Sabbir Rangwala

Geiger-mode avalanche photodiode focal plane arrays for three-dimensional imaging LADAR

We report on the development of focal plane arrays (FPAs) employing two-dimensional arrays of InGaAsP-based Geiger-mode avalanche photodiodes (GmAPDs). These FPAs incorporate InP/InGaAs(P) Geiger-mode avalanche photodiodes (GmAPDs) to create pixels that detect single photons at shortwave infrared wavelengths with high efficiency and low dark count rates. GmAPD arrays are hybridized to CMOS read-out integrated circuits (ROICs) that enable independent laser radar (LADAR) time-of-flight measurements for each pixel, providing three-dimensional image data at frame rates approaching 200 kHz. Microlens arrays are used to maintain high fill factor of greater than 70%. We present full-array performance maps for two different types of sensors optimized for operation at 1.06 μm and 1.55 μm, respectively. For the 1.06 μm FPAs, overall photon detection efficiency of >40% is achieved at <20 kHz dark count rates with modest cooling to ~250 K using integrated thermoelectric coolers. We also describe the first evalution of these FPAs when multi-photon pulses are incident on single pixels. The effective detection efficiency for multi-photon pulses shows excellent agreement with predictions based on Poisson statistics. We also characterize the crosstalk as a function of pulse mean photon number. Relative to the intrinsic crosstalk contribution from hot carrier luminescence that occurs during avalanche current flows resulting from single incident photons, we find a modest rise in crosstalk for multi-photon incident pulses that can be accurately explained by direct optical scattering.

InP-based Geiger-mode avalanche photodiode arrays for three-dimensional imaging at 1.06 μm

We report on the development of 32 x 32 focal plane arrays (FPAs) based on InGaAsP/InP Geiger-mode avalanche photodiodes (GmAPDs) designed for use in three-dimensional (3-D) laser radar imaging systems at 1064 nm. To our knowledge, this is the first realization of FPAs for 3-D imaging that employ a planar-passivated buried-junction InP-based GmAPD device platform. This development also included the design and fabrication of custom readout integrate circuits (ROICs) to perform avalanche detection and time-of-flight measurements on a per-pixel basis. We demonstrate photodiode arrays (PDAs) with a very narrow breakdown voltage distribution width of 0.34 V, corresponding to a breakdown voltage total variation of less than +/- 0.2%. At an excess bias voltage of 3.3 V, which provides 40% pixel-level single photon detection efficiency, we achieve average dark count rates of 2 kHz at an operating temperature of 248 K. We present the characterization of optical crosstalk induced by hot carrier luminescence during avalanche events, where we show that the worst-case crosstalk probability per pixel, which occurs for nearest neighbors, has a value of less than 1.6% and exhibits anisotropy due to isolation trench etch geometry. To demonstrate the FPA response to optical density variations, we show a simple image of a broadened optical beam.

Geiger-mode APD camera system for single-photon 3D LADAR imaging

The unparalleled sensitivity of 3D LADAR imaging sensors based on single photon detection provides substantial benefits for imaging at long stand-off distances and minimizing laser pulse energy requirements. To obtain 3D LADAR images with single photon sensitivity, we have demonstrated focal plane arrays (FPAs) based on InGaAsP Geiger-mode avalanche photodiodes (GmAPDs) optimized for use at either 1.06 μm or 1.55 μm. These state-of-the-art FPAs exhibit excellent pixel-level performance and the capability for 100% pixel yield on a 32 x 32 format. To realize the full potential of these FPAs, we have recently developed an integrated camera system providing turnkey operation based on FPGA control. This system implementation enables the extremely high frame-rate capability of the GmAPD FPA, and frame rates in excess of 250 kHz (for 0.4 μs range gates) can be accommodated using an industry-standard CameraLink interface in full configuration. Real-time data streaming for continuous acquisition of 2 μs range gate point cloud data with 13-bit time-stamp resolution at 186 kHz frame rates has been established using multiple solid-state storage drives. Range gate durations spanning 4 ns to 10 μs provide broad operational flexibility. The camera also provides real-time signal processing in the form of multi-frame gray-scale contrast images and single-frame time-stamp histograms, and automated bias control has been implemented to maintain a constant photon detection efficiency in the presence of ambient temperature changes. A comprehensive graphical user interface has been developed to provide complete camera control using a simple serial command set, and this command set supports highly flexible end-user customization.

