Mohammad Khan Jamali

Assessment of water quality of polluted lake using multivariate statistical techniques: A case study

Multivariate statistical techniques, cluster analysis (CA) and principal component analysis (PCA) were applied to the data on water quality of Manchar Lake (Pakistan), generated during 2005-06, with monitoring at five different sites for 36 parameters. This study evaluated and interpreted complex water quality data sets and apportioned of pollution sources to get better information about water quality and to design a monitoring network. The chemical correlations were observed by PCA, which were used to classify the samples by CA, based on the PCA scores. Three significant sampling locations--(sites 1 and 2), (site 4) and (sites 3 and 5)--were detected on the basis of similarity of their water quality. The results revealed that the major causes of water quality deterioration were related to inflow of effluent from industrial, domestic, agricultural and saline seeps into the lake at site 1 and also resulting from people living in boats and fishing at sites 2 and 3.

Copper, Chromium, Manganese, Iron, Nickel, and Zinc Levels in Biological Samples of Diabetes Mellitus Patients

There is accumulating evidence that the metabolism of several trace elements is altered in diabetes mellitus and that these nutrients might have specific roles in the pathogenesis and progress of this disease. The aim of present study was to compare the level of essential trace elements, chromium (Cr), copper (Cu), iron (Fe), manganese (Mn), nickel (Ni), and zinc (Zn) in biological samples (whole blood, urine, and scalp hair) of patients who have diabetes mellitus type 2 (n = 257), with those of nondiabetic control subjects (n = 166), age ranged (45–75) of both genders. The element concentrations were measured by means of an atomic absorption spectrophotometer after microwave-induced acid digestion. The validity and accuracy was checked by conventional wet-acid-digestion method and using certified reference materials. The overall recoveries of all elements were found in the range of (97.60–99.49%) of certified values. The results of this study showed that the mean values of Zn, Mn, and Cr were significantly reduced in blood and scalp-hair samples of diabetic patients as compared to control subjects of both genders (p < 0.001). The urinary levels of these elements were found to be higher in the diabetic patients than in the age-matched healthy controls. In contrast, high mean values of Cu and Fe were detected in scalp hair and blood from patients versus the nondiabetic subjects, but the differences found in blood samples was not significant (p < 0.05). These results are consistent with those obtained in other studies, confirming that deficiency and efficiency of some essential trace metals may play a role in the development of diabetes mellitus.

Evaluation of status of toxic metals in biological samples of diabetes mellitus patients

There is accumulating evidence that the metabolism of several trace elements is altered in diabetes mellitus and that these nutrients might have specific roles in the pathogenesis and progress of this disease. The aim of present study was to compare the level of toxic elements, lead (Pb), cadmium (Cd), and arsenic (As) in biological samples (whole blood, urine, and scalp hair) of patients having diabetes mellitus type-2 age ranged (31-60) (n=238), with those of age matched non-diabetics (ND) as control subjects (n=196), of both genders. The concentrations of elements were measured by means of an atomic absorption spectrophotometer after microwave-assisted acid digestion. The validity and accuracy was checked by conventional wet acid digestion method and using certified reference materials. The overall recoveries of all elements were found in the range of 98.1-99.4% of certified values. The results of this study showed that the mean values of Pb, Cd and, As were significantly higher in scalp hair samples of smoker and non-smoker diabetic patients as compared to control subjects (p<0.001). The concentration of understudy toxic metals was also high in blood and urine samples of DM patient but difference was more significant in smoker DM patients. These results are consistent with those obtained in other studies, confirming that toxic metals may play a role in the development of diabetes mellitus.

Time saving modified BCR sequential extraction procedure for the fraction of Cd, Cr, Cu, Ni, Pb and Zn in sediment samples of polluted lake.

The mobility, availability and persistence of heavy metals (Cd, Cr, Cu, Ni, Pb and Zn) in contaminated lake sediment samples were evaluated by means of sequential extraction scheme, proposed by the Community Bureau of Reference protocol (BCR). The metal content in the extracts was measured by atomic absorption spectrometry. The precision and accuracy of the proposed procedure were evaluated by using a certified reference material BCR 701. The maximum recoveries for heavy metals (HMs) were observed for all three steps of BCR protocol at 32h total shaking period instead of previously reported 51h, with p>0.05. The lixiviation tests (DIN 38414-S4) were used to evaluate the leaching of HMs from sediment samples and it was observed that levels of water extractable HMs were low as compared to those values obtained by acid-soluble fraction of the BCR protocol.

