S Simone Assali

Direct Band Gap Wurtzite Gallium Phosphide Nanowires

The main challenge for light-emitting diodes is to increase the efficiency in the green part of the spectrum. Gallium phosphide (GaP) with the normal cubic crystal structure has an indirect band gap, which severely limits the green emission efficiency. Band structure calculations have predicted a direct band gap for wurtzite GaP. Here, we report the fabrication of GaP nanowires with pure hexagonal crystal structure and demonstrate the direct nature of the band gap. We observe strong photoluminescence at a wavelength of 594 nm with short lifetime, typical for a direct band gap. Furthermore, by incorporation of aluminum or arsenic in the GaP nanowires, the emitted wavelength is tuned across an important range of the visible light spectrum (555–690 nm). This approach of crystal structure engineering enables new pathways to tailor materials properties enhancing the functionality.

Hexagonal silicon realized

Silicon, arguably the most important technological semiconductor, is predicted to exhibit a range of new and interesting properties when grown in the hexagonal crystal structure. To obtain pure hexagonal silicon is a great challenge because it naturally crystallizes in the cubic structure. Here, we demonstrate the fabrication of pure and stable hexagonal silicon evidenced by structural characterization. In our approach, we transfer the hexagonal crystal structure from a template hexagonal gallium phosphide nanowire to an epitaxially grown silicon shell, such that hexagonal silicon is formed. The typical ABABAB... stacking of the hexagonal structure is shown by aberration-corrected imaging in transmission electron microscopy. In addition, X-ray diffraction measurements show the high crystalline purity of the material. We show that this material is stable up to 9 GPa pressure. With this development, we open the way for exploring its optical, electrical, superconducting, and mechanical properties.

Atomic layer deposition of Pd and Pt nanoparticles for catalysis: on the mechanisms of nanoparticle formation

The deposition of Pd and Pt nanoparticles by atomic layer deposition (ALD) has been studied extensively in recent years for the synthesis of nanoparticles for catalysis. For these applications, it is essential to synthesize nanoparticles with well-defined sizes and a high density on large-surface-area supports. Although the potential of ALD for synthesizing active nanocatalysts for various chemical reactions has been demonstrated, insight into how to control the nanoparticle properties (i.e. size, composition) by choosing suitable processing conditions is lacking. Furthermore, there is little understanding of the reaction mechanisms during the nucleation stage of metal ALD. In this work, nanoparticles synthesized with four different ALD processes (two for Pd and two for Pt) were extensively studied by transmission electron spectroscopy. Using these datasets as a starting point, the growth characteristics and reaction mechanisms of Pd and Pt ALD relevant for the synthesis of nanoparticles are discussed. The results reveal that ALD allows for the preparation of particles with control of the particle size, although it is also shown that the particle size distribution is strongly dependent on the processing conditions. Moreover, this paper discusses the opportunities and limitations of the use of ALD in the synthesis of nanocatalysts.

Exploring Crystal Phase Switching in GaP Nanowires.

The growth of wurtzite/zincblende (WZ and ZB, respectively) superstructures opens new avenues for band structure engineering and holds the promise of digitally controlling the energy spectrum of quantum confined systems. Here, we study growth kinetics of pure and thus defect-free WZ/ZB homostructures in GaP nanowires with the aim to obtain monolayer control of the ZB and WZ segment lengths. We find that the Ga concentration and the supersaturation in the catalyst particle are the key parameters determining growth kinetics. These parameters can be tuned by the gallium partial pressure and the temperature. The formation of WZ and ZB can be understood with a model based on nucleation either at the triple phase line for the WZ phase or in the center of the solid-liquid interface for the ZB phase. Furthermore, the observed delay/offset time needed to induce WZ and ZB growth after growth of the other phase can be explained within this framework.

High yield transfer of ordered nanowire arrays into transparent flexible polymer films

The factors affecting transfer of nanowire arrays from their substrates into flexible PDMS films have been systematically investigated. Experiments were carried out on gallium phosphide nanowires with a standard length of 10 μm with varying pitch (0.2-1.5 μm). The important factors were found to be penetration of the PDMS within the nanowire arrays and the strength/rigidity of the PDMS film. The PDMS penetration between wires in the arrays is affected by both the viscosity of the PDMS solution and the presence of air pockets trapped within nanowire arrays, particularly at small pitches. Dilution with hexane and curing in a vacuum desiccator solve the wire penetration problem, and an increase in cure/base ratio increases the rigidity and strength of the PDMS. The procedures for preparation and deposition of the PDMS solution are optimized and a high yield, up to 95%, of wire transfer across a range of nanowire pitches has been obtained.