InP-Based Single-Photon Detectors and Geiger-Mode APD Arrays for Quantum Communications Applications

To meet the increasing demand from quantum communications and other photon starved applications, we have developed various InP-based single-photon detectors, including discrete single-photon avalanche diodes (SPADs), negative feedback avalanche diodes (NFADs), and Geiger-mode avalanche photodiode (GmAPD) arrays. A large quantity of InP SPADs have been fabricated. Out of 1000 devices with a 25-μm active area diameter, operated under gated mode at temperature of 233 K, with a pulse repetition rate of 1 MHz and pulse width of 1 ns, the average dark count rate and afterpulsing probability are 30 kHz and 8 × 10-5, respectively. Smaller (16-μm active area diameter) and larger (40-μm active area diameter) discrete devices have been fabricated as well, and their performances are presented along with the 25-μm diameter devices. NFAD devices can operate in free running mode and photon detection efficiency of 10-15% can be achieved without applying any hold-off time externally. When the temperature decreases from 240 to 160 K, the noise equivalent power (NEP) decreasesfrom1.9 × 10-16 to 1.8 × 10-18WHz-1/2, with the activation energy being 0.2 eV. The very low NEP at 160 K makes NFAD devices an ideal choice for long distance, entanglement-based quantum key distributions. GmAPD arrays provide an enabling technology for many active optical applications, such as 3-D laser detection and ranging (LADAR) and photon starved optical communications. Both 32 × 32 and 128 × 32 GmAPD arrays have been fabricated with high performance and good uniformity. GmAPD focal plane arrays (FPAs) with framed readout mode have enabled very high-performance flash LADAR systems. GmAPD FPAs with asynchronous readout mode will enable high rate quantum key distributions and other quantum communications applications.

Comparison of 32 x 128 and 32 x 32 Geiger-mode APD FPAs for single photon 3D LADAR imaging

We present results obtained from 3D imaging focal plane arrays (FPAs) employing planar-geometry InGaAsP/InP Geiger-mode avalanche photodiodes (GmAPDs) with high-efficiency single photon sensitivity at 1.06 μm. We report results obtained for new 32 x 128 format FPAs with 50 μm pitch and compare these results to those obtained for 32 x 32 format FPAs with 100 μm pitch. We show excellent pixel-level yield-including 100% pixel operability-for both formats. The dark count rate (DCR) and photon detection efficiency (PDE) performance is found to be similar for both types of arrays, including the fundamental DCR vs. PDE tradeoff. The optical crosstalk due to photon emission induced by pixel-level avalanche detection events is found to be qualitatively similar for both formats, with some crosstalk metrics for the 32 x 128 format found to be moderately elevated relative to the 32 x 32 FPA results. Timing jitter measurements are also reported for the 32 x 128 FPAs.

Design and performance of single photon APD focal plane arrays for 3-D LADAR imaging

×We describe the design, fabrication, and performance of focal plane arrays (FPAs) for use in 3-D LADAR imaging applications requiring single photon sensitivity. These 32 × 32 FPAs provide high-efficiency single photon sensitivity for three-dimensional LADAR imaging applications at 1064 nm. Our GmAPD arrays are designed using a planarpassivated avalanche photodiode device platform with buried p-n junctions that has demonstrated excellent performance uniformity, operational stability, and long-term reliability. The core of the FPA is a chip stack formed by hybridizing the GmAPD photodiode array to a custom CMOS read-out integrated circuit (ROIC) and attaching a precision-aligned GaP microlens array (MLA) to the back-illuminated detector array. Each ROIC pixel includes an active quenching circuit governing Geiger-mode operation of the corresponding avalanche photodiode pixel as well as a pseudo-random counter to capture per-pixel time-of-flight timestamps in each frame. The FPA has been designed to operate at frame rates as high as 186 kHz for 2 μs range gates. Effective single photon detection efficiencies as high as 40% (including all optical transmission and MLA losses) are achieved for dark count rates below 20 kHz. For these planar-geometry diffused-junction GmAPDs, isolation trenches are used to reduce crosstalk due to hot carrier luminescence effects during avalanche events, and we present details of the crosstalk performance for different operating conditions. Direct measurement of temporal probability distribution functions due to cumulative timing uncertainties of the GmAPDs and ROIC circuitry has demonstrated a FWHM timing jitter as low as 265 ps (standard deviation is ~100 ps).

