Teresa M. Borges-Miquel

Ionic liquid-dispersive liquid-liquid microextraction for the simultaneous determination of pesticides and metabolites in soils using high-performance liquid chromatography and fluorescence detection.

In this work, an ionic liquid-dispersive liquid-liquid microextraction (IL-DLLME) procedure was developed for the extraction of a group of pesticides (carbendazim/benomyl, thiabendazole, fuberidazole, carbaryl and triazophos) and some of their key metabolites in soils (2-aminobenzimidazole, metabolite of carbendazim and 1-naphthol, metabolite of carbaryl) from aqueous soil extracts, using high performance liquid chromatography (HPLC) with fluorescence detection (FD). Analytes were previously extracted from four soils with different physicochemical properties (forestal, ornamental, garden and lapilli soils) by ultrasound-assisted extraction (USE). The IL 1-hexyl-3-methylimidazolium hexafluorophosphate ([HMIm][PF(6)]) and methanol (MeOH) were used as extraction and dispersion solvent, respectively, for the DLLME procedure. Factors affecting IL-DLLME (sample pH, IL amount, volume of dispersion solvent and sodium chloride percentage) were optimized by means of an experimental design, obtaining the most favorable results when using 117.5 mg of IL and 418 μL of MeOH to extract the compounds from the aqueous soil extracts at pH 5.20 containing 30% (w/v) NaCl. Calibration of the USE-IL-DLLME-HPLC-FD method was carried out for every type of soil and accuracy and precision studies were developed at two levels of concentration, finding that no significant differences existed between real and spiked concentrations (Students t test). LODs achieved were in the low ng/g range.

Dispersive liquid-liquid microextraction combined with ultra-high performance liquid chromatography for the simultaneous determination of 25 sulfonamide and quinolone antibiotics in water samples.

In this work, a dispersive liquid-liquid microextraction (DLLME) procedure combined with ultra-high performance liquid chromatography with diode-array detection was developed to determine 25 antibiotics in mineral and run-off waters. Optimum DLLME conditions (5 mL of water at pH=7.6, 20% (w/v) NaCl, 685 μL of CHCl₃ as extractant solvent, and 1250 μL of ACN as disperser solvent) allowed the repeatable, accurate and selective determination of 11 sulfonamides (sulfanilamide, sulfacetamide, sulfadiazine, sulfathiazole, sulfadimidin, sulfamethoxypyridazine, sulfadoxine, sulfamethoxazole, sulfisoxazole, sulfadimethoxine and sulfaquinoxaline) and 14 quinolones (pipemidic acid, marbofloxacin, fleroxacin, levofloxacin, pefloxacin, ciprofloxacin, lomefloxacin, danofloxacin, enrofloxacin, sarafloxacin, difloxacin, moxifloxacin, oxolinic acid and flumequine). The method was validated by means of the obtention of calibration curves of the whole method as well as a recovery study at two levels of concentration. The LODs of the method were in the range 0.35-10.5 μg/L with recoveries between 78% and 117%.

Evaluation of multi-walled carbon nanotubes as solid-phase extraction adsorbents of pesticides from agricultural, ornamental and forestal soils

A new, simple and cost-effective method based on the use of multi-walled carbon nanotubes (MWCNTs) as solid-phase extraction stationary phases is proposed for the determination of a group of seven organophosphorus pesticides (i.e. ethoprophos, diazinon, chlorpyriphos-methyl, fenitrothion, malathion, chlorpyriphos and phosmet) and one thiadiazine (buprofezin) in different kinds of soil samples (forestal, ornamental and agricultural) using gas chromatography with nitrogen phosphorus detection. Soils were first ultrasound extracted with 10 mL 1:1 methanol/acetonitrile (v/v) and the evaporated extract redissolved in 20 mL water (pH 6.0) was passed through 100 mg of MWCNTs of 10-15 nm o.d., 2-6 nm i.d. and 0.1-10 microm length. Elution was carried out with 20 mL dichloromethane. The method was validated in terms of linearity, precision, recovery, accuracy and selectivity. Matrix-matched calibration was carried out for each type of soil since statistical differences between the calibration curves constructed in pure solvent and in the reconstituted soil extract were found for most of the pesticides under study. Recovery values of spiked samples ranged between 54 and 91% for the three types of soils (limits of detection (LODs) between 2.97 and 9.49 ngg(-1)), except for chlorpyrifos, chlorpyrifos-methyl and buprofezin which ranged between 12 and 54% (LODs between 3.14 and 72.4 ngg(-1)), which are the pesticides with the highest soil organic carbon sorption coefficient (K(OC)) values. Using a one-sample test (Students t-test) with fortified samples at two concentration levels in each type of soil, no significant differences were observed between the real and the experimental values (accuracy percentages ranged between 87 and 117%). It is the first time that the adsorptive potential of MWCNTs for the extraction of organophosphorus pesticides from soils is investigated.