Essential Trace and Toxic Element Distribution in the Scalp Hair of Pakistani Myocardial Infarction Patients and Controls

The pathogenesis of heart disease has been associated with changes in the balance of certain trace elements. The aim of this study was to evaluate the Zn, Fe, Cu, Cr, Ni, Pb, and Cd contents in scalp hair samples of myocardial infarction (MCI) patients hospitalized in the cardiac ward of National Hospital in Hyderabad city (Pakistan). Scalp hair samples were collected from 193 patients (104 male, 89 female) of 3 age groups (46–60, 61–75, and 76–90 yr), for a comparative study, 200 normal, healthy subjects (103 male, 97 female) of the same age groups residing in the same city were selected. All metals in scalp hair samples were assessed by a flame/graphite furnace atomic absorption spectrophotometer, prior to microwave-assisted and conventional wet acid digestion methods. Results were calculated in micrograms per gram.The mean values of Fe and Zn of scalp hair samples of MCI patients were significantly reduced compared to the control subjects of both genders. The mean Fe concentrations in male patients were 19.42, 12.36, and 6.98 vs 30.69, 24.42, and 16.75 for the control patients in the three age groups (46–60, 61–75, and 76–90 yrs, respectively). The mean Zn concentration in male patients were 169.2, 149.4, and 107.7 μg/g vs 206.1, 188.0, and 154.4 μg/g for the control group (p<0.002, 0.004, and 0.001) in all three age groups, respectively. These differences were also observed in the female study groups. The mean values of Pb, Cd, and Ni were significantly high in patients compared to healthy subjects (mean Pb in male patients: 11.85, 12.89, and 14.52 those of female patients were 11.88, 12.73, and 14.21 vs the male controls patients (6.08, 7.56, and 8.56) and female controls (5.99, 7.41, and 8.25) for all three age groups, respectively. The concentration of Ni and Cd in the scalp hair samples of the heart patients of both sexes were significantly higher compared to the control; in the case of Ni the range of significant difference for males was found to be p<0.001–0.009 and for females to be p<0.0.002–0.007 and significantly high concentration of Cd were observed in hair samples of patients than in controls in the range for males (p<0.001–0.009) and in females (p<0.001–0.011). The Zn/Cu and Zn/Cd ratios in the scalp hair (p<0.01) of the diseased groups were significantly lower than that of the healthy groups.Deficiency of essential trace metals and high level of toxic metals might play a role in the development of heart disease in the subjects of this study. Toxic metals might also cause diminished absorption of essential elements.

Evaluation of toxic metals in biological samples (scalp hair, blood and urine) of steel mill workers by electrothermal atomic absorption spectrometry.

The determination of toxic metals in the biological samples of human beings is an important clinical screening procedure. This study aimed to assess the possible influence of environmental exposure on production workers (PW) and quality control workers (QCW) of a steel mill, all male subjects aged 25-55 years. In this investigation, the concentrations of Pb, Cd, Ni and Cr were determined in biological samples (blood, urine and scalp hair samples) from these steel mill workers in relation to controlled unexposed healthy subjects of the same age group. After pre-treatment with nitric acid-hydrogen peroxide, the samples were digested via a microwave oven, and for comparison purposes, the same samples were digested by the conventional wet acid digestion method. The samples digested were subjected to graphite furnace atomic absorption spectrometry (GFAAS). To assess the reliability of these methods, critical factors, such as detection limit(s), calibration range(s), accuracy and precision, were studied. Quality control for these procedures was established with certified sample of human hair, urine and whole blood. The results indicate that the level of lead, cadmium and nickel in scalp hair, blood and urine samples were significantly higher in both groups of exposed workers (QW and PW) than those of the controls. The possible connection of these elements with the etiology of disease is discussed. The results also show the need for immediate improvements in workplace ventilation and industrial hygiene practices. Toxicology and Industrial Health 2006; 22: 381-393.

Speciation of heavy metals in untreated domestic wastewater sludge by time saving BCR sequential extraction method

