Samar Mansour

Liposomes as an Ocular Delivery System for Acetazolamide: In Vitro and In Vivo Studies

The purpose of this study was to formulate topically effective controlled release ophthalmic acetazolamide liposomal formulations. Reverse-phase evaporation and lipid film hydration methods were used for the preparation of reversephase evaporation (REVs) and multilamellar (MLVs) acetazolamide liposomes consisting of egg phosphatidylcholine (PC) and cholesterol (CH) in the molar ratios of (7∶2), (7∶4), (7∶6), and (7∶7) with or without stearylamine (SA) or dicetyl phosphate (DP) as positive and negative charge inducers, respectively. The prepared liposomes were evaluated for their entrapment efficiency and in vitro release. Multilamellar liposomes entrapped greater amounts of drug than REVs liposomes. Drug loading was increased by increasing CH content as well as by inclusion of SA. Drug release rate showed an order of negatively charged > neutral > positively charged liposomes, which is the reverse of the data of drug loading efficiency. Physical stability study indicated that approximately 89%, 77%, and 69% of acetazolamide was retained in positive, negative, and neutral MLVs liposomal formulations up to a period of 3 months at 4°C. The intraocular pressure (IOP)-lowering activity of selected acetazolamide liposomal formulations was determined and compared with that of plain liposomes and acetazolamide solution. Multilamellar acetazolamide liposomes revealed more prolonged effect than REVs liposomes. The positively charged and neutral liposomes exhibited greater lowering in IOP and a more prolonged effect than the negatively charged ones. The positive multilamellar liposomes composed of PC:CH:SA (7:4:1) molar ratio showed the maximal response, which reached a value of −7.8±1.04 mmHg after 3 hours of topical administration.

Microemulsion formulations for the transdermal delivery of testosterone

The objective was to develop a microemulsion formulation for the transdermal delivery of testosterone. Microemulsion formulations were prepared using oleic acid as the oil phase, Tween20 as a surfactant, Transcutol as cosurfactant, and water. The microemulsions were characterized visually, with the polarizing microscope, and by dynamic light scattering. In addition, the pH, conductivity (sigma) and viscosity (eta) of the formulations were measured. Moreover, differential scanning calorimetry and diffusion-ordered nuclear magnetic resonance spectroscopy were used to study the formulations investigated. Conductivity measurements revealed, as a function of the weight fraction of the aqueous phase, the point at which the microemulsion made the transition from water-in-oil to bicontinuous. Alterations in the microstructure of the microemulsions, following incorporation of testosterone, have been evaluated using the same physical parameters (pH, sigma and eta) and via Fourier-transform infrared spectroscopy (FT-IR), (1)H NMR and (13)C NMR. These methods were also used to determine the location of the drug in the colloidal formulation. Finally, testosterone delivery from selected formulations was assessed across porcine skin in vitro in Franz diffusion cells. The physical parameter determinations, combined with the spectroscopic studies, demonstrated that the drug was principally located in the oily domains of the microemulsions. Testosterone was delivered successfully across the skin from the microemulsions examined, with the highest flux achieved (4.6+/-0.6microgcm(-2)h(-1)) from a formulation containing 3% (w/v) of the active drug and the composition (w/w) of 16% oleic acid, 32% Tween20, 32% Transcutol and 20% water. The microemulsions considered offer potentially useful vehicles for the transdermal delivery of testosterone.

Vesicular aceclofenac systems: A comparative study between liposomes and niosomes

Vesicular delivery systems have been reported to serve as local depot for sustained drug release. Aceclofenac multilamellar liposomes and niosomes were prepared and a comparative study was done between them through evaluation of entrapment efficiency, particle size, shape, differential scanning calorimetry and in vitro drug release. A stability study was carried out by investigating the leakage of aceclofenac and the change in the vesicles particle size when stored at (2–8°C) for 3 months. The anti-inflammatory effect of aceclofenac vesicles was assessed by the rat paw oedema technique. Results showed that the entrapment efficiency and the in vitro release of aceclofenac from the vesicles can be manipulated by varying the cholesterol content, the type of surfactant as well as the type of charge. Niosomes showed better stability than liposomes. Both vesicular systems showed significant sustained anti-inflammatory activity compared to the marketed product, with niosomes being superior to liposomes as manifested by both oedema rate and inhibition rate percentages suggesting their effectiveness as topical anti-inflammatory delivery systems.

