Hye Min Oh

Synthesis of Centimeter-Scale Monolayer Tungsten Disulfide Film on Gold Foils

We report the synthesis of centimeter-scale monolayer WS2 on gold foil by chemical vapor deposition. The limited tungsten and sulfur solubility in gold foil allows monolayer WS2 film growth on gold surface. To ensure the coverage uniformity of monolayer WS2 film, the tungsten source-coated substrate was placed in parallel with Au foil under hydrogen sulfide atmosphere. The high growth temperature near 935 °C helps to increase a domain size up to 420 μm. Gold foil is reused for the repeatable growth after bubbling transfer. The WS2-based field effect transistor reveals an electron mobility of 20 cm(2) V(-1) s(-1) with high on-off ratio of ∼10(8) at room temperature, which is the highest reported value from previous reports of CVD-grown WS2 samples. The on-off ratio of integrated multiple FETs on the large area WS2 film on SiO2 (300 nm)/Si substrate shows within the same order, implying reasonable uniformity of WS2 FET device characteristics over a large area of 3 × 1.5 cm(2).

Observing Grain Boundaries in CVD-Grown Monolayer Transition Metal Dichalcogenides

Two-dimensional monolayer transition metal dichalcogenides (TMdCs), driven by graphene science, revisit optical and electronic properties, which are markedly different from bulk characteristics. These properties are easily modified due to accessibility of all the atoms viable to ambient gases, and therefore, there is no guarantee that impurities and defects such as vacancies, grain boundaries, and wrinkles behave as those of ideal bulk. On the other hand, this could be advantageous in engineering such defects. Here, we report a method of observing grain boundary distribution of monolayer TMdCs by a selective oxidation. This was implemented by exposing directly the TMdC layer grown on sapphire without transfer to ultraviolet light irradiation under moisture-rich conditions. The generated oxygen and hydroxyl radicals selectively functionalized defective grain boundaries in TMdCs to provoke morphological changes at the boundary, where the grain boundary distribution was observed by atomic force microscopy and scanning electron microscopy. This paves the way toward the investigation of transport properties engineered by defects and grain boundaries.

Carrier localization in In-rich InGaN/GaN multiple quantum wells for green light-emitting diodes

Carrier localization phenomena in indium-rich InGaN/GaN multiple quantum wells (MQWs) grown on sapphire and GaN substrates were investigated. Temperature-dependent photoluminescence (PL) spectroscopy, ultraviolet near-field scanning optical microscopy (NSOM), and confocal time-resolved PL (TRPL) spectroscopy were employed to verify the correlation between carrier localization and crystal quality. From the spatially resolved PL measurements, we observed that the distribution and shape of luminescent clusters, which were known as an outcome of the carrier localization, are strongly affected by the crystalline quality. Spectroscopic analysis of the NSOM signal shows that carrier localization of MQWs with low crystalline quality is different from that of MQWs with high crystalline quality. This interrelation between carrier localization and crystal quality is well supported by confocal TRPL results.

Semiconductor–Insulator–Semiconductor Diode Consisting of Monolayer MoS2, h-BN, and GaN Heterostructure

We propose a semiconductor-insulator-semiconductor (SIS) heterojunction diode consisting of monolayer (1-L) MoS2, hexagonal boron nitride (h-BN), and epitaxial p-GaN that can be applied to high-performance nanoscale optoelectronics. The layered materials of 1-L MoS2 and h-BN, grown by chemical vapor deposition, were vertically stacked by a wet-transfer method on a p-GaN layer. The final structure was verified by confocal photoluminescence and Raman spectroscopy. Current-voltage (I-V) measurements were conducted to compare the device performance with that of a more classical p-n structure. In both structures (the p-n and SIS heterojunction diode), clear current-rectifying characteristics were observed. In particular, a current and threshold voltage were obtained for the SIS structure that was higher compared to that of the p-n structure. This indicated that tunneling is the predominant carrier transport mechanism. In addition, the photoresponse of the SIS structure induced by the illumination of visible light was observed by photocurrent measurements.

Metal–Insulator–Semiconductor Diode Consisting of Two-Dimensional Nanomaterials

We present a novel metal-insulator-semiconductor (MIS) diode consisting of graphene, hexagonal BN, and monolayer MoS2 for application in ultrathin nanoelectronics. The MIS heterojunction structure was fabricated by vertically stacking layered materials using a simple wet chemical transfer method. The stacking of each layer was confirmed by confocal scanning Raman spectroscopy and device performance was evaluated using current versus voltage (I-V) and photocurrent measurements. We clearly observed better current rectification and much higher current flow in the MIS diode than in the p-n junction and the metal-semiconductor diodes made of layered materials. The I-V characteristic curve of the MIS diode indicates that current flows mainly across interfaces as a result of carrier tunneling. Moreover, we observed considerably high photocurrent from the MIS diode under visible light illumination.

