James F. Davies

Influence of organic films on the evaporation and condensation of water in aerosol

Uncertainties in quantifying the kinetics of evaporation and condensation of water from atmospheric aerosol are a significant contributor to the uncertainty in predicting cloud droplet number and the indirect effect of aerosols on climate. The influence of aerosol particle surface composition, particularly the impact of surface active organic films, on the condensation and evaporation coefficients remains ambiguous. Here, we report measurements of the influence of organic films on the evaporation and condensation of water from aerosol particles. Significant reductions in the evaporation coefficient are shown to result when condensed films are formed by monolayers of long-chain alcohols [CnH(2n+1)OH], with the value decreasing from 2.4 × 10−3 to 1.7 × 10−5 as n increases from 12 to 17. Temperature-dependent measurements confirm that a condensed film of long-range order must be formed to suppress the evaporation coefficient below 0.05. The condensation of water on a droplet coated in a condensed film is shown to be fast, with strong coherence of the long-chain alcohol molecules leading to islanding as the water droplet grows, opening up broad areas of uncoated surface on which water can condense rapidly. We conclude that multicomponent composition of organic films on the surface of atmospheric aerosol particles is likely to preclude the formation of condensed films and that the kinetics of water condensation during the activation of aerosol to form cloud droplets is likely to remain rapid.

An interfacial mechanism for cloud droplet formation on organic aerosols

Organic contributions to cloud theory Current theories about the formation of cloud droplets from aerosol particles containing organic components assume that the organic molecules are distributed throughout the droplet. Ruehl et al. show that this assumption is not always correct (see the Perspective by Noziere). During droplet nucleation, droplet diameters were 50% larger than predicted by the standard model. This suggests that the organic particles reside in a surface layer rather than in the bulk of the droplet. Models that neglect organic surface activity will thus underestimate how well organic-rich particles seed clouds. Science, this issue p. 1447; see also p. 1396 Organic molecules can form a surface layer around nucleating cloud droplets. [Also see Perspective by Noziere] Accurate predictions of aerosol/cloud interactions require simple, physically accurate parameterizations of the cloud condensation nuclei (CCN) activity of aerosols. Current models assume that organic aerosol species contribute to CCN activity by lowering water activity. We measured droplet diameters at the point of CCN activation for particles composed of dicarboxylic acids or secondary organic aerosol and ammonium sulfate. Droplet activation diameters were 40 to 60% larger than predicted if the organic was assumed to be dissolved within the bulk droplet, suggesting that a new mechanism is needed to explain cloud droplet formation. A compressed film model explains how surface tension depression by interfacial organic molecules can alter the relationship between water vapor supersaturation and droplet size (i.e., the Köhler curve), leading to the larger diameters observed at activation.

Measurements of the Sensitivity of Aerosol Hygroscopicity and the κ Parameter to the O/C Ratio

We report measurements of the subsaturated hygroscopic growth of aerosol particles composed of single organic components of varying oxygen-to-carbon ratio up to relative humidities approaching saturation using the techniques of aerosol optical tweezers and an electrodynamic balance. The variation in the hygroscopicity parameter κ between compounds of even the same O/C ratio is found to be significant with, for example, a range in κ values from 0.12 to 0.38 for compounds with an O/C of 1. The measurements are compared with a review of all of the available literature data for which both the κ value and O/C ratio are reported, and a new parametrization is determined. Critical supersaturations predicted using this parametrization yield values that have associated uncertainties that are comparable to typical uncertainties in experimental measurements of critical supersaturations. However, the systematic variability between κ parametrizations determined from different studies remains large, consistent with the O/C ratio providing only an approximate guide to aerosol hygroscopicity and reflecting significant variations for aerosols of different chemical functionality, composition, and oxidation history.

Bulk, surface, and gas-phase limited water transport in aerosol.

