Jet-Rung Chang

Investigation of efficiency droop for InGaN-based UV light-emitting diodes with InAlGaN barrier

The efficiency droop in InGaN-based UV light emitting device (LED) with AlGaN and InAlGaN barrier is investigated. Electroluminescence results indicate that the light performance of quaternary LEDs can be enhanced by 25% and 55% at 350 mA and 1000 mA, respectively. Furthermore, simulations show that quaternary LEDs exhibit 62% higher radiative recombination rate and low efficiency degradation of 13% at a high injection current. We attribute this improvement to increasing of carrier concentration and uniform redistribution of carriers.

The Roles of Threading Dislocations on Electrical Properties of AlGaN/GaN Heterostructure Grown by MBE

The role played by different types of threading dislocations (TDs) on the electrical properties of AlGaN/GaN heterostructure grown by plasma-assisted molecular beam epitaxy (MBE) was investigated. Samples with different defect structures and densities were prepared and measurements were taken from the same sample to study the correlative behavior of various TDs. From the Hall measurement, the electron mobility in two-dimensional electron gas channel was mainly controlled by the edge dislocation, which has a dominant amount in the material. The edge TDs acted as Coulomb scattering centers inside the channel and reduces the carrier mobility and increased its resistance. Screw TDs played a much significant role than edge TDs in determining the reverse-bias leakage current of Schottky barrier diodes. Leakage current is affected slightly by the reduction of free carrier density in the channel for samples with a higher edge TD density, but screw TD, which acted as the current leakage path, was more deleterious to the reverse-bias leakage current of AlGaN/GaN structure.

Highly Efficient and Bright LEDs Overgrown on GaN Nanopillar Substrates

We presented a study of high-performance GaN-based light emitting diodes (LEDs) using a GaN nanopillars (NPs) structure grown on sapphire substrate by integrating RF-plasma molecular beam epitaxy (MBE) and metal-organic chemical vapor deposition (MOCVD). Nanoscale air voids were clearly observed at the interface between GaN NPs and the overgrown GaN layer by cross-sectional scanning electron microscopy. It can increase the light-extraction efficiency due to additional light scattering. The transmission electron microscopy images suggest the air voids between GaN NPs introduced during nanoscale epitaxial lateral overgrowth of GaN can suppress the threading dislocation density. Moreover, Raman spectrum demonstrated that the strain of the GaN layer grown on GaN NPs was effectively eliminated, resulting in the reduction of quantum-confined Stark effect in InGaN/GaN quantum wells. Consequently, the LEDs fabricated on the GaN NPs template exhibit smaller electroluminescent peak wavelength blue shift and great enhancement of the light output (70% at 20 mA) compared with the conventional LEDs.

Electrically driven green, olivine, and amber color nanopyramid light emitting diodes

We report the fabrication and studies of electrically driven green, olivine, and amber color nanopyramid GaN light emitting diodes (LEDs). InGaN/GaN multiple quantum wells (MQWs) were grown on the nanopyramid semipolar facets. Compared with the commonly used (0001) c-plane MQWs, the semipolar facet has lower piezoelectric field, resulting in much faster radiative recombination efficiency. This is important for high In content MQWs. The measured internal quantum efficiencies for green, olivine, and amber color LED are 30%, 25%, and 21%, respectively. The radiative and non-radiative lifetime of the semipolar MQWs are also investigated.

InGaN/GaN multiple-quantum-well nanopyramid-on-pillar light-emitting diodes

We report the study of an electrically driven nanopyramid-on-pillar green light-emitting diode (LED). The pyramid-on-pillar nanostructure was fabricated by top-down etching from a GaN template, followed by epitaxial regrowth. High-In-content InGaN/GaN multiple quantum wells (MQWs) were grown on semipolar pyramid and nonpolar pillar surfaces. The measured radiative lifetimes of MQWs on these two surfaces were 2 orders of magnitude shorter than that of a conventional c-plane (0001) MQW owing to their lower polarization field. Electrical injection performance was also demonstrated and discussed.

Epitaxial Overgrowth of Gallium Nitride