V. Ovchinnikov

Fast electron generation in cones with ultraintense laser pulses

Experimental results from copper cones irradiated with ultra-intense laser light are presented. Spatial images and total yields of Cu K{sub {alpha}} fluorescence were measured as a function of the laser focusing properties. The fluorescence emission extends into the cone approximately 300 {micro}m from the cone tip and cannot be explained by ray tracing including cone wall absorption. In addition the total fluorescence yield from cones is an order of magnitude higher than for equivalent mass foil targets. Indications are that the physics of the laser cone interaction is dominated by preplasma created from the long duration, low energy pre-pulse from the laser.

Comparison of bulk and pitcher-catcher targets for laser-driven neutron production

Laser-driven d(d, n)-3He beam-target fusion neutron production from bulk deuterated plastic (CD) targets is compared with a pitcher-catcher target scheme using an identical laser and detector arrangement. For laser intensities in the range of (1–3) × 1019 W cm−2, it was found that the bulk targets produced a high yield (5 × 104 neutrons per steradian) beamed preferentially in the laser propagation direction. Numerical modeling shows the importance of considering the temperature adjusted stopping powers to correctly model the neutron production. The bulk CD targets have a high background target temperature leading to a reduced stopping power for the deuterons, which increases the probability of generating neutrons by fusion. Neutron production from the pitcher-catcher targets was not as efficient since it does not benefit from the reduced stopping power in the cold catcher target. Also, the inhibition of the deuteron acceleration by a proton rich contamination layer significantly reduces the pitcher-catche...

Front versus rear side light-ion acceleration from high-intensity laser–solid interactions

The source of ions accelerated from high-intensity laser interactions with thin foil targets is investigated by coating a deuterated plastic layer either on the front, rear or both surfaces of thin foil targets. The originating surface of the deuterons is therefore known and this method is used to assess the relative source contributions and maximum energies using a Thomson parabola spectrometer to obtain high-resolution light-ion spectra. Under these experimental conditions, laser intensity of (0.5‐2.5) × 10 19 Wc m −2 , pulse duration of 400 fs and target thickness of 6‐13 µm, deuterons originating from the front surface can gain comparable maximum energies as those from the rear surface and spectra from either side can deviate from Maxwellian. Two-dimensional particle-in-cell simulations model the acceleration and show that any presence of a proton rich contamination layer over the surface is detrimental to the deuteron acceleration from the rear surface, whereas it is likely to be less influential on the front side acceleration mechanism. (Some figures in this article are in colour only in the electronic version)

Diagnostics for fast ignition science (invited)

The ignition concept for electron fast ignition inertial confinement fusion requires sufficient energy be transferred from an approximately 20 ps laser pulse to the compressed fuel via approximately MeV electrons. We have assembled a suite of diagnostics to characterize such transfer, simultaneously fielding absolutely calibrated extreme ultraviolet multilayer imagers at 68 and 256 eV; spherically bent crystal imagers at 4.5 and 8 keV; multi-keV crystal spectrometers; MeV x-ray bremmstrahlung, electron and proton spectrometers (along the same line of sight), and a picosecond optical probe interferometer. These diagnostics allow careful measurement of energy transport and deposition during and following the laser-plasma interactions at extremely high intensities in both planar and conical targets. Together with accurate on-shot laser focal spot and prepulse characterization, these measurements are yielding new insights into energy coupling and are providing critical data for validating numerical particle-in-cell (PIC) and hybrid PIC simulation codes in an area crucial for fast ignition and other applications. Novel aspects of these diagnostics and how they are combined to extract quantitative data on ultrahigh intensity laser-plasma interactions are discussed.

How well do time-integrated Kα images represent hot electron spatial distributions?

A computational study is described, which addresses how well spatially resolved time-integrated Kα images recorded in intense laser-plasma experiments correlate with the distribution of “hot” (>1 MeV) electrons as they propagate through the target. The hot electron angular distribution leaving the laser-plasma region is critically important for many applications such as Fast Ignition or laser based x-ray sources; and Kα images are commonly used as a diagnostic. It is found that Kα images can easily mislead due to refluxing and other effects. Using the particle-in-cell code LSP, it is shown that a Kα image is not solely determined by the initial population of forward directed hot electrons, but rather also depends upon “delayed” hot electrons, and in fact continues to evolve long after the end of the laser interaction. Of particular note, there is a population of hot electrons created during the laser-plasma interaction that acquire a velocity direction opposite that of the laser and subsequently reflux of...

