Oleg Pronin

High-power 200 fs Kerr-lens mode-locked Yb:YAG thin-disk oscillator.

We demonstrate a power-scalable Kerr-lens mode-locked Yb:YAG thin-disk oscillator. It delivers 200 fs pulses at an average power of 17 W and a repetition rate of 40 MHz. At an increased (180 W) pump power level, the laser produces 270 fs 1.1 μJ pulses at an average power of 45 W (optical-to-optical efficiency of 25%). Semiconductor-saturable-absorber-mirror-assisted Kerr-lens mode locking (KLM) and pure KLM with a hard aperture show similar performance. To our knowledge, these are the shortest pulses achieved from a mode-locked Yb:YAG disk oscillator and this is the first demonstration of a Kerr-lens mode-locked thin-disk laser.

High photon flux table-top coherent extreme-ultraviolet source

High photon flux with up to 1012 photons in the 25–40 eV range has been achieved in a new table-top coherent extreme ultraviolet (EUV) source based on phase-matched high-harmonic generation using a fibre laser. Intense and compact EUV sources are needed for certain types of spectroscopic and imaging applications.

Energy scaling of Kerr-lens mode-locked thin-disk oscillators

Geometric scaling of a Kerr-lens mode-locked Yb:YAG thin-disk oscillator yields femtosecond pulses with an average output power of 270 W. The scaled system delivers femtosecond (210-330 fs) pulses with a peak power of 38 MW. These values of average and peak power surpass the performance of any previously reported femtosecond laser oscillator operated in atmospheric air.

High-dispersive mirrors for high power applications

We report on the development and manufacturing of two different types of high-dispersive mirrors (HDM). One of them provides a record value for the group delay dispersion (GDD) of -4000 fs2 and covers the wavelength range of 1027-1033 nm, whereas the other one provides -3000 fs2 over the wavelength range of 1020-1040 nm. Both of the fabricated mirrors exhibit a reflectance of >99.9% and are well suited for intracavity applications. Mirrors of the second type have been successfully employed in a Kerr-lens mode-locked Yb:YAG thin-disk oscillator for the generation of 200-fs pulses with multi-10-W average power.

High-power multi-megahertz source of waveform-stabilized few-cycle light

Waveform-stabilized laser pulses have revolutionized the exploration of the electronic structure and dynamics of matter by serving as the technological basis for frequency-comb and attosecond spectroscopy. Their primary sources, mode-locked titanium-doped sapphire lasers and erbium/ytterbium-doped fibre lasers, deliver pulses with several nanojoules energy, which is insufficient for many important applications. Here we present the waveform-stabilized light source that is scalable to microjoule energy levels at the full (megahertz) repetition rate of the laser oscillator. A diode-pumped Kerr-lens-mode-locked Yb:YAG thin-disk laser combined with extracavity pulse compression yields waveform-stabilized few-cycle pulses (7.7 fs, 2.2 cycles) with a pulse energy of 0.15 μJ and an average power of 6 W. The demonstrated concept is scalable to pulse energies of several microjoules and near-gigawatt peak powers. The generation of attosecond pulses at the full repetition rate of the oscillator comes into reach. The presented system could serve as a primary source for frequency combs in the mid infrared and vacuum UV with unprecedented high power levels.

Ultrabroadband efficient intracavity XUV output coupler

We report an efficient intracavity XUV output coupler based on an anti-reflection-coated grazing incidence plate (GIP). Conceptually, GIP is an extension of a Brewster plate, affording low loss of the circulating fundamental light and serving as a highly efficient, extremely broadband output coupler for XUV. Due to the grazing incidence geometry, the short wavelength reflectivity can be extended to the keV range. The first GIP realized shows parameters close to the design. We discuss both the limitations of the GIP in comparison with other XUV output couplers and the applicability of the GIP extension at longer wavelengths, down to the MIR.

All solid-state spectral broadening: an average and peak power scalable method for compression of ultrashort pulses

Spectral broadening in bulk material is a simple, robust and low-cost method to extend the bandwidth of a laser source. Consequently, it enables ultrashort pulse compression. Experiments with a 38 MHz repetition rate, 50 W average power Kerr-lens mode-locked thin-disk oscillator were performed. The initially 1.2 μJ, 250 fs pulses are compressed to 43 fs by means of self-phase modulation in a single 15 mm thick quartz crystal and subsequent chirped-mirror compression. The losses due to spatial nonlinear effects are only about 40 %. A second broadening stage reduced the Fourier transform limit to 15 fs. It is shown that the intensity noise of the oscillator is preserved independent of the broadening factor. Simulations manifest the peak power scalability of the concept and show that it is applicable to a wide range of input pulse durations and energies.

High-power Kerr-lens mode-locked Yb:YAG thin-disk oscillator in the positive dispersion regime

We demonstrate a self-starting Kerr-lens mode-locked (KLM) Yb:YAG thin-disk oscillator operating in the regime of positive intracavity group-delay dispersion (GDD). It delivers 1.7 ps pulses at an average power of 17 W and a repetition rate of 40 MHz. Dispersive mirrors compress the pulses to a duration of 190 fs (assuming sech2 shape; Fourier limit: 150 fs) at an average power level of 11 W. To our knowledge, this is the first KLM thin-disk oscillator with positive GDD. Output powers of up to 30 W were achieved with an increased output coupler transmission and intracavity GDD. We demonstrate increase of the pulse energy with increasing positive intracavity GDD, limited by difficulties in initiating mode-locking.

1 kW, 200 mJ picosecond thin-disk laser system

We report on a laser system based on thin-disk technology and chirped pulse amplification, providing output pulse energies of 200 mJ at a 5 kHz repetition rate. The amplifier contains a ring-type cavity and two thin Yb:YAG disks, each pumped by diode laser systems providing up to 3.5 kW power at a 969 nm wavelength. The average output power of more than 1 kW is delivered in an excellent output beam characterized by M2=1.1. The output pulses are compressed to 1.1 ps at full power with a pair of dielectric gratings.

High-power, 1-ps, all-Yb:YAG thin-disk regenerative amplifier

We report a 100 W, 20 mJ, 1-ps, all-Yb:YAG thin-disk regenerative amplifier seeded by a microjoule-level Yb:YAG thin-disk Kerr-lens mode-locked oscillator. The regenerative amplifier is implemented in a chirped pulse amplification system and operates at an ambient temperature in air, delivering ultrastable output pulses at a 5 kHz repetition rate and with a root mean square power noise value of less than 0.5%. Second harmonic generation of the amplifiers output in a 1.5 mm-thick BBO crystal results in more than 70 W at 515 nm, making the system an attractive source for pumping optical parametric chirped pulse amplifiers in the visible and near-infrared spectral ranges.