Geiger-mode APD single-photon cameras for 3D laser radar imaging

We describe the design and performance of short-wave infrared 3D imaging cameras with focal plane arrays (FPAs) based on Geiger-mode avalanche photodiodes (GmAPDs) with single photon sensitivity for laser radar imaging applications. The FPA pixels incorporate InP/InGaAs(P) GmAPDs for the detection of single photons with high efficiency and low dark count rates. Based on the design of the GmAPD detectors, FPAs have been optimized for source wavelengths near either 1.0 μm or 1.5 μm. We present results and attributes of fully integrated camera sub-systems with 32 × 32 and 128 × 32 formats, which have 100 μm pitch and 50 μm pitch, respectively. We also address the sensitivity of the fundamental GmAPD detectors to radiation exposure, including recent results that correlate detector active region volume to sustainable radiation tolerance levels. For GmAPD detector designs that are compatible with our existing FPA platform, these discrete device results indicate that sensors with our current level of performance can be designed to tolerate radiation exposure of at least 8 krad with acceptable levels of dark count rate elevation.

SWIR Geiger-mode APD detectors and cameras for 3D imaging

The operation of avalanche photodiodes in Geiger mode by arming these detectors above their breakdown voltage provides high-performance single photon detection in a robust solid-state device platform. Moreover, these devices are ideally suited for integration into large format focal plane arrays enabling single photon imaging. We describe the design and performance of short-wave infrared 3D imaging cameras with focal plane arrays (FPAs) based on Geigermode avalanche photodiodes (GmAPDs) with single photon sensitivity for laser radar imaging applications. The FPA pixels incorporate InP/InGaAs(P) GmAPDs for the detection of single photons with high efficiency and low dark count rates. We present results and attributes of fully integrated camera sub-systems with 32 × 32 and 128 × 32 formats, which have 100 μm pitch and 50 μm pitch, respectively. We also address the sensitivity of the fundamental GmAPD detectors to radiation exposure, including recent results that correlate detector active region volume to sustainable radiation tolerance levels.

Short Wave Infrared Wavelength (SWIR) Applications in Industrial Optics: Drivers and Challenges

Entrepreuners in the optics industry generally need to focus their talent, capital and mindshare on specific technologies and products. In many cases, this is driven by the choice of wavelengths that the business would need to focus on. This talk discusses drivers, challenges and case studies for SWIR applications in various industrial arenas.

Spatially resolved spectral imaging of pharmaceutical powders

Pharmaceutical initiatives use analytical tools to monitor powders flowing through granulating, blending, and tablet formation steps. Two critical parameters that drive the quality and efficiency of drugs are the concentration of actives in the tablet, and the dissolution properties of the tablet. In order to ensure that these are within the target design space, it is important that component concentrations, particle size distributions, and cluster size are monitored throughout the manufacturing process. Standard optical techniques detect scattered light from spots that encompass many components in the blend. Efforts to extract composition and blend uniformity based on chemometric analyses are complex and often intractable. A highly spatially resolved spectral imager could simplify the chemometrics if the effective spatial resolution can separate most particles from neighboring particles. The effective spatial resolution is a function of the incident spot size, multiple scattering events, and the collection optics. This paper assesses the degree of spectral mixing due to particle-particle scattering as a function of incident spot size. Our real-time optical design is enabled by a high spectral brightness supercontinuum source, a MEMs-based spectral scan mechanism, confocal spatial scanning optics, and high gain * bandwidth detection.