Development of an in situ peak intensity measurement method for ultraintense single shot laser-plasma experiments at the Sandia Z petawatt facility

Using the physical process of ultraintense field ionization of high charge states of inert gas ions, we have developed a method of peak intensity measurement at the focus of high energy short pulse lasers operating in single shot mode. The technique involves detecting ionization products created from a low pressure gas target at the laser focus via time of flight detector. The observation of high ion charge states collected by the detector yields peak intensity at the focus when compared with the results obtained from well established tunnel ionization models. An initial peak intensity measurement of 5×1016Wcm−2 was obtained for a 1.053μm center wavelength, 0.4J pulse with 1ps pulse duration focused with an f∕5.5 off-axis parabola. Experiments with multijoule level, 500fs laser pulses are on the way.

Backward-propagating MeV electrons from 1018 W/cm2 laser interactions with water

We present an experimental study of the generation of ∼MeV electrons opposite to the direction of laser propagation following the relativistic interaction at normal incidence of a ∼3 mJ, 1018 W/cm2 short pulse laser with a flowing 30  μm diameter water column target. Faraday cup measurements record hundreds of pC charge accelerated to energies exceeding 120 keV, and energy-resolved measurements of secondary x-ray emissions reveal an x-ray spectrum peaking above 800 keV, which is significantly higher energy than previous studies with similar experimental conditions and more than five times the ∼110 keV ponderomotive energy scale for the laser. We show that the energetic x-rays generated in the experiment result from backward-going, high-energy electrons interacting with the focusing optic, and vacuum chamber walls with only a small component of x-ray emission emerging from the target itself. We also demonstrate that the high energy radiation can be suppressed through the attenuation of the nanosecond-scale...

High-Intensity Laser-Plasma Interaction with Wedge-Shaped-Cavity Targets

High-intensity, short-pulse laser-interaction experiments with small-mass, wedge-shaped-cavity Cu targets are presented. The diagnostics provided spatially and spectrally resolved measurements of the Cu Kα line emission at 8 keV. The conversion efficiency of short-pulse laser energy into fast electrons was inferred from the x-ray yield for wedge opening angles between 30° and 60° and for s- and p-polarized laser irradiation. Up to 36±7% conversion efficiency was measured for the narrowest wedge with p-polarization. The results are compared with predictions from two-dimensional particle-in-cell simulations.

Hot electron generation and transport using Kα emission

We have conducted experiments on both the Vulcan and Titan laser facilities to study hot electron generation and transport in the context of fast ignition. Cu wires attached to Al cones were used to investigate the effect on coupling efficiency of plasma surround and the pre-formed plasma inside the cone. We found that with thin cones 15% of laser energy is coupled to the 40μm diameter wire emulating a 40μm fast ignition spot. Thick cone walls, simulating plasma in fast ignition, reduce coupling by x4. An increase of pre-pulse level inside the cone by a factor of 50 reduces coupling by a factor of 3.

Using time-integrated Kα images to study refluxing and the extent of pre-plasmas in intense laser-plasma experiment

We report the results of an experimental and numerical modeling study of the formation of time-integrated Kα images by electrons excited during an intense laser-plasma interaction. We report the use of the spatial structure of time-integrated Kα images to quantitatively characterize the pre-plasma profile near the critical surface and to verify the near elimination of back-surface refluxing from targets when a thick layer of a low-Z material is attached to the back. The time integrated Kα images are found to be sensitive to the relative separation between the critical surface and the bulk target, permitting a single parameter exponential pre-plasma scale length to be determined by fitting to experimental results. The refluxed electrons affect different parts of the Kα images in a manner that varies depending on the location of the refluxing. We use these properties to characterize refluxing also by fitting to experimental results. Experiments were performed using the Titan laser at the Lawrence Livermore ...