Stuart W. Krasner

Occurrence of disinfection byproducts in United States wastewater treatment plant effluents

Effluents from wastewater treatment plants (WWTPs) contain disinfection byproducts (DBPs) of health concern when the water is utilized downstream as a potable water supply. The pattern of DBP formation was strongly affected by whether or not the WWTP achieved good nitrification. Chlorine addition to poorly nitrified effluents formed low levels of halogenated DBPs, except for (in some cases) dihalogenated acetic acids, but often substantial amounts of N-nitrosodimethyamine (NDMA). Chlorination of well-nitrified effluent typically resulted in substantial formation of halogenated DBPs but much less NDMA. For example, on a median basis after chlorine addition, the well-nitrified effluents had 57 microg/L of trihalomethanes [THMs] and 3 ng/L of NDMA, while the poorly nitrified effluents had 2 microg/L of THMs and 11 ng/L of NDMA. DBPs with amino acid precursors (haloacetonitriles, haloacetaldehydes) formed at substantial levels after chlorination of well-nitrified effluent. The formation of halogenated DBPs but not that of NDMA correlated with the formation of THMs in WWTP effluents disinfected with free chlorine. However, THM formation did not correlate with the formation of other DBPs in effluents disinfected with chloramines. Because of the relatively high levels of bromide in treated wastewater, bromine incorporation was observed in various classes of DBPs.

Formation, precursors, control, and occurrence of nitrosamines in drinking water: A review

This review summarizes major findings over the last decade related to nitrosamines in drinking water, with a particular focus on N-nitrosodimethylamine (NDMA), because it is among the most widely detected nitrosamines in drinking waters. The reaction of inorganic dichloramine with amine precursors is likely the dominant mechanism responsible for NDMA formation in drinking waters. Even when occurrence surveys found NDMA formation in chlorinated drinking waters, it is unclear whether chloramination resulted from ammonia in the source waters. NDMA formation has been associated with the use of quaternary amine-based coagulants and anion exchange resins, and wastewater-impaired source waters. Specific NDMA precursors in wastewater-impacted source waters may include tertiary amine-containing pharmaceuticals or other quaternary amine-containing constituents of personal care products. Options for nitrosamine control include physical removal of precursors by activated carbon or precursor deactivation by application of oxidants, particularly ozone or chlorine, upstream of chloramination. Although NDMA has been the most prevalent nitrosamine detected in worldwide occurrence surveys, it may account for only ≈ 5% of all nitrosamines in chloraminated drinking waters. Other significant contributors to total nitrosamines are poorly characterized. However, high levels of certain low molecular weight nitrosamines have been detected in certain Chinese waters suspected to be impaired by industrial effluents. The review concludes by identifying research needs that should be addressed over the next decade.

Precursors of Dichloroacetamide, an Emerging Nitrogenous DBP Formed during Chlorination or Chloramination

Haloacetamides (HAcAms) are an emerging class of nitrogenous disinfection byproducts (N-DBPs). However, there is a limited understanding about the precursors of HAcAms. In this study, we screened the precursors of dichloroacetamide (DCAcAm), the most commonly identified HAcAm in chlorinated or chloraminated drinking water. DCAcAm formation potential (FP) of raw water samples collected in different months from a reservoir in China was determined during chlorination, and the highest DCAcAm FP typically occurred in the summer samples. Dissolved organic matter (DOM) in a representative summer raw water sample was separated into six fractions by a series of resin elutions. Among them, hydrophilic acid (HiA) DOM showed the maximum DCAcAm FP, followed by hydrophilic bases (HiB) and, to a much lower extent, hydrophobic acids (HoA). Fluorescence excitation-emission matrix (EEM) spectra revealed that a mass of protein-like substances in the HiA fraction, made up of amino acids (AAs), were the likely DCAcAm precursors. Finally, we investigated the DCAcAm yields of 20 AAs during chlorination. Among them, seven AAs (aspartic acid, histidine, tyrosine, tryptophan, glutamine, asparagine, phenylalanine) could form DCAcAm during chlorination, with the corresponding DCAcAm yields of 0.231, 0.189, 0.153, 0.104, 0.078, 0.058, and 0.050 mmol/mol AA.

A comparison of disinfection by-products found in chlorinated and chloraminated drinking waters in Scotland.

