta) and Nephroselmis pyriformis (Chlorophyta), and one standard test species, Phaeodactylum tricornutum (Ochrophyta), in a high-throughput Maxi-Imaging-PAM bioassay (Maxi-IPAM). The order of toxicity was; diuron > hexazinone > tebuthiuron > atrazine > simazine > DEA > 3,4-DCA for all species. The tropical green alga N. pyriformis was up to 10-fold more sensitive than the diatoms tested here and reported for coral symbionts, and is recommended as a standard tropical test species for future research. All binary mixtures exhibited additive toxicity, and the use of herbicide equivalents (HEq) is therefore recommended in order to incorporate total-maximum-load measures for environmental regulatory purposes.

Total lipid and fatty acid composition of seaweeds for the selection of species for oil‐based biofuel and bioproducts

We investigated the potential of seaweeds as feedstock for oil‐based products, and our results support macroalgae (seaweeds) as a biomass source for oil‐based bioproducts including biodiesel. Not only do several seaweeds have high total lipid content above 10% dry weight, but in the brown alga Spatoglossum macrodontum 50% of these lipids are in the form of extractable fatty acids. S. macrodontum had the highest fatty acid content (57.40 mg g−1 dw) and a fatty acid profile rich in saturated fatty acids with a high content of C18:1, which is suitable as a biofuel feedstock. Similarly, the green seaweed Derbesia tenuissima has high levels of fatty acids (39.58 mg g−1 dw), however, with a high proportion of PUFA (n‐3) (31% of total lipid) which are suitable as nutraceuticals or fish oil replacements. Across all species of algae the critical parameter of fatty acid content (measured as fatty acid methyl esters, FAME) was positively correlated (R2 = 0.67) with total lipid content. However, the proportion of fatty acids to total lipid decreased markedly with total lipid content, generally between 30% and 50%, making it an inaccurate measure of the potential to identify seaweeds suitable for oil‐based bioproducts. Finally, we quantified within species variation of fatty acids across locations and sampling periods supporting either environmental effects on quantitative fatty acid profiles, or genotypes with specific quantitative fatty acid profiles, thereby opening the possibility to optimize the fatty acid content and quality for oil production through specific culture conditions and selective breeding.

Comparing the potential production and value of high-energy liquid fuels and protein from marine and freshwater macroalgae

The biomass production and biochemical properties of marine and freshwater species of green macroalgae (multicellular algae), cultivated in outdoor conditions, were evaluated to assess the potential conversion into high‐energy liquid biofuels, specifically biocrude and biodiesel and the value of these products. Biomass productivities were typically two times higher for marine macroalgae (8.5–11.9 g m−2 d−1, dry weight) than for freshwater macroalgae (3.4–5.1 g m−2 d−1, dry weight). The biochemical compositions of the species were also distinct, with higher ash content (25.5–36.6%) in marine macroalgae and higher calorific value (15.8–16.4 MJ kg−1) in freshwater macroalgae. Lipid content was highest for freshwater Oedogonium and marine Derbesia. Lipids are a critical organic component for biocrude production by hydrothermal liquefaction (HTL) and the theoretical biocrude yield was therefore highest for Oedogonium (17.7%, dry weight) and Derbesia (16.2%, dry weight). Theoretical biocrude yields were also higher than biodiesel yields for all species due to the conversion of the whole organic component of biomass, including the predominant carbohydrate fraction. However, all marine species had higher biomass productivities and therefore had higher projected biocrude productivities than freshwater species, up to 7.1 t of biocrude ha−1 yr−1 for Derbesia. The projected value of the six macroalgae was increased by 45–77% (up to US

Chronic herbicide exposures affect the sensitivity and community structure of tropical benthic microalgae

7700 ha−1 yr−1) through the extraction of protein prior to the conversion of the residual biomass to biocrude. This study highlights the importance of optimizing biomass productivities for high‐energy fuels and targeting additional coproducts to increase value.

Pesticide contamination and phytotoxicity of sediment interstitial water to tropical benthic microalgae

The effects of prolonged exposure to low concentrations of herbicides on tropical periphyton (biofilm) communities are largely unknown. Tropical estuarine biofilms established in microcosms were therefore exposed to diuron (photosystem-II-inhibitor) at 2-16μg L(-1) for 4 weeks. The biofilms, consisting of diatoms, filamentous brown algae and cyanobacteria, developed a tolerance to diuron during this period as measured by Phyto-PAM fluorometry. Microscopy and pigment analysis revealed that this decrease in sensitivity was accompanied by a shift in species composition towards communities dominated by diatoms. The combination of techniques enabled the first identification of pollution-induced community tolerance (PICT) in tropical estuarine periphyton in response to chronic herbicide exposures. Community composition changed compared to controls at environmentally relevant concentrations of 1.6μg L(-1), while development of PICT was evident at 6.5μg L(-1) diuron, with no recovery (over 2 weeks) in uncontaminated water, indicating chronic pollution induced shifts in community structure.

