Masahiro Furuno

Monolithic silica column for in-tube solid-phase microextraction coupled to high-performance liquid chromatography.

In-tube solid-phase microextraction (SPME) has successfully been coupled to capillary LC, and further an automated in-tube SPME system has been developed using a commercially available HPLC auto-sampler. However, an open tubular capillary column with a thick film of polymer (stationary phase) is unfavorable because the ratio of the surface area of coating layer contacted with sample solution to the volume of the capillary column is insufficient for mass transfer. A highly efficient SPME column is. therefore, required. We introduced a C18-bonded monolithic capillary column that was used for in-tube SPME. The column consisted of continuous porous silica having a double-pore structure. Both the through-pore and the meso-pore were optimized for in-tube SPME, and the optimized capillary column was connected to an HPLC injection valve for characterization. The results demonstrated that the pre-concentration efficiency is excellent compared with the conventional in-tube SPME. The novel method for both introduction and concentration of the samples was effective. satisfactory and suitable for use in the SPME medium.

On-line coupling of solid-phase extraction to gas chromatography with fast solvent vaporization and concentration in an open injector liner: Analysis of pesticides in aqueous samples

The purpose of this study is to combine solid-phase extraction (SPE) with gas chromatography (GC) for the fully automated determination of pesticides and herbicides in aqueous samples. The interface technique employed for connecting SPE with GC was fast solvent vaporization and concentration in an open injector liner. The interface device consisted of the programmed-temperature vaporizing injector without using the packing material in the liner and the target compounds were concentrated around the inlet of the GC capillary column. This avoided the degradation of target compounds, and no precise control of the injecting speed was required, when an automatic SPE system was connected to GC-MS. The aqueous samples used in this system were prepared by spiking 29 kinds of pesticide and herbicide compounds, which are regulated by the Ministry of Health and Welfare of the Japanese National government, in purified water and river water, to a resulting concentration of 1 microg/l. Employing this system, the recoveries and RSDs (n=6) of most compounds were greater than 75% and within 10%, respectively. From the results of this study, we found that on-line automatic SPE and capillary GC-MS equipped with the fast solvent vaporizing and concentrating method in an open injector liner could be connected in order to obtain good results for the determination of pesticides in water samples.

Semi-micro-monolithic columns using macroporous silica rods with improved performance.

Monolithic silica columns in semi-micro-format have been synthesized using poly(acrylic acid) as a phase-separation inducer via a sol-gel route. The absence of a thick skin layer accompanied by deformation of the micrometer-sized gelling skeletons on the outermost part of the macroporous silica rod contributed to improve the efficiency of monolithic silica columns as thick as 2.4 mm in diameter. The kinetic plot analysis revealed that monolithic silica columns with macropore diameter of 1 microm and skeleton thickness of 1 microm with decreased macroporosity behave similarly to columns packed with 3 microm particles with slightly lower back pressure.

Efficiency of short, small-diameter columns for reversed-phase liquid chromatography under practical operating conditions

Prototype small-size (1.0mm I.D., 5cm long) columns for reversed-phase HPLC were evaluated in relation to instrument requirements. The performance of three types of columns, monolithic silica and particulate silica (2μm, totally porous and 2.6μm, core-shell particles) was studied in the presence of considerable or minimal extra-column effects, while the detector contribution to band broadening was minimized by employing a small size UV-detector cell (6- or 90nL). A micro-LC instrument having small system volume (<1μL) provided extra-column band variance of only 0.01-0.02μL(2). The three columns generated about 8500 theoretical plates for solutes with retention factor, k>1-3 (depending on the column), in acetonitrile/water mobile phase (65/35=vol/vol) at 0.05mL/min, with the instrument specified above. The column efficiency was lower by up to 30% than that observed with a 2.1mm I.D. commercial column. The small-size columns also provided 8000-8500 theoretical plates for well retained solutes with a commercial ultrahigh-pressure liquid chromatography (UHPLC) instrument when extra-column contributions were minimized. While a significant extra-column effect was observed for early eluting solutes (k<2-4, depending on column) with methanol/water (20/80=vol/vol) as weak-wash solvent, the use of methanol/water=50/50 as wash solvent affected the column efficiency for most analytes. The results suggest that the band compression effect by the weak-wash solvent associated with partial-loop injection may provide a practical means to reducing the extra-column effect for small-size columns, while the use of an instrument with minimum extra-column effect is highly desirable.