The influence of solute species on mass transfer to and from aqueous aerosol droplets is investigated using an electrodynamic balance coupled with light scattering techniques. In particular, we explore the limitations imposed on water evaporation by slow bulk phase diffusion and by the formation of surface organic films. Measurements of evaporation from ionic salt solutions, specifically sodium chloride and ammonium sulfate, are compared with predictions from an analytical model framework, highlighting the uncertainties associated with quantifying gas diffusional transport. The influence of low solubility organic acids on mass transfer is reported and compared to both model predictions and previous work. The limiting value of the evaporation coefficient that can be resolved by this approach, when uncertainties in key thermophysical quantities are accounted for, is estimated. The limitation of slow bulk phase diffusion on the evaporation rate is investigated for gel and glass states formed during the evaporation of magnesium sulfate and sucrose droplets, respectively. Finally, the effect of surfactants on evaporation has been probed, with soluble surfactants (such as sodium dodecyl sulfate) leading to little or no retardation of evaporation through slowing of surface layer kinetics.

Time-Resolved Measurements of the Evaporation of Volatile Components from Single Aerosol Droplets

A strategy for examining the dynamic hygroscopic response of single aerosol particles is reported, allowing a direct investigation of the interplay of thermodynamic and kinetic factors regulating the time dependence of particle size. In particular, we investigate the rapid evaporation of water from water–glycerol droplets, measuring the evolving size with a time resolution of <10 ms (with as low as 2.5 ms being possible) over a time range from subsecond to many hours. Measurements can be made on sequential droplets generated from a droplet-on-demand generator, and a reproducibility of better than ±0.25 μm in droplet size over tens of events can be achieved at any resolved time point considered during an evaporation process lasting >2 s. The time-dependent measurements of evolving droplet size are compared with an analytical treatment of the evaporation process. Excellent agreement between measurements and simulations is found over a wide range of starting droplet compositions. The benefits of using this approach for investigating water transport within the bulk of an aerosol particle or to/from the droplet surface are discussed. Copyright 2012 American Association for Aerosol Research

Raman Spectroscopy of Isotopic Water Diffusion in Ultraviscous, Glassy, and Gel States in Aerosol by Use of Optical Tweezers.

The formation of ultraviscous, glassy, and amorphous gel states in aqueous aerosol following the loss of water results in nonequilibrium dynamics due to the extended time scales for diffusive mixing. Existing techniques for measuring water diffusion by isotopic exchange are limited by contact of samples with the substrate, and methods applied to infer diffusion coefficients from mass transport in levitated droplets requires analysis by complex coupled differential equations to derive diffusion coefficients. We present a new technique that combines contactless levitation with aerosol optical tweezers with isotopic exchange (D2O/H2O) to measure the water diffusion coefficient over a broad range (Dw ≈ 10(-12)-10(-17) m(2)·s(-1)) in viscous organic liquids (citric acid, sucrose, and shikimic acid) and inorganic gels (magnesium sulfate, MgSO4). For the organic liquids in binary and ternary mixtures, Dw depends on relative humidity and follows a simple compositional Vignes relationship. In MgSO4 droplets, water diffusivity decreases sharply with water activity and is consistent with predictions from percolation theory. These measurements show that, by combining micrometer-sized particle levitation (a contactless measurement with rapid mixing times) with an established probe of water diffusion, Dw can be simply and directly quantified for amorphous and glassy states that are inaccessible to existing methods.

Simultaneous Analysis of the Equilibrium Hygroscopicity and Water Transport Kinetics of Liquid Aerosol

We demonstrate that the equilibrium hygroscopic response of an aerosol droplet and the kinetics of water condensation and evaporation can be retrieved with high accuracy, even close to saturation, through comparative measurements of probe and sample aerosol droplets. The experimental methodology is described and is based on an electrodynamic balance with a newly designed trapping chamber. Through use of a probe aerosol, composed of either pure water or a sodium chloride solution of known concentration, the gas-phase relative humidity (RH) can be accurately measured with an uncertainty of typically <0.005. By fast manipulation of the airflows into the chamber, a step-change in RH over a time scale of <0.5 s can be achieved. Using this approach, the kinetics of mass transfer are studied using the comparative procedure, and results are compared to theoretical mass flux predictions. The time-dependent measured mass fluxes for sodium chloride, ammonium sulfate, sorbitol, and galactose are used to calculate droplet water activities as a function of the droplet growth factor, allowing retrieval of a hygroscopic growth curve in a matter of seconds. Comparisons with both new and established thermodynamic predictions of hygroscopicity, as well as to optical tweezers measurements, are presented, demonstrating good agreement within the experimental uncertainties.