In this work the modified three-stage sequential extraction procedure developed within the Standards, Measurement and Testing Programme (formally the Community Bureau of Reference BCR) of the European Commission, was applied for the fractionation of Cd, Cr, Cu, Ni, Pb and Zn in the untreated domestic wastewater sludge (DWS) collected from the Hyderabad city of Pakistan. The aim of our study was to evaluate the impact of different time intervals for shaking, and sample mass of sewage sludge on optimal recovery of all metals under study. Analyses of the extracts were performed by flame atomic absorption spectrometry (FAAS) and electrothermal atomic absorption spectrometry (ETAAS). The precision and accuracy of the proposed procedure was evaluated by using a certified reference material of soil amended with sewage sludge BCR 483. The maximum recoveries for Cd and Zn were observed for all three steps of BCR protocol at 26 hours (h) total shaking period, while Cr, Cu, Ni and Pb were achieved at 32 hours instead of previously reported 51 hours, with (p < 0.05). The maximum level of all heavy metals was achieved in samples mass 0.2–0.4 g, where as the extractant-sample mass ratio was kept according to the optimized BCR method. The results of the sequential extraction study of untreated DWS indicates that more easily mobilized forms (acid exchangeable) were found to be 31.0, 3.1, 2.5, 7.6, 2.6 and 8.4% of total contents of Cd, Cr, Cu, Ni, Pb and Zn, respectively. The oxidizable fraction is dominant for all the heavy metals, except Cd. The lixiviation tests (DIN 38414-S4) were used to evaluate the leaching of heavy metals from sewage sludge used for agricultural purposes.

Application of factorial design in optimization of ultrasonic-assisted extraction of aluminum in juices and soft drinks

A sample preparation method based on ultrasound-assisted pseudo-digestion of Al from Juices and soft drink samples under ultrasonic effect has been described. A Plackett-Burman experimental design was used as a multivariate strategy for the evaluation of the effects of varying several variables at once. The effects of five different variables preintensification time (without ultrasonic stirring), intensification time in ultrasonic bath (UB), temperature of UB, two acid mixtures (HNO(3)-H(2)SO(4)-H(2)O(2) and HNO(3)-H(2)O(2)), on the recovery of Al have been investigated. From these studies, certain variable showed up as significant, and they were optimized by a using 2(3)+star central composite design, which involved 16 experiments. The best conditions for pseudo-digestion were as follows: a preintensification time 10min, intensification time 20min, volume of acid mixtures 3.0ml and temperature of ultrasonic bath 80 degrees C. A conventional acid digestion on electric hot plate was used to obtain total Al for comparative purpose. Final solutions obtained from both methods, were analysed by electrothermal atomic absorption spectrometry. Analytical results for the Al by ultrasound-assisted pseudo-digestion, and conventional wet digestion methods showed a good agreement, thus indicating the possibility of using ultrasonic-assisted digestion sample preparation instead of intensive treatments inherent with the acid digestion methods on electric hot plate. The procedure proposed allowed the determination of Al with detection limit (3alpha/s) 10mugl(-1).

Hazardous impact of toxic metals on tobacco leaves grown in contaminated soil by ultrasonic assisted pseudo-digestion: multivariate study.

Tobacco leaves (Nicotiana tabacum L.), agricultural soil and pollute irrigated lake water samples were collected during 2005--2006 and analyzed for Cd and Ni by electrothermal atomic absorption spectrometry (ETAAS). A simple and efficient procedure was investigated for the complete decomposition of tobacco leaves using ultrasonic assisted acid pseudo-digestion method (UPDM). A Plackett-Burman experimental design was used as a multivariate strategy for the evaluation of seven factors/variables at once, while central composite were used to found optimum values of significant variables. The accuracy of the proposed methods was assessed by analyzing certified reference (CRM); Virginia tobacco leaves (CTA-VTL-2). The results being compared with those obtained by conventional wet acid digestion method. The result obtained by optimized method showed good agreement with the certified values and sufficiently high recovery 97.8 and 98.7% for Cd and Ni, respectively. Under optimal conditions, the detection limits (3sigma) were evaluated to be 0.019 microg g(-1) for Cd and 0.37 microg g(-1) for Ni. The proposed method was successfully applied to the determination of Cd and Ni in raw, processed tobacco and different branded cigarettes samples.

Assessment of toxic metals in raw and processed milk samples using electrothermal atomic absorption spectrophotometer.

Milk and dairy products have been recognized all over the world for their beneficial influence on human health. The levels of toxic metals (TMs) are an important component of safety and quality of milk. A simple and efficient microwave assisted extraction (MAE) method has been developed for the determination of TMs (Al, Cd, Ni and Pb), in raw and processed milk samples. A Plackett-Burman experimental design and 2(3)+star central composite design, were applied in order to determine the optimum conditions for MAE. Concentrations of TMs were measured by electrothermal atomic absorption spectrometry. The accuracy of the optimized procedure was evaluated by standard addition method and conventional wet acid digestion method (CDM), for comparative purpose. No significant differences were observed (P>0.05), when comparing the values obtained by the proposed MAE method and CDM (paired t-test). The average relative standard deviation of the MAE method varied between 4.3% and 7.6% based on analyte (n=6). The proposed method was successfully applied for the determination of understudy TMs in milk samples. The results of raw and processed milk indicated that environmental conditions and manufacturing processes play a key role in the distribution of toxic metals in raw and processed milk.