Determination of ricin by nano liquid chromatography/mass spectrometry after extraction using lactose‐immobilized monolithic silica spin column

Ricin is a glycosylated proteinous toxin that is registered as toxic substance by Chemical Weapons convention. Current detection methods can result in false negatives and/or positives, and their criteria are not based on the identification of the protein amino acid sequences. In this study, lactose-immobilized monolithic silica extraction followed by tryptic digestion and liquid chromatography/mass spectrometry (LC/MS) was developed as a method for rapid and accurate determination of ricin. Lactose, which was immobilized on monolithic silica, was used as a capture ligand for ricin extraction from the sample solution, and the silica was supported in a disk-packed spin column. Recovery of ricin was more than 40%. After extraction, the extract was digested with trypsin and analyzed by LC/MS. The accurate masses of molecular ions and MS/MS spectra of the separated peptide peaks were measured by Fourier transform-MS and linear iontrap-MS, respectively. Six peptides, which were derived from the ricin A-(m/z 537.8, 448.8 and 586.8) and B-chains (m/z 701.3, 647.8 and 616.8), were chosen as marker peptides for the identification of ricin. Among these marker peptides, two peptides were ricin-specific. This method was applied to the determination of ricin from crude samples. The monolithic silica extraction removed most contaminant peaks from the total ion chromatogram of the sample, and the six marker peptides were clearly detected by LC/MS. It takes about 5 h for detection and identification of more than 8 ng/ml of ricin through the whole handling, and this procedure will be able to deal with the terrorism using chemical weapon.

Enhanced Sequence Coverage in Tryptic Fragment Analysis by Two-Dimensional HPLC/MS Using a Monolithic Silica Capillary Column

The HPLC/MS system, in which a monolithic silica capillary column is directly connected to an electronspray-ionization mass spectrometer, showed superior performance at high mobile phase linear velocity. A two-dimensional (2D) HPLC/MS system was established, using an ion-exchange particle-packed capillary column at the first dimension and a monolithic silica capillary column at the second dimension. In an analysis of tryptic fragments from bovine serum albumin, an 81% sequence coverage, obtained by the 2D-HPLC/MS system, increased by 23% as compared to a 1D-HPLC/MS system. This 2D-HPLC/MS system using a monolithic silica capillary column should be useful for enhancing sequence coverage of tryptic fragments in proteomics.

Monolithic silica capillary column extraction of methamphetamine and amphetamine in urine coupled with thin-layer chromatographic detection

A monolithic silica capillary column was first developed in Japan in 2001 as a new tool for better liquid chromatographic separation. The column is made of C18-bonded monolithic silica packed into a capillary glass tube (0.20 mm i.d.). In this study, we used this column for solid-phase extraction of methamphetamine (MA) and amphetamine (AP) in urine. Chromatographic separation was achieved by thin-layer chromatography (TLC) with double-spray detection of each spot. For extraction of amphetamines in urine, samples were mixed with phosphate buffer (pH 3.0, containing 20mM sodium octanesulfate), and the analytes were adsorbed to the column by passing the mixture through it. They were then eluted with a 10-μl volume of ethyl acetate and directly spotted onto a TLC plate. After development, the detection of MA was performed with Simon’s reagent. The plate was air-dried, and then over-sprayed with fluorescamine reagent for detection of AP. A fluorescent spot of AP was observed at 365 nm using an ultraviolet viewing system. The detection limits of MA and AP in urine were about 1.0 and 2.0μg/ml, respectively. To confirm the usefulness of this method, the eluent from the column was also analyzed by gas chromatography-mass spectrometry (GC-MS) after derivatization with heptafluorobutyric anhydride. In analysis of 30 actual urine samples, the results obtained by the monolith-TLC system were generally well in accordance with those obtained by GC-MS.

Performance of wide-pore monolithic silica column in protein separation.

A monolithic wide-pore silica column was newly prepared for protein separation. The wide distribution of the pore sizes of monolithic columns was evaluated by mercury porosimetry. This column, as well as the conventional monolithic column, shows high permeability in the chromatographic separation of low-molecular-sized substances. In higher-molecular-sized protein separation, the wide-pore monolithic silica column shows better performance than that of the conventional monolithic column. Under optimized conditions, five different proteins--ribonuclease A, albumin, aldolase, catalase, and ferritin--were baseline-separated within 3 min, which is faster than that using the particle-packed columns. In addition, the monolithic wide-pore silica column could also be prepared in fused silica capillary (600 mm long, 0.2 mm i.d.) for highly efficient protein separation. The peak capacity of the wide-pore monolithic silica capillary column is estimated to be approximately 300 in the case of protein separation, which is a characteristic performance.

Preparation and evaluation of lactose-modified monoliths for the adsorption and decontamination of plant toxins and lectins

A series of sugar-modified porous silica monoliths with different sugar ligands (β-lactoside, β-N-acetyllactosaminide, β-d-galactoside, β-d-N-acetylgalactosaminide and β-d-glucoside) and linkers were prepared and evaluated using plant toxins and lectins including ricin and a Ricinus communis agglutinin (RCA(120)). Among these sugar monoliths, a lactose monolith carrying a triethylene glycol spacer adsorbed ricin and RCA(120) with the highest efficiency. The monolith showed no binding with albumin, globulin, and lectins from Jack beans, Osage orange, Amur maackia and wheat germ. All these data support the utility of the lactose-modified monolith as a tool for adsorption and decontamination of plant toxins.