Dan-Hua Hsieh

450-nm GaN laser diode enables high-speed visible light communication with 9-Gbps QAM-OFDM

A TO-38-can packaged Gallium nitride (GaN) blue laser diode (LD) based free-space visible light communication (VLC) with 64-quadrature amplitude modulation (QAM) and 32-subcarrier orthogonal frequency division multiplexing (OFDM) transmission at 9 Gbps is preliminarily demonstrated over a 5-m free-space link. The 3-dB analog modulation bandwidth of the TO-38-can packaged GaN blue LD biased at 65 mA and controlled at 25°C is only 900 MHz, which can be extended to 1.5 GHz for OFDM encoding after throughput intensity optimization. When delivering the 4-Gbps 16-QAM OFDM data within 1-GHz bandwidth, the error vector magnitude (EVM), signal-to-noise ratio (SNR) and bit-error-rate (BER) of the received data are observed as 8.4%, 22.4 dB and 3.5 × 10(-8), respectively. By increasing the encoded bandwidth to 1.5 GHz, the TO-38-can packaged GaN blue LD enlarges its transmission capacity to 6 Gbps but degrades its transmitted BER to 1.7 × 10(-3). The same transmission capacity of 6 Gbps can also be achieved with a BER of 1 × 10(-6) by encoding 64-QAM OFDM data within 1-GHz bandwidth. Using the 1.5-GHz full bandwidth of the TO-38-can packaged GaN blue LD provides the 64-QAM OFDM transmission up to 9 Gbps, which successfully delivers data with an EVM of 5.1%, an SNR of 22 dB and a BER of 3.6 × 10(-3) passed the forward error correction (FEC) criterion.

Phosphorous Diffuser Diverged Blue Laser Diode for Indoor Lighting and Communication.

An advanced light-fidelity (Li-Fi) system based on the blue Gallium nitride (GaN) laser diode (LD) with a compact white-light phosphorous diffuser is demonstrated for fusing the indoor white-lighting and visible light communication (VLC). The phosphorous diffuser adhered blue GaN LD broadens luminescent spectrum and diverges beam spot to provide ample functionality including the completeness of Li-Fi feature and the quality of white-lighting. The phosphorous diffuser diverged white-light spot covers a radiant angle up to 120o with CIE coordinates of (0.34, 0.37). On the other hand, the degradation on throughput frequency response of the blue LD is mainly attributed to the self-feedback caused by the reflection from the phosphor-air interface. It represents the current state-of-the-art performance on carrying 5.2-Gbit/s orthogonal frequency-division multiplexed 16-quadrature-amplitude modulation (16-QAM OFDM) data with a bit error rate (BER) of 3.1 × 10−3 over a 60-cm free-space link. This work aims to explore the plausibility of the phosphorous diffuser diverged blue GaN LD for future hybrid white-lighting and VLC systems.

Non-antireflective Scheme for Efficiency Enhancement of Cu(In,Ga)Se2 Nanotip Array Solar Cells

We present systematic works in characterization of CIGS nanotip arrays (CIGS NTRs). CIGS NTRs are obtained by a one-step ion-milling process by a direct-sputtering process of CIGS thin films (CIGS TF) without a postselenization process. At the surface of CIGS NTRs, a region extending to 100 nm in depth with a lower copper concentration compared to that of CIGS TF has been discovered. After KCN washing, removal of secondary phases can be achieved and a layer with abundant copper vacancy (V(Cu)) was left. Such compositional changes can be a benefit for a CIGS solar cell by promoting formation of Cd-occupied Cu sites (Cd(Cu)) at the CdS/CIGS interface and creates a type-inversion layer to enhance interface passivation and carrier extraction. The raised V(Cu) concentration and enhanced Cd diffusion in CIGS NTRs have been verified by energy dispersive spectrometry. Strengthened adhesion of Al:ZnO (AZO) thin film on CIGS NTRs capped with CdS has also been observed in SEM images and can explain the suppressed series resistance of the device with CIGS NTRs. Those improvements in electrical characteristics are the main factors for efficiency enhancement rather than antireflection.

4-Gbit/s visible light communication link based on 16-QAM OFDM transmission over remote phosphor-film converted white light by using blue laser diode

Visible Light Communication (VLC) as a new technology for ultrahigh-speed communication is still limited when using slow modulation light-emitting diode (LED). Alternatively, we present a 4-Gbit/s VLC system using coherent blue-laser diode (LD) via 16-quadrature amplitude modulation orthogonal frequency division multiplexing. By changing the composition and the optical-configuration of a remote phosphor-film the generated white light is tuned from cool day to neutral, and the bit error rate is optimized from 1.9 × 10(-2) to 2.8 × 10(-5) in a blue filter-free link due to enhanced blue light transmission in forward direction. Briefly, blue-LD is an alternative to LED for generating white light and boosting the data rate of VLC.