Dispersive liquid–liquid microextraction combined with nonaqueous capillary electrophoresis for the determination of fluoroquinolone antibiotics in waters

Dispersive liquid–liquid microextraction (DLLME) was combined for the first time with NACE‐UV for the selective determination of eight fluoroquinolone antibiotics (lomefloxacin, levofloxacin, marbofloxacin, ciprofloxacin, sarafloxacin, enrofloxacin, danofloxacin and difloxacin) in mineral and run‐off waters. Field‐enhanced sample injection was carried out in order to improve the sensitivity, whereas pipemidic acid was used as internal standard. The BGE that provided complete separation of the eight analytes and the internal standard was composed of 3 M acetic acid, 49 mM ammonium acetate in 55:45 v/v methanol:ACN. Optimum DLLME conditions (extraction of 5 mL of water at pH 7.6 with 685 μL of CHCl3 and 1250 μL of ACN, extractant and disperser solvents, respectively) were achieved by means of experimental design methodology. Calibration curves of the whole method were obtained with correlation coefficients (R) higher than 0.994 in all cases. An accuracy and precision study was carried out at different levels of concentration, finding that there were no significant differences (Students t‐test) between real and spiked concentrations.

Pesticide analysis in tomatoes by solid-phase microextraction and micellar electrokinetic chromatography.

The analysis of a group of seven pesticides (i.e. six fungicides: pyrimethanil, procymidone, nuarimol, fenarimol, benalaxyl and penconazole and one insecticide: pirimicarb) in tomato samples by micellar electrokinetic chromatography is investigated. For this purpose, reversed electrode polarity stacking mode and solid-phase microextraction (SPME) have been used as on-line and off-line preconcentration procedures, respectively. Tomato samples were first homogenized and extracted with acetone. After suitable evaporation and reconstitution of the extract in water, a SPME procedure using poly(dimethylsiloxane)/divinylbenzene fibers was used. Due to the strong influence of the sample matrix in the extraction, a matrix matched calibration of spiked tomato samples was developed. The method was found to be linear between 0.5 and 2.5 mg/kg. Limits of detection achieved are below the maximum residue limits established by the European Union and Spain legislation as well as by the Codex Alimentarius (except for penconazole). The potential of the method was demonstrated by analyzing 12 tomato samples (of ecological and non-ecological production) taken from regional cultivars. No residues of the selected pesticides were detected in any of the samples.

Determination of organophosphorus pesticides and metabolites in cereal-based baby foods and wheat flour by means of ultrasound-assisted extraction and hollow-fiber liquid-phase microextraction prior to gas chromatography with nitrogen phosphorus detection

A new method based on hollow-fiber liquid-phase microextraction (HF-LPME) has been developed for the determination of a group of organophosphorus pesticides, including some of their metabolites, in two commercial cereal-based baby foods and one wheat flour prior to gas chromatography-nitrogen phosphorus detection. Samples were first extracted by ultrasound-assisted extraction with acetonitrile (ACN) containing 1.25% (v/v) of formic acid. After evaporation and reconstitution in Milli-Q water, the HF-LPME procedure, using 1-octanol as extraction solvent, was applied followed by a desorption step in ACN, which clearly improved the performance of the technique. The effects of sample pH, ionic strength, stirring rate, extraction temperature and time as well as the desorption procedure were investigated. Under the optimum conditions that involved the extraction of the analytes from 10 mL of the water reconstituted extract at pH 7.0 containing 5% (w/v) of NaCl for 45 min at 960 rpm, the method was validated in terms of linearity, precision and accuracy. The limits of detection (LODs) were between 0.29 and 3.20 μg/kg. The extraction of Milli-Q water, as an example of the applicability of the procedure to aqueous samples, allowed achieving LODs in the range 0.01-0.04 μg/L. Such values, together with the ones achieved for the rest of the samples, are below or equal to the maximum residue limits specified by the European Union.

Determination of pesticides and their metabolites in processed cereal samples

Fifteen pesticides including some of their metabolites (disulfoton sulfoxide, ethoprophos, cadusafos, dimethoate, terbufos, disulfoton, chlorpyrifos-methyl, malaoxon, fenitrothion, pirimiphos-methyl, malathion, chlorpyrifos, terbufos sulfone, disulfoton sulfone and fensulfothion) were analysed in milled toasted wheat and maize as well as in wheat flour and baby cereals. The QuEChERS (quick, easy, cheap, effective, rugged and safe) methodology was used and its dispersive solid-phase extraction procedure was optimised by means of an experimental design with the aim of reducing the amount of co-extracted lipids and obtaining a clean extract. Gas chromatography with nitrogen phosphorus detection were used as the separation and detection techniques, respectively. The method was validated in terms of selectivity, recoveries, calibration, precision and accuracy as well as matrix effects. Limits of detection were between 0.07 and 34.8 µg kg−1 with recoveries in the range of 71–110% (relative standard deviations were below 9%). A total of 40 samples of different origin were analysed. Residues of pirimiphos-methyl were found in six of the samples at concentrations in the range 0.08–0.47 mg kg−1, which were below the MRLs established for this pesticide in cereal grains. Tandem mass spectrometry confirmation was also carried out in order to identify unequivocally the presence of this pesticide.