Seven water treatment works were selected to compare disinfection by-products (DBPs) formed when using chlorination and chloramination. DBPs measured included trihalomethanes (THMs), haloacetic acids (HAAs), haloacetonitriles (HANs), trihalonitromethane, iodinated THMs and nitrosamines. Generally treatment works that used chloramination were able to meet the European THM regulatory limit of 100 microg L(-1) whereas the chlorinated works found it significantly more difficult. There were no significant differences in the levels of nitrogenous DBPs between the treatment works using chlorination or chloramination with the exception of the nitrosamine N-nitrosodimethylamine (NDMA) which was present at one treatment works in one season.

Nitrogen enriched dissolved organic matter (DOM) isolates and their affinity to form emerging disinfection by-products.

Increased contributions from wastewater discharges and algal activity in drinking water supplies can lead to elevated levels of dissolved organic nitrogen (DON), which can increase the likelihood for the formation of emerging nitrogenous disinfection by-products (N-DBPs) of health concern. Dissolved organic matter (DOM) isolated from five waters, using a newly developed DOM isolation method specific to DON fractionation, produced thirty-four isolates of suitable mass. Each isolate was treated with free chlorine or chloramines under formation potential conditions. The DBP yields were determined for three halogenated DBPs (trichloromethane, dichloroacetonitrile, and trichloronitromethane) and one non-halogenated DBP (N-nitrosodimethylamine [NDMA]). Halogenated DBP yields were greater during the application of free chlorine, however chloramination produced significant levels of halogenated N-DBPs for some isolates. NDMA was only observed to form from selected nitrogen-enriched isolates (DOC/DON ratio < 20 mg/mg), especially those isolated from treated wastewater. Other results indicated that nitrogen-enriched DOM resulted in increased yields of the other N-DBPs studied.

Trade-Offs in Disinfection Byproduct Formation Associated with Precursor Preoxidation for Control of N-Nitrosodimethylamine Formation

Chloramines in drinking water may form N-nitrosodimethylamine (NDMA). Various primary disinfectants can deactivate NDMA precursors prior to chloramination. However, they promote the formation of other byproducts. This study compared the reduction in NDMA formation due to chlorine, ozone, chlorine dioxide, and UV over oxidant exposures relevant to Giardia control coupled with postchloramination under conditions relevant to drinking water practice. Ten waters impacted by treated wastewater, poly(diallyldimethylammonium chloride) (polyDADMAC) polymer, or anion exchange resin were examined. Ozone reduced NDMA formation by 50% at exposures as low as 0.4 mg×min/L. A similar reduction in NDMA formation by chlorination required ∼60 mg×min/L exposure. However, for some waters, chlorination actually increased NDMA formation at lower exposures. Chlorine dioxide typically had limited efficacy regarding NDMA precursor destruction; moreover, it increased NDMA formation in some cases. UV decreased NDMA formation by ∼30% at fluences >500 mJ/cm(2), levels relevant to advanced oxidation. For the selected pretreatment oxidant exposures, concentrations of regulated trihalomethanes, haloacetic acids, bromate, and chlorite typically remained below current regulatory levels. Chloropicrin and trichloroacetaldehyde formation were increased by preozonation or medium pressure UV followed by postchloramination. Among preoxidants, ozone achieved the greatest reduction in NDMA formation at the lowest oxidant exposure associated with each disinfectant. Accordingly, preozonation may inhibit NDMA formation with minimal risk of promotion of other byproducts. Bromide >500 μg/L generally increased NDMA formation during chloramination. Higher temperatures increased NDMA precursor destruction by preoxidants but also increased NDMA formation during postchloramination. The net effect of these opposing trends on NDMA formation was water-specific.

Integrated Disinfection By-Products Mixtures Research: Comprehensive Characterization of Water Concentrates Prepared from Chlorinated and Ozonated/Postchlorinated Drinking Water

This article describes the disinfection by-product (DBP) characterization portion of a series of experiments designed for comprehensive chemical and toxicological evaluation of two drinking-water concentrates containing highly complex mixtures of DBPs. This project, called the Four Lab Study, involved the participation of scientists from four laboratories and centers of the U.S. Environmental Protection Agency (EPA) Office of Research and Development, along with collaborators from the water industry and academia, and addressed toxicologic effects of complex DBP mixtures, with an emphasis on reproductive and developmental effects that are associated with DBP exposures in epidemiologic studies. Complex mixtures of DBPs from two different disinfection schemes (chlorination and ozonation/postchlorination) were concentrated successfully, while maintaining a water matrix suitable for animal studies. An array of chlorinated/brominated/iodinated DBPs was created. The DBPs were relatively stable over the course of the animal experiments, and a significant portion of the halogenated DBPs formed in the drinking water was accounted for through a comprehensive qualitative and quantitative identification approach. DBPs quantified included priority DBPs that are not regulated but have been predicted to produce adverse health effects, as well as those currently regulated in the United States and those targeted during implementation of the Information Collection Rule. New by-products were also reported for the first time. These included previously undetected and unreported bromo- and chloroacids, iodinated compounds, bromo- and iodophenols, and bromoalkyltins.