Very High Bit-Rate Distance Product Using High-Power Single-Mode 850-nm VCSEL With Discrete Multitone Modulation Formats Through OM4 Multimode Fiber

In order to investigate the tradeoff between optical spectral width and modulation speed of 850-nm Zn-diffusion vertical-cavity surface-emitting laser (VCSEL) and its influence on the performance of discrete multitone (DMT) modulation, two kinds of high-speed VCSEL structures with different cavity lengths (λ/2 and 3λ/2) are studied. By shortening the cavity length to λ/2, allocating the oxide layer in the standing-wave peak, and performing a Zn-diffusion aperture in our VCSEL structure, stable dual mode in the output optical spectra across the full range of bias currents with good high-speed performance (~16-GHz bandwidth) can be achieved. Compared with its multimode reference, it shows far less roll-off with regard to the maximum data rate versus transmission distance over OM4 multimode fibers under forward error correction (FEC) threshold (BER <; 3.8 × 10-3). On the other hand, for the 3λ/2 VCSEL structure, by using the same Zn-diffusion conditions as those of dual-mode counterpart, highly single-mode operation (side-mode suppression ratio> 35 dB) with high available power can be achieved over the full range of bias currents. Although such device shows a smaller 3-dB electrical-to-optical bandwidth (12 versus 16 GHz) than that of the dual-mode one, it exhibits a superior transmission performance by use of DMT modulation format. A record high bit-rate distance product (107.6 Gb/s·km) at nearly 50-Gb/s transmission under FEC threshold (BER<; 3.8 × 10-3) through 2.2-km OM4 fibers has been successfully demonstrated by the use of single-mode VCSEL with optimized structures. In addition, error-free (BER<; 1 × 10-12) transmission at 20.3 Gb/s with bit-rate distance product of 44.66 Gb/s·km has also been demonstrated.

Improved carrier injection in GaN-based VCSEL via AlGaN/GaN multiple quantum barrier electron blocking layer

In this report, the improved lasing performance of the III-nitride based vertical-cavity surface-emitting laser (VCSEL) has been demonstrated by replacing the bulk AlGaN electron blocking layer (EBL) in the conventional VCSEL structure with an AlGaN/GaN multiple quantum barrier (MQB) EBL. The output power can be enhanced up to three times from 0.3 mW to 0.9 mW. In addition, the threshold current density of the fabricated device with the MQB-EBL was reduced from 12 kA/cm2 (9.5 mA) to 10.6 kA/cm2 (8.5 mA) compared with the use of the bulk AlGaN EBL. Theoretical calculation results suggest that the improved carrier injection efficiency can be mainly attributed to the partial release of the strain and the effect of quantum interference by using the MQB structure, hence increasing the effective barrier height of the conduction band.

Observation of unusual optical transitions in thin-film Cu(In,Ga)Se 2 solar cells

In this paper, we examine photoluminescence spectra of Cu(In,Ga)Se(2) (CIGS) via temperature-dependent and power-dependent photoluminescence (PL). Donor-acceptor pair (DAP) transition, near-band-edge transition were identified by their activation energies. S-shaped displacement of peak position was observed and was attributed to carrier confinement caused by potential fluctuation. This coincides well with the obtained activation energy at low temperature. We also present a model for transition from V(Se) to V(In) and to V(Cu) which illustrates competing mechanisms between DAPs recombinations.

Optical cross-talk reduction in a quantum-dot-based full-color micro-light-emitting-diode display by a lithographic-fabricated photoresist mold

In this study, a full-color emission red–green–blue (RGB) quantum-dot (QD)-based micro-light-emitting-diode (micro-LED) array with the reduced optical cross-talk effect by a photoresist mold has been demonstrated. The UV micro-LED array is used as an efficient excitation source for the QDs. The aerosol jet technique provides a narrow linewidth on the micrometer scale for a precise jet of QDs on the micro-LEDs. To reduce the optical cross-talk effect, a simple lithography method and photoresist are used to fabricate the mold, which consists of a window for QD jetting and a blocking wall for cross-talk reduction. The cross-talk effect of the well-confined QDs in the window is confirmed by a fluorescence microscope, which shows clear separation between QD pixels. A distributed Bragg reflector is covered on the micro-LED array and the QDs’ jetted mold to further increase the reuse of UV light. The enhanced light emission of the QDs is 5%, 32%, and 23% for blue, green, and red QDs, respectively.

Device Modeling of the Performance of Cu(In,Ga)Se2 Solar Cells with V-Shaped Bandgap Profiles

The effect of Cu(In,Ga)Se2 (CIGS) with V-shaped bandgap on device performance is investigated in detail. A series of Ga/(In

850-nm VCSELs With p-Type

In this paper, we study the influence of p-type modulation doping on the dynamic/static performance of high-speed 850-nm VCSELs with highly strained multiple quantum wells. The studied device structure has a 3/2 λ asymmetric cavity design, which can let the internal transit time of injected carriers be as short as that of 1/2 λ cavity design and further improve its performance in terms of speed and output power for high single-mode operation. Our proposed VCSEL structure with p-type doping shows superior modulation speed with an output power comparable with that of the un-doped reference device under room temperature operation. Furthermore, when the operating temperature reaches 85 °C, there is a significant improvement in both the modulation speed and maximum power of the p-doped structures. According to our simulation, this can be attributed to the change in the quasi-Fermi levels of the injected carriers after the addition of p-doping in the active layers, which minimizes the electron leakage under high-temperature operation.