Uptake of Microemulsion Components into the Stratum Corneum and Their Molecular Effects on Skin Barrier Function

This research determined the uptake of individual components of topically applied microemulsions into the stratum corneum (SC) and assessed their molecular effects on skin barrier function. The microemulsions comprised oleic acid, Tween20, Transcutol and water. The effects of selected formulations, and of the individual components, on the conformational order of the SC intercellular lipids, and on SC hydration, were assessed by infrared spectroscopy. Measurements were made as a function of SC depth by progressively tape-stripping the membrane in the normal way. SC uptake of microemulsion components was quantified via extraction and analysis of the collected tape strips. SC hydration increased in proportion to the water content of the microemulsion. Each of the microemulsion components penetrated into the SC, but to different extents. Oleic acid decreased the conformational order of the SC lipids, and induced some phase separation, as revealed by the frequency shifts and peak areas of the absorbances associated with -CH(2) symmetric and asymmetric stretching vibrations. Tween20 extracted some of the SC intercellular lipids. In summary, SC structure was perturbed by all components of the microemulsions, and the degree of the effects detected was proportional to the level of the respective component present in the skin.

Chitosan and cyclodextrin in intranasal microemulsion for improved brain buspirone hydrochloride pharmacokinetics in rats

The aim of this study was to develop buspirone hydrochloride microemulsion formulations for intranasal administration to improve the drug bioavailability and provide high drug brain levels. For the purpose, chitosan aspartate, and hydroxypropyl-β-cyclodextrin were incorporated in the microemulsions. The prepared formulations were characterized. Biological investigations including pharmacokinetic studies, brain drug targeting efficiency determinations and histopathological examinations were performed on rats. The results showed that safe and stable mucoadhesive microemulsion suitable for nasal administration were successfully prepared. Ex vivo drug permeation revealed high drug permeation from microemulsions. Absolute bioavailability after intranasal administration of buspirone mucoadhesive microemulsion increased significantly and plasma concentration peaked at 15 min. The AUC0-360(brain) was 3 times that obtained after intravenous administration. A high brain targeting efficiency (86.6%) and a direct nose to brain transport (88%) confirmed the direct nose to brain transport of buspirone following nasal administration of the microemulsions.

Exploring the use of nanocarrier systems to deliver the magical molecule; Curcumin and its derivatives.

Curcumin and its derivatives; curcuminoids have been proven as potential remedies in different diseases. However, their delivery carries several challenges owing to their poor aqueous solubility, photodegradation, chemical instability, poor bioavailability and rapid metabolism. This review explores and criticizes the numerous attempts that were adopted through the years to entrap/encapsulate this valuable drug in nanocarriers aiming to reach its most appropriate and successful delivery system.

Ocular Poloxamer-Based Ciprofloxacin Hydrochloride In Situ Forming Gels

The purpose of this study was to develop poloxamer-based in situ gelling formulations of ciprofloxacin hydrochloride (HCl) aiming at prolonging corneal contact time, controlling drug release, enhancing ocular bioavailability, and increasing patient compliance. The in situ forming gels were prepared using different concentrations of poloxamer 407 (P407) and poloxamer 188 (P188). Mucoadhesives such as hydroxypropylmethyl cellulose (HPMC) or hydroxyethyl cellulose (HEC) were added to the formulations to enhance the gel bioadhesion properties. The prepared formulations were evaluated for their in vitro drug release, sol–gel transition temperature, rheological behavior, and mucoadhesion force. The in vivo antimicrobial efficacy of selected ciprofloxacin HCl in situ gelling formulations was studied on infected rabbits eyes and compared with that of the marketed conventional eye drops. The gelation temperature of the prepared formulations ranged from 28.00 to 34.03°C. Increasing the concentrations of P407, HPMC, and HEC increased the viscosity and mucoadhesion force of the preparations and decreased the in vitro drug release. Ciprofloxacin HCl in situ forming gel formulae composed of P407/P188/HPMC (18/13/1.5%, wt/wt), and P407/P188/HEC (18/13/0.5%, wt/wt) showed optimum release and mucoadhesion properties and improved ocular bioavailability as evidenced by an enhanced therapeutic response compared with the marketed conventional eye drops.

