Benjamin D. Briggs

Through-Cobalt Self Forming Barrier (tCoSFB) for Cu/ULK BEOL: A novel concept for advanced technology nodes

Through-Co self-forming-barrier (tCoSFB) metallization scheme is introduced, with Cu gap-fill capability down to 7 nm-node dimensions. Mn atoms from doped-seedlayer diffuse through CVD-Co wetting layer, to form TaMnxOy barrier, with integrity proven by vertical-trench triangular-voltage-sweep and barrier-oxidation tests. tCoSFB scheme enables 32% and 45% lower line and via resistance, respectively at 10 nm node dimensions, while achieving superior EM performance to competitive TaN/Co and TaN/Ru-based barriers.

Defect detection strategies and process partitioning for SE EUV patterning (Conference Presentation)

The key challenge for enablement of a 2nd node of single-expose EUV patterning is understanding and mitigating the patterning-related defects that narrow the process window. Typical in-line inspection techniques, such as broadband plasma (291x) and e-beam systems, find it difficult to detect the main yield-detracting defects post-develop, and thus understanding the effects of process improvement strategies has become more challenging. New techniques and methodologies for detection of EUV lithography defects, along with judicious process partitioning, are required to develop process solutions that improve yield. This paper will first discuss alternative techniques and methodologies for detection of lithography-related defects, such as scumming and microbridging. These strategies will then be used to gain a better understanding of the effects of material property changes, process partitioning, and hardware improvements, ultimately correlating them directly with electrical yield detractors .

Comparison of key fine-line BEOL metallization schemes for beyond 7 nm node

For beyond 7 nm node BEOL, line resistance (R) is assessed among four metallization schemes: Ru; Co; Cu with TaN/Ru barrier, and Cu with through-cobalt self-forming barrier (tCoSFB) [1]. Line-R vs. linewidth of Cu fine wires with TaN/Ru barrier crosses over with barrier-less Ru and Co wires for beyond-7 nm node dimensions, whereas Cu with tCoSFB remains competitive, with the lowest line R for 7 nm and beyond. Our study suggests promise of this last scheme to meet requirements in line R and EM reliability.

Cobalt/copper composite interconnects for line resistance reduction in both fine and wide lines

Co/Cu composite interconnect systems were studied. Since wide Cu lines require a diffusion barrier which is simultaneously applied also to fine Co lines to reduce Co volume fraction, through-Cobalt Self-Formed-Barrier (tCoSFB) was employed to thin down TaN barrier to <1 nm which works as an adhesion layer for Co lines. Line R of fine Co lines was reduced by 30% successfully. The Co/tCoSFB-Cu composite interconnect system is promising to achieve low line R for both fine and wide lines simultaneously in 7nm BEOL and beyond.