Nisha Prakash

Ultrasensitive self-powered large area planar GaN UV-photodetector using reduced graphene oxide electrodes

A simplistic design of a self-powered UV-photodetector device based on hybrid reduced-graphene-oxide (r-GO)/gallium nitride (GaN) is demonstrated. Under zero bias, the fabricated hybrid photodetector shows a photosensivity of ∼85% while the ohmic contact GaN photodetector with an identical device structure exhibits only ∼5.3% photosensivity at 350 nm illumination (18 μW/cm2). The responsivity and detectivity of the hybrid device were found to be 1.54 mA/W and 1.45 × 1010 Jones (cm Hz½ W−1), respectively, at zero bias with fast response (60 ms), recovery time (267 ms), and excellent repeatability. Power density-dependent responsivity and detectivity revealed ultrasensitive behaviour under low light conditions. The source of the observed self-powered effect in the hybrid photodetector is attributed to the depletion region formed at the r-GO and GaN quasi-ohmic interface.

Binary Multifunctional Ultrabroadband Self‐Powered g‐C3N4/Si Heterojunction High‐Performance Photodetector

Compact optical detectors with fast binary photoswitching over a broad range of wavelength are essential as an interconnect for any light-based parallel, real-time computing. Despite of the tremendous technological advancements yet there is no such single device available that meets the specifications. Here we report a multifunctional self-powered high-speed ultrabroadband (250-1650 nm) photodetector based on g-C3N4/Si hybrid 2D/3D structure. The device shows a novel binary photoswitching (change in current from positive to negative) in response to OFF/ON light illumination at small forward bias (<0.1 V) covering 250-1350 nm. At zero bias, the device displays an extremely high ON/OFF ratio of 1.2 x 10^5 under 680 nm (49 microWcm-2) illumination. The device also shows an ultrasensitive behaviour over the entire operating range at low light illuminations, with highest responsivity (1.2 AW-1), detectivity (2.8 x 10^14 Jones) and external quantum efficiency (213%) at 680 nm. The response and recovery speeds are typically 0.23 and 0.60 ms, respectively, under 288 Hz light switching frequency. Dramatically improved performance of our device is attributed to the heterojunctions formed by the ultrathin g-C3N4 nanosheets embedded in the Si surface.

Emerging photoluminescence from bilayer large-area 2D MoS2 films grown by pulsed laser deposition on different substrates

We report the growth of continuous large area bilayer films of MoS2 on different substrates by pulsed laser deposition (PLD). The growth parameters for PLD were modified in such a way that results in bilayer 2D-MoS2 films on both c-Al2O3 (0001) (sapphire) and SiO2/Si (SO) substrates. The bilayer large area crystalline nature of growth in the 2 H-phase is determined by Raman spectroscopy. Cross-sectional transmission electron microscopy confirms the distinct thinnest ordered layered structure of MoS2. Chemical analysis reveals an almost stoichiometric 2 H-phase on both the substrates. The photoluminescence intensities of both the films match very well with those of the corresponding exfoliated flakes, as well as chemical vapor deposited (CVD) films as reported in the literature. The in-situ post growth annealing with optimal film thickness acts as a solid phase epitaxy process which provides continuous crystalline layers with a smooth interface and regulates the photoluminescence properties. In contrast, t...

Effect of substrate nitridation temperature on the persistent photoconductivity of unintentionally-doped GaN layer grown by PAMBE

The surface roughness and defect density of GaN epitaxial layers grown on c-plane sapphire substrate are investigated and found to be dependent on nitridation temperature. GaN epitaxial layers grown after nitridation of sapphire at 200°C have a higher defect density and higher surface roughness compared to the GaN layers grown at 646°C nitridation as confirmed by atomic force microscopy (AFM). The persistent photoconductivity (PPC) was observed in both samples and it was found to be decreasing with decreasing temperature in the range 150-300°C due to long carrier lifetime and high electron mobility at low temperature. The photoresponse of the GaN films grown in this study exhibit improved PPC due to their better surface morphology at 646°C nitrided sample. The point defects or extended microstructure defects limits the photocarrier lifetime and electron mobility at 200°C nitrided sample.

Assessment of Genetic Variability for Iron Content in Grain of Rice (Oryza sativa L.) Germplasm Accessions and Identification of Transgressant Lines

Iron and zinc deficiencies are serious global health problems among the people dependent on staple crops like rice and maize. Enrichment of nutrients in these crops can be achieved by adopting biofortification methods. The objective of this experiment was to identify high iron containing lines in rice by developing new mapping populations. Three mapping populations were developed based on grain iron content and yield viz., IRRI38 X Jeerigesanna, BI33 X Jeerigesanna and Azucena X Moromutant after the two seasons screening of 960 germplasm accessions under aerobic and wetland condition. Iron and zinc concentrations were estimated from RILs and the values ranged from 4.45 to 76 mg/kg and 7.73 to 146 mg/kg, respectively. Thirty two high iron and zinc containing genotypes were identified for all India trial in Kharif 2011; these genotypes were evaluated for iron and zinc content. AM127 and Karidaddi were found to have high iron content while AM65 and AM143 were found to be have high zinc content.