Growth and Optical Properties of Direct Band Gap Ge/Ge0.87Sn0.13 Core/Shell Nanowire Arrays

Group IV semiconductor optoelectronic devices are now possible by using strain-free direct band gap GeSn alloys grown on a Ge/Si virtual substrate with Sn contents above 9%. Here, we demonstrate the growth of Ge/GeSn core/shell nanowire arrays with Sn incorporation up to 13% and without the formation of Sn clusters. The nanowire geometry promotes strain relaxation in the Ge0.87Sn0.13 shell and limits the formation of structural defects. This results in room-temperature photoluminescence centered at 0.465 eV and enhanced absorption above 98%. Therefore, direct band gap GeSn grown in a nanowire geometry holds promise as a low-cost and high-efficiency material for photodetectors operating in the short-wave infrared and thermal imaging devices.

Atom-by-Atom Analysis of Semiconductor Nanowires with Parts Per Million Sensitivity

The functionality of semiconductor devices is determined by the incorporation of dopants at concentrations down to the parts per million (ppm) level and below. Optimization of intentional and unintentional impurity doping relies on methods to detect and map the level of impurities. Detecting such low concentrations of impurities in nanostructures is however challenging to date as on the one hand methods used for macroscopic samples cannot be applied due to the inherent small volumes or faceted surfaces and on the other hand conventional microscopic analysis techniques are not sufficiently sensitive. Here, we show that we can detect and map impurities at the ppm level in semiconductor nanowires using atom probe tomography. We develop a method applicable to a wide variety of nanowires relevant for electronic and optical devices. We expect that it will contribute significantly to the further optimization of the synthesis of nanowires, nanostructures and devices based on these structures.

Cracking the Si Shell Growth in Hexagonal GaP-Si Core-Shell Nanowires

Semiconductor nanowires have increased the palette of possible heterostructures thanks to their more effective strain relaxation. Among these, core-shell heterostructures are much more sensitive to strain than axial ones. It is now accepted that the formation of misfit dislocations depends both on the lattice mismatch and relative dimensions of the core and the shell. Here, we show for the first time the existence of a new kind of defect in core-shell nanowires: cracks. These defects do not originate from a lattice mismatch (we demonstrate their appearance in an essentially zero-mismatch system) but from the thermal history during the growth of the nanowires. Crack defects lead to the development of secondary defects, such as type-I1 stacking faults and Frank-type dislocations. These results provide crucial information with important implications for the optimized synthesis of nanowire-based core-shell heterostructures.

Optical properties of strained wurtzite gallium phosphide nanowires

Wurtzite gallium phosphide (WZ GaP) has been predicted to exhibit a direct bandgap in the green spectral range. Optical transitions, however, are only weakly allowed by the symmetry of the bands. While efficient luminescence has been experimentally shown, the nature of the transitions is not yet clear. Here we apply tensile strain up to 6% and investigate the evolution of the photoluminescence (PL) spectrum of WZ GaP nanowires (NWs). The pressure and polarization dependence of the emission together with a theoretical analysis of strain effects is employed to establish the nature and symmetry of the transitions. We identify the emission lines to be related to localized states with significant admixture of Γ7c symmetry and not exclusively related to the Γ8c conduction band minimum (CBM). The results emphasize the importance of strongly bound state-related emission in the pseudodirect semiconductor WZ GaP and contribute significantly to the understanding of the optoelectronic properties of this novel material.

Optical study of the band structure of wurtzite GaP nanowires

We investigated the optical properties of wurtzite (WZ) GaP nanowires by performing photoluminescence (PL) and time-resolved PL measurements in the temperature range from 4 K to 300 K, together with atom probe tomography to identify residual impurities in the nanowires. At low temperature, the WZ GaP luminescence shows donor-acceptor pair emission at 2.115 eV and 2.088 eV, and Burstein-Moss band-filling continuum between 2.180 and 2.253 eV, resulting in a direct band gap above 2.170 eV. Sharp exciton α-β-γ lines are observed at 2.140–2.164–2.252 eV, respectively, showing clear differences in lifetime, presence of phonon replicas, and temperature-dependence. The excitonic nature of those peaks is critically discussed, leading to a direct band gap of ∼2.190 eV and to a resonant state associated with the γ-line ∼80 meV above the Γ8C conduction band edge.