Clement Goyon

Experimental investigation of the stimulated Brillouin scattering growth and saturation at 526 and 351 nm for direct drive and shock ignition

We have designed experiments to study the effect of the laser wavelength (0.527 versus 0.351 μm) on the coupling efficiency in plasma conditions relevant to compression and shock ignition (SI) schemes in different intensity regimes. A difficult issue was to produce interaction conditions that are equivalent for the two wavelengths. This was obtained by using plasma preformed from a solid target with a plasma-preforming beam at the same wavelength as the interaction beam. This produced an almost exponential density profile from vacuum to the critical density of the interaction beam in which all interaction mechanisms are taken into account. The growth and saturation of stimulated Brillouin scattering (SBS) have been measured at the two wavelengths, in backward as well as in near-backward directions. We have found that the SBS intensity threshold is ∼1.5 times higher at 3ω than at 2ω in agreement with the Iλ dependence of the SBS gain. The SBS behaviour is very well reproduced by the linear calculations of ...

High Power Dynamic Polarization Control Using Plasma Photonics

We report the first experimental demonstration of a plasma wave plate based on laser-induced birefringence. An elliptically polarized input was converted into a nearly ideal circularly polarized beam using an optical system composed of a second laser beam and a plasma. The results are in excellent agreement with linear theory and three-dimensional simulations up to phase delays exceeding π/4, thus establishing the feasibility of laser-plasma photonic devices that are ultrafast, damage-resistant, and easily tunable.

Refractive Index Seen by a Probe Beam Interacting with a Laser-Plasma System

We report the first complete set of measurements of a laser-plasma optical systems refractive index, as seen by a second probe laser beam, as a function of the relative wavelength shift between the two laser beams. Both the imaginary and real refractive index components are found to be in good agreement with linear theory using plasma parameters measured by optical Thomson scattering and interferometry; the former is in contrast to previous work and has implications for crossed-beam energy transfer in indirect-drive inertial confinement fusion, and the latter is measured for the first time. The data include the first demonstration of a laser-plasma polarizer with 85%-87% extinction for the particular laser and plasma parameters used in this experiment, complementing the existing suite of high-power, tunable, and ultrafast plasma-based photonic devices.

The high velocity, high adiabat, “Bigfoot” campaign and tests of indirect-drive implosion scaling

The Bigfoot approach is to intentionally trade off high convergence, and therefore areal-density, in favor of high implosion velocity and good coupling between the laser, hohlraum, shell, and hotspot. This results in a short laser pulse that improves hohlraum symmetry and predictability, while the reduced compression reduces hydrodynamic instability growth. The results thus far include demonstrated low-mode symmetry control at two different hohlraum geometries (5.75 mm and 5.4 mm diameters) and at two different target scales (5.4 mm and 6.0 mm hohlraum diameters) spanning 300–405 TW in laser power and 0.8–1.6 MJ in laser energy. Additionally, by carefully scaling the 5.4 mm design to 6.0 mm, an increase in target scale of 13%, equivalent to 40% increase in laser energy, has been demonstrated.

Increasing stagnation pressure and thermonuclear performance of inertial confinement fusion capsules by the introduction of a high-Z dopant

Inertial confinement fusion requires the inertia of the imploding mass to provide the necessary confinement such that the core reaches adequate high density, temperature, and pressure. Experiments utilize low-Z capsules filled with hydrogenic fuel, which are subject to multiple instabilities at the interfaces during the implosion. To improve the stability of the fuel:capsule interface and narrow the imploding shell profile, capsules are doped with a small atomic percentage of a high-Z material. A series of recent indirect-drive experiments executed at the National Ignition Facility with tungsten-doped high density carbon capsules has demonstrated that the presence of this dopant serves to increase the in-flight aspect ratio of the shell and increase the compression and neutron yield performance of both gas-filled and deuterium-tritium cryogenically layered targets. These experiments definitively demonstrate that benefits accrued by the introduction of a high-Z dopant into the capsule can outweigh the detrimentally reduced stability of the ablation front, avoiding shell breakup or significant radiative cooling of the hot spot. Future experiments will utilize these types of capsules to further increase nuclear performance.Inertial confinement fusion requires the inertia of the imploding mass to provide the necessary confinement such that the core reaches adequate high density, temperature, and pressure. Experiments utilize low-Z capsules filled with hydrogenic fuel, which are subject to multiple instabilities at the interfaces during the implosion. To improve the stability of the fuel:capsule interface and narrow the imploding shell profile, capsules are doped with a small atomic percentage of a high-Z material. A series of recent indirect-drive experiments executed at the National Ignition Facility with tungsten-doped high density carbon capsules has demonstrated that the presence of this dopant serves to increase the in-flight aspect ratio of the shell and increase the compression and neutron yield performance of both gas-filled and deuterium-tritium cryogenically layered targets. These experiments definitively demonstrate that benefits accrued by the introduction of a high-Z dopant into the capsule can outweigh the detr...

Publisher's Note: Development of improved radiation drive environment for high foot implosions at the National Ignition Facility [Phys. Rev. Lett. 117, 225002 (2016)].

This corrects the article DOI: 10.1103/PhysRevLett.117.225002.

Reduction of stimulated Brillouin backscattering with plasma beam smoothing

Plasma induced incoherence (PII) can strongly modify the growth rates of stimulated scattering instabilities. A special double-target design was used to quantify the effect of PII on stimulated Brillouin scattering (SBS). Successive shots using all or part of these targets led to the characterization of temporal and spatial incoherence of a laser pulse after propagation through a foam plasma and to the quantification of the reduction of SBS from the second target. Numerical simulations were used to identify the main physical mechanisms in play.