Dynamics of aerosol size during inhalation: Hygroscopic growth of commercial nebulizer formulations

The size of aerosol particles prior to, and during, inhalation influences the site of deposition within the lung. As such, a detailed understanding of the hygroscopic growth of an aerosol during inhalation is necessary to accurately model the deposited dose. In the first part of this study, it is demonstrated that the aerosol produced by a nebulizer, depending on the airflows rates, may experience a (predictable) wide range of relative humidity prior to inhalation and undergo dramatic changes in both size and solute concentration. A series of sensitive single aerosol analysis techniques are then used to make measurements of the relative humidity dependent thermodynamic equilibrium properties of aerosol generated from four common nebulizer formulations. Measurements are also reported of the kinetics of mass transport during the evaporation or condensation of water from the aerosol. Combined, these measurements allow accurate prediction of the temporal response of the aerosol size prior to and during inhalation. Specifically, we compare aerosol composed of pure saline (150 mM sodium chloride solution in ultrapure water) with two commercially available nebulizer products containing relatively low compound doses: Breath®, consisting of a simple salbutamol sulfate solution (5 mg/2.5 mL; 1.7 mM) in saline, and Flixotide® Nebules, consisting of a more complex stabilized fluticasone propionate suspension (0.25 mg/mL; 0.5 mM in saline. A mimic of the commercial product Tobi© (60 mg/mL tobramycin and 2.25 mg/mL NaCl, pH 5.5-6.5) is also studied, which was prepared in house. In all cases, the presence of the pharmaceutical was shown to have a profound effect on the magnitude, and in some cases the rate, of the mass flux of water to and from the aerosol as compared to saline. These findings provide physical chemical evidence supporting observations from human inhalation studies, and suggest that using the growth dynamics of a pure saline aerosol in a lung inhalation model to represent nebulizer formulations may not be representative of the actual behavior of the aerosolized drug solutions.

Temperature dependence of the vapor pressure and evaporation coefficient of supercooled water

We report measurements of the vapor pressure of water over the supercooled temperature range 248 to 273 K derived from evaporation kinetics measurements of single water droplets. Accurate measurements of the relative humidity of the surrounding gas phase are derived from comparative and sequential measurements of the evaporation kinetics of droplets containing sodium chloride. The temperature dependence of the vapor pressure of supercooled water is shown to conform closely to the parameterization provided by Murphy and Koop (2005) once the uncertainties in experimental and thermophysical parameters are accounted for by ensuring an accurate representation of evaporation rates at temperatures above 273 K. Further, from a sensitivity analysis of all of the data over the full temperature range from 248 to 293 K, we can conclude that the evaporation coefficient of water, and thus the mass accommodation coefficient, is greater than, or equal to, 0.5.

Dynamics of Particle Size on Inhalation of Environmental Aerosol and Impact on Deposition Fraction

Inhalation of elevated levels of particulate air pollution has been shown to elicit the onset of adverse health effects in humans, where the magnitude of the response is a product of where in the lung the particulate dose is delivered. At any point in time during inhalation the depositional flux of the aerosol is a function of the radius of the droplet, thus a detailed understanding of the rate and magnitude of the mass flux of water to the droplet during inhalation is crucial. In this study, we assess the impact of aerosol hygroscopicity on deposited dose through the inclusion of a detailed treatment of the mass flux of water to account for the dynamics of particle size in a modified version of the standard International Commission on Radiological Protection (ICRP) whole lung deposition model. The ability to account for the role of the relative humidity (RH) of the aerosol prior to, and during, inhalation on the deposition pattern is explored, and found to have a significant effect on the deposition pattern. The model is verified by comparison to previously published measurements, and used to demonstrate that ambient RH affects where in the lung indoor particulate air pollution is delivered.