Salinity Tolerance of Picochlorum atomus and the Use of Salinity for Contamination Control by the Freshwater Cyanobacterium Pseudanabaena limnetica

Many organic compounds including some herbicides concentrate in sediment, thus it may be expected that interstitial waters contain higher concentrations of these contaminants than the water column. To estimate benthic microalgal exposure to pesticides, sediment and interstitial water sampled in the dry season from four major rivers in north Queensland, Australia, were analysed for these contaminants. Interstitial water extracts from the sediments were tested for acute phytotoxicity to benthic microalgae using PAM fluorometry and the results were compared with chemical analyses of the same water samples. A range of pesticides were detected in both sediment and interstitial waters from all sites, notably the herbicide diuron at concentrations ranging from 0.3 to 11 μg kg(-1) dry weight sediment, and up to 68 ng L(-1) in interstitial waters. Herbicide concentrations estimated from partition coefficients and the sediment concentrations typically overestimated analytically determined concentrations present in interstitial water by an order of magnitude. The analytically determined herbicide concentrations in the interstitial water explained most of the phytotoxicity measured with the bioassay; however, photoinhibition was slightly higher than expected based on analytical results, indicating the presence of unidentified phytotoxins. These results demonstrate the presence of pesticides in interstitial waters in the Tropical dry season, sometimes at concentrations that may affect sensitive benthic organisms, and supports the use of the I-PAM bioassay as a valuable tool in exposure- and environmental risk- and impact-assessments.

Effects of marine and freshwater macroalgae on in vitro total gas and methane production.

Microalgae are ideal candidates for waste-gas and –water remediation. However, salinity often varies between different sites. A cosmopolitan microalga with large salinity tolerance and consistent biochemical profiles would be ideal for standardised cultivation across various remediation sites. The aims of this study were to determine the effects of salinity on Picochlorum atomus growth, biomass productivity, nutrient uptake and biochemical profiles. To determine if target end-products could be manipulated, the effects of 4-day nutrient limitation were also determined. Culture salinity had no effect on growth, biomass productivity, phosphate, nitrate and total nitrogen uptake at 2, 8, 18, 28 and 36 ppt. 11 ppt, however, initiated a significantly higher total nitrogen uptake. While salinity had only minor effects on biochemical composition, nutrient depletion was a major driver for changes in biomass quality, leading to significant increases in total lipid, fatty acid and carbohydrate quantities. Fatty acid composition was also significantly affected by nutrient depletion, with an increased proportion of saturated and mono-unsaturated fatty acids. Having established that P. atomus is a euryhaline microalga, the effects of culture salinity on the development of the freshwater cyanobacterial contaminant Pseudanabaena limnetica were determined. Salinity at 28 and 36 ppt significantly inhibited establishment of P. limnetica in P. atomus cultures. In conclusion, P. atomus can be deployed for bioremediation at sites with highly variable salinities without effects on end-product potential. Nutrient status critically affected biochemical profiles – an important consideration for end-product development by microalgal industries. 28 and 36 ppt slow the establishment of the freshwater cyanobacterium P. limnetica, allowing for harvest of low contaminant containing biomass.

From macroalgae to liquid fuel via waste-water remediation, hydrothermal upgrading, carbon dioxide hydrogenation and hydrotreating

This study aimed to evaluate the effects of twenty species of tropical macroalgae on in vitro fermentation parameters, total gas production (TGP) and methane (CH4) production when incubated in rumen fluid from cattle fed a low quality roughage diet. Primary biochemical parameters of macroalgae were characterized and included proximate, elemental, and fatty acid (FAME) analysis. Macroalgae and the control, decorticated cottonseed meal (DCS), were incubated in vitro for 72 h, where gas production was continuously monitored. Post-fermentation parameters, including CH4 production, pH, ammonia, apparent organic matter degradability (OMd), and volatile fatty acid (VFA) concentrations were measured. All species of macroalgae had lower TGP and CH4 production than DCS. Dictyota and Asparagopsis had the strongest effects, inhibiting TGP by 53.2% and 61.8%, and CH4 production by 92.2% and 98.9% after 72 h, respectively. Both species also resulted in the lowest total VFA concentration, and the highest molar concentration of propionate among all species analysed, indicating that anaerobic fermentation was affected. Overall, there were no strong relationships between TGP or CH4 production and the >70 biochemical parameters analysed. However, zinc concentrations >0.10 g.kg−1 may potentially interact with other biochemical components to influence TGP and CH4 production. The lack of relationship between the primary biochemistry of species and gas parameters suggests that significant decreases in TGP and CH4 production are associated with secondary metabolites produced by effective macroalgae. The most effective species, Asparagopsis, offers the most promising alternative for mitigation of enteric CH4 emissions.