Visualization, dermatopharmacokinetic analysis and monitoring the conformational effects of a microemulsion formulation in the skin stratum corneum

The use of nano-systems such as the microemulsions is considered as an increasingly implemented strategy in order to enhance the percutaneous transport into and across the skin barrier. The determination of the major pathway of penetration and the mechanisms by which these formulations work remains crucial. In this study, laser confocal scanning microscopy was used to visualize the penetration and the distribution of a fluorescently-labelled microemulsion (using 0.1% w/v Nile red) consisting of (%, w/w) 15.4% oleic acid, 30.8% Tween 20, 30.8% Transcutol® and 23% water. The surface images revealed that the microemulsion accumulated preferentially in the intercellular domains of the stratum corneum. Additionally, by analysis of the images taken across the whole stratum corneum (SC), the penetration was found to occur along its whole depth. The latter result was confirmed using tape stripping and the subsequent sensitive analysis using liquid chromatography mass spectroscopy. Dermatopharmacokinetic parameters were obtained for the microemulsion different components. These values proved the breakage of the microemulsion during its penetration across the stratum corneum. Moreover, the mechanisms of penetration enhancement and the micro molecular effects on the skin stratum corneum were investigated using attenuated Fourier transform infra-red spectroscopy. The results revealed the penetration of all the microemulsion components in the stratum corneum and demonstrated the microemulsion interaction with the skin barrier perturbing its architecture structure.

Release Mechanisms Behind Polysaccharides-Based Famotidine Controlled Release Matrix Tablets

Polysaccharides, which have been explored to possess gelling properties and a wide margin of safety, were used to formulate single-unit floating matrix tablets by a direct compression technique. This work has the aim to allow continuous slow release of famotidine above its site of absorption. The floating approach was achieved by the use of the low density polypropylene foam powder. Polysaccharides (κ-carrageenan, gellan gum, xyloglucan, and pectin) and blends of polysaccharides (κ-carrageenan and gellan gum) and cellulose ethers (hydroxypropylmethyl cellulose, hydroxypropylcellulose, sodium carboxymethyl cellulose) were tried to modulate the release characteristics. The prepared floating tablets were evaluated for their floating behavior, matrix integrity, swelling studies, in vitro drug release studies, and kinetic analysis of the release data. The differential scanning calorimetry and Fourier transform infrared spectroscopy studies revealed that changing the polymer matrix system by formulation of polymers blends resulted in formation of molecular interactions which may have implications on drug release characteristics. This was obvious from the retardation in drug release and change in its mechanistics.

Bioavailability enhancement of verapamil HCl via intranasal chitosan microspheres

Chitosan microspheres are potential drug carriers for maximizing nasal residence time, circumventing rapid mucociliary clearance and enhancing nasal absorption. The aim of the present study was to develop and characterize chitosan mucoadhesive microspheres of verapamil hydrochloride (VRP) for intranasal delivery as an alternative to oral VRP which suffers low bioavailability (20%) due to extensive first pass effect. The microspheres were produced using a spray-drying and precipitation techniques and characterized for morphology (scanning electron microscopy), particle size (laser diffraction method), drug entrapment efficiency, thermal behavior (differential scanning calorimetry) and crystallinity (X-ray diffractometric studies) as well as in vitro drug release. Bioavailability of nasal VRP microspheres was studied in rabbits and the results were compared to those obtained after nasal, oral and intravenous administration of VRP solution. Results demonstrated that the microspheres were spherical with size 21-53 μm suitable for nasal deposition. The spray-drying technique was superior over precipitation technique in providing higher VRP entrapment efficiency and smaller burst release followed by a more sustained one over 6h. The bioavailability study demonstrated that the nasal microspheres exhibited a significantly higher bioavailability (58.6%) than nasal solution of VRP (47.8%) and oral VRP solution (13%). In conclusion, the chitosan-based nasal VRP microspheres are promising for enhancing VRP bioavailability by increasing the nasal residence time and avoiding the first-pass metabolism of the drug substance.