Takashi Funatsu

Intracellular temperature mapping with a fluorescent polymeric thermometer and fluorescence lifetime imaging microscopy

Cellular functions are fundamentally regulated by intracellular temperature, which influences biochemical reactions inside a cell. Despite the important contributions to biological and medical applications that it would offer, intracellular temperature mapping has not been achieved. Here we demonstrate the first intracellular temperature mapping based on a fluorescent polymeric thermometer and fluorescence lifetime imaging microscopy. The spatial and temperature resolutions of our thermometry were at the diffraction limited level (200 nm) and 0.18–0.58 °C. The intracellular temperature distribution we observed indicated that the nucleus and centrosome of a COS7 cell, both showed a significantly higher temperature than the cytoplasm and that the temperature gap between the nucleus and the cytoplasm differed depending on the cell cycle. The heat production from mitochondria was also observed as a proximal local temperature increase. These results showed that our new intracellular thermometry could determine an intrinsic relationship between the temperature and organelle function.

Simultaneous observation of individual ATPase and mechanical events by a single myosin molecule during interaction with actin

We have developed a technique that allows mechanical and ligand-binding events in a single myosin molecule to be monitored simultaneously. We describe how steps in the ATPase reaction are temporally related to mechanical events at the single molecule level. The results show that the force generation does not always coincide with the release of bound nucleotide, presumably ADP. Instead the myosin head produces force several hundreds of milliseconds after bound nucleotide is released. This finding does not support the widely accepted view that force generation is directly coupled to the release of bound ligands. It suggests that myosin has a hysteresis or memory state, which stores chemical energy from ATP hydrolysis.

Microscopic analysis of polymerization dynamics with individual actin filaments.

The polymerization–depolymerization dynamics of actin is a key process in a variety of cellular functions. Many spectroscopic studies have been performed in solution, but studies on single actin filaments have just begun. Here, we show that the time course of polymerization of individual filaments consists of a polymerization phase and a subsequent steady-state phase. During the steady-state phase, a treadmilling process of elongation at the barbed end and shortening at the pointed end occurs, in which both components of the process proceed at approximately the same rate. The time correlation of length fluctuation of the filaments in the steady-state phase showed that the polymerization–depolymerization dynamics follow a diffusion (stochastic) process, which cannot be explained by simple association and dissociation of monomers at both ends of the filaments.

Hydrophilic Fluorescent Nanogel Thermometer for Intracellular Thermometry

The first methodology to measure intracellular temperature is described. A highly hydrophilic fluorescent nanogel thermometer developed for this purpose stays in the cytoplasm and emits stronger fluorescence at a higher temperature. Thus, intracellular temperature variations associated with biological processes can be monitored by this novel thermometer with a temperature resolution of better than 0.5 degrees C.

Single-Molecule Imaging of RNA Polymerase-DNA Interactions in Real Time

Using total internal reflection fluorescence microscopy, we have directly observed individual interactions of single RNA polymerase molecules with a single molecule of lambda-phage DNA suspended in solution by optical traps. The interactions of RNA polymerase molecules were not homogeneous along DNA. They dissociated slowly from the positions of the promoters and sequences common to promoters at a rate of approximately 0.66 s-1, which was more than severalfold smaller than the rate at other positions. The association rate constant for the slow dissociation sites was 9.2 x 10(2) bp-1 M-1 s-1. The frequency of binding to the fast dissociation sites was dependent on the A-T composition; it was larger in the AT-rich regions than in the GC-rich regions. RNA polymerase molecules on the fast dissociation sites underwent linear diffusion (sliding) along DNA. The binding to the slow dissociation sites was greatly enhanced when DNA was released to a relaxed state, suggesting that the binding depended on the strain exerted on the DNA. The present method is potentially applicable to the examination of a wide variety of protein-nucleic acid interactions, especially those involved in the process of transcription.

Multiple- and single-molecule analysis of the actomyosin motor by nanometer-piconewton manipulation with a microneedle: unitary steps and forces.