Large Work Function Modulation of Monolayer MoS2 by Ambient Gases

Although two-dimensional monolayer transition-metal dichalcogenides reveal numerous unique features that are inaccessible in bulk materials, their intrinsic properties are often obscured by environmental effects. Among them, work function, which is the energy required to extract an electron from a material to vacuum, is one critical parameter in electronic/optoelectronic devices. Here, we report a large work function modulation in MoS2 via ambient gases. The work function was measured by an in situ Kelvin probe technique and further confirmed by ultraviolet photoemission spectroscopy and theoretical calculations. A measured work function of 4.04 eV in vacuum was converted to 4.47 eV with O2 exposure, which is comparable with a large variation in graphene. The homojunction diode by partially passivating a transistor reveals an ideal junction with an ideality factor of almost one and perfect electrical reversibility. The estimated depletion width obtained from photocurrent mapping was ∼200 nm, which is much narrower than bulk semiconductors.

Photochemical Reaction in Monolayer MoS2 via Correlated Photoluminescence, Raman Spectroscopy, and Atomic Force Microscopy

Photoluminescence (PL) from monolayer MoS2 has been modulated using plasma treatment or thermal annealing. However, a systematic way of understanding the underlying PL modulation mechanism has not yet been achieved. By introducing PL and Raman spectroscopy, we analyze that the PL modulation by laser irradiation is associated with structural damage and associated oxygen adsorption on the sample in ambient conditions. Three distinct behaviors were observed according to the laser irradiation time: (i) slow photo-oxidation at the initial stage, where the physisorption of ambient gases gradually increases the PL intensity; (ii) fast photo-oxidation at a later stage, where chemisorption increases the PL intensity abruptly; and (iii) photoquenching, with complete reduction of PL intensity. The correlated confocal Raman spectroscopy confirms that no structural deformation is involved in slow photo-oxidation stage; however, the structural disorder is invoked during the fast photo-oxidation stage, and severe structural degradation is generated during the photoquenching stage. The effect of oxidation is further verified by repeating experiments in vacuum, where the PL intensity is simply degraded with laser irradiation in a vacuum due to a simple structural degradation without involving oxygen functional groups. The charge scattering by oxidation is further explained by the emergence/disappearance of neutral excitons and multiexcitons during each stage.

Indirect Bandgap Puddles in Monolayer MoS2 by Substrate-Induced Local Strain

An unusually large bandgap modulation of 1.23-2.65 eV in monolayer MoS2 on a SiO2 /Si substrate is found due to the inherent local bending strain induced by the surface roughness of the substrate, reaching the direct-to-indirect bandgap transition. Approximately 80% of the surface area reveals an indirect bandgap, which is confirmed further by the degraded photoluminescence compared to that from suspended MoS2 .

Integrated Freestanding Two-dimensional Transition Metal Dichalcogenides

This paper reports on the integration of freestanding transition metal dichalcogenides (TMDs). Monolayer (1-L) MoS2 , WS2 , and WSe2 as representative TMDs are transferred on ZnO nanorods (NRs), used here as nanostructured substrates. The photoluminescence (PL) spectra of 1-L TMDs on NRs show a giant PL intensity enhancement, compared with those of 1-L TMDs on SiO2 . The strong increases in Raman and PL intensities, along with the characteristic peak shifts, confirm the absence of stress in the TMDs on NRs. In depth analysis of the PL emission also reveals that the ratio between the exciton and trion peak intensity is almost not modified after transfer. The latter shows that the effect of charge transfer between the 1-L TMDs and ZnO NRs is here negligible. Furthermore, confocal PL and Raman spectroscopy reveal a fairly consistent distribution of PL and Raman intensities. These observations are in agreement with a very limited points contact between the support and the 1-L TMDs. The entire process reported here is scalable and may pave the way for the development of very efficient ultrathin optoelectronics.

Highly Enhanced Photoresponsivity of a Monolayer WSe2 Photodetector with Nitrogen-Doped Graphene Quantum Dots

Hybrid structures of two-dimensional (2D) materials and quantum dots (QDs) are particularly interesting in the field of nanoscale optoelectronic devices because QDs are efficient light absorbers and can inject photocarriers into thin layers of 2D transition-metal dichalcogenides, which have high carrier mobility. In this study, we present a heterostructure that consists of a monolayer of tungsten diselenide (ML WSe2) covered by nitrogen-doped graphene QDs (N-GQDs). The improved photoluminescence of ML WSe2 is attributed to the dominant neutral exciton emission caused by the n-doping effect. Owing to strong light absorption and charge transfer from N-GQDs to ML WSe2, N-GQD-covered ML WSe2 showed up to 480% higher photoresponsivity than that of a pristine ML WSe2 photodetector. The hybrid photodetector exhibits good environmental stability, with 46% performance retention after 30 days under ambient conditions. The photogating effect also plays a key role in the improvement of hybrid photodetector performance. On applying the back-gate voltage modulation, the hybrid photodetector shows a responsivity of 2578 A W-1, which is much higher than that of the ML WSe2-based device.