Formation of halogenated C-, N-DBPs from chlor(am)ination and UV irradiation of tyrosine in drinking water

The formation of regulated and emerging halogenated carbonaceous (C-) and nitrogenous disinfection by-products (N-DBPs) from the chlor(am)ination and UV irradiation of tyrosine (Tyr) was investigated. Increased chlorine contact time and/or Cl(2)/Tyr ratio increased the formation of most C-DBPs, with the exception of 4-chlorophenol, dichloroacetonitrile, and dichloroacetamideChloroform and dichloroacetic acid increased with increasing pH, dichloroacetonitrile first increased and then decreased, and other DBPs had maximum yields at pH 7 or 8. The addition of ammonia significantly reduced the formation of most C-DBPs but increased 4-chlorophenol, dichloroacetonitrile, dichloroacetamide, and trichloroacetonitrile yields for short prechlorination contact times before dosing ammonia. When UV irradiation and chlorination were performed simultaneously, the concentrations of the relatively stable C-DBPs increased, and the concentrations of dichloroacetonitrile, dichloroacetamide, and 4-chlorophenol decreased with increasing UV dose. This information was used to develop a mechanistic model for the formation of intermediate DBPs and end products from the interaction of disinfectants with tyrosine.

Trace determination of 13 haloacetamides in drinking water using liquid chromatography triple quadrupole mass spectrometry with atmospheric pressure chemical ionization

The haloacetamides (HAcAms) are disinfection by-products (DBPs) in drinking water which are currently receiving increased scientific attention due to their elevated toxicity relative to regulated disinfection by-products. A simultaneous determination method of 13 HAcAms, combining solid-phase extraction (SPE) enrichment, liquid chromatographic (LC) separation, and triple quadrupole mass spectrometry (tqMS) detection with atmospheric pressure chemical ionization (APCI) using selective reaction monitoring in positive mode, was developed to measure HAcAms, including chlorinated, brominated, and iodinated analogs. Ammonium chloride and Oasis HLB were selected as the dechlorinating reagent and polymeric SPE sorbent of HAcAm samples. The used tqMS apparatus showed higher sensitivity for the studied HAcAms in the APCI mode than electrospray ionization. 13 HAcAms were separated by LC in 9.0 min, and the detection limits ranged from 7.6 to 19.7 ng/L. The SPE-LC/tqMS method was successfully applied to quantify 13 HAcAms in drinking water samples for the first time, and first indentified tribromoacetamide and chloroiodoacetamide as DBPs in drinking water.

Adsorption of N-nitrosodimethylamine precursors by powdered and granular activated carbon.

Activated carbon (AC) has been shown to remove precursors of halogenated disinfection byproducts. Granular and powdered activated carbon (GAC, PAC) were investigated for their potential to adsorb N-nitrosodimethylamine (NDMA) precursors from blends of river water and effluent from a wastewater treatment plant (WWTP). At bench scale, waters were exposed to lignite or bituminous AC, either as PAC in bottle point experiments or as GAC in rapid small-scale column tests (RSSCTs). NDMA formation potential (FP) was used as a surrogate for precursor removal. NDMA FP was reduced by 37, 59, and 91% with 3, 8, and 75 mg/L of one PAC, respectively, with a 4-h contact time. In RSSCTs and in full-scale GAC contactors, NDMA FP removal always exceeded that of the bulk dissolved organic carbon (DOC) and UV absorbance at 254 nm. For example, whereas DOC breakthrough exceeded 90% of its influent concentration after 10,000 bed volumes of operation in an RSSCT, NDMA FP was less than 40% of influent concentration after the same bed life of the GAC. At full or pilot scale, high NDMA FP reduction ranging from >60 to >90% was achieved across GAC contactors, dependent upon the GAC bed life and/or use of a preoxidant (chlorine or ozone). In all experiments, NDMA formation was not reduced to zero, which suggests that although some precursors are strongly sorbed, others are not. This is among the first studies to show that AC is capable of adsorbing NDMA precursors, but further research is needed to better understand NDMA precursor chemical properties (e.g., hydrophobicity, molecular size) and evaluate how best to incorporate this finding into full-scale designs and practice.