We have developed a new technique for measurements of piconewton forces and nanometer displacements in the millisecond time range caused by actin-myosin interaction in vitro by manipulating single actin filaments with a glass microneedle. Here, we describe in full the details of this method. Using this method, the elementary events in energy transduction by the actomyosin motor, driven by ATP hydrolysis, were directly recorded from multiple and single molecules. We found that not only the velocity but also the force greatly depended on the orientations of myosin relative to the actin filament axis. Therefore, to avoid the effects of random orientation of myosin and association of myosin with an artificial substrate in the surface motility assay, we measured forces and displacements by myosin molecules correctly oriented in single synthetic myosin rod cofilaments. At a high myosin-to-rod ratio, large force fluctuations were observed when the actin filament interacted in the correct orientation with a cofilament. The noise analysis of the force fluctuations caused by a small number of heads showed that the myosin head generated a force of 5.9 +/- 0.8 pN at peak and 2.1 +/- 0.4 pN on average over the whole ATPase cycle. The rate constants for transitions into (k+) and out of (k-) the force generation state and the duty ratio were 12 +/- 2 s-1, and 22 +/- 4 s-1, and 0.36 +/- 0.07, respectively. The stiffness was 0.14 pN nm-1 head-1 for slow length change (100 Hz), which would be approximately 0.28 pN nm-1 head-1 for rapid length change or in rigor. At a very low myosin-to-rod ratio, distinct actomyosin attachment, force generation (the power stroke), and detachment events were directly detected. At high load, one power stroke generated a force spike with a peak value of 5-6 pN and a duration of 50 ms (k(-)-1), which were compatible with those of individual myosin heads deduced from the force fluctuations. As the load was reduced, the force of the power stroke decreased and the needle displacement increased. At near zero load, the mean size of single displacement spikes, i.e., the unitary steps caused by correctly oriented myosin, which were corrected for the stiffness of the needle-to-myosin linkage and the randomizing effect by the thermal vibration of the needle, was approximately 20 nm.

Infrared laser-mediated gene induction in targeted single cells in vivo.

We developed infrared laser–evoked gene operator (IR-LEGO), a microscope system optimized for heating cells without photochemical damage. Infrared irradiation causes reproducible temperature shifts of the in vitro microenvironment in a power-dependent manner. When applied to living Caenorhabditis elegans, IR-LEGO induced heat shock–mediated expression of transgenes in targeted single cells in a more efficient and less deleterious manner than a 440-nm dye laser and elicited physiologically relevant phenotypic responses.

Single-molecule observation of protein-protein interactions in the chaperonin system.

We have analyzed the dynamics of the chaperonin (GroEL)–cochaperonin (GroES) interaction at the single-molecule level. In the presence of ATP and non-native protein, binding of GroES to the immobilized GroEL occurred at a rate that is consistent with bulk kinetics measurements. However, the release of GroES from GroEL occurred after a lag period (∼3 s) that was not recognized in earlier bulk-phase studies. This observation suggests a new kinetic intermediate in the GroEL–GroES reaction pathway.

A spontaneously blinking fluorophore based on intramolecular spirocyclization for live-cell super-resolution imaging

Single-molecule localization microscopy is used to construct super-resolution images, but generally requires prior intense laser irradiation and in some cases additives, such as thiols, to induce on-off switching of fluorophores. These requirements limit the potential applications of this methodology. Here, we report a first-in-class spontaneously blinking fluorophore based on an intramolecular spirocyclization reaction. Optimization of the intramolecular nucleophile and rhodamine-based fluorophore (electrophile) provide a suitable lifetime for the fluorescent open form, and equilibrium between the open form and the non-fluorescent closed form. We show that this spontaneously blinking fluorophore is suitable for single-molecule localization microscopy imaging deep inside cells and for tracking the motion of structures in living cells. We further demonstrate the advantages of this fluorophore over existing methodologies by applying it to nuclear pore structures located far above the coverslip with a spinning-disk confocal microscope and for repetitive time-lapse super-resolution imaging of microtubules in live cells for up to 1 h.

Kinetic study of de novo chromophore maturation of fluorescent proteins

Green fluorescent protein (GFP) has a chromophore that forms autocatalytically within the folded protein. Although many studies have focused on the precise mechanism of chromophore maturation, little is known about the kinetics of de novo chromophore maturation. Here we present a simple and efficient method for examining the de novo kinetics. GFP with an immature chromophore was synthesized in a reconstituted cell-free protein synthesis system under anaerobic conditions. Chromophore maturation was initiated by rapid dilution in an air-saturated maturation buffer, and the time course of fluorescence development was monitored. Comparison of the de novo maturation rates in various GFP variants revealed that some folding mutations near the chromophore promoted rapid chromophore maturation and that the accumulation of mutations could reduce the maturation rate. Our method will contribute to the design of rapidly maturing fluorescent proteins with improved characteristics for real-time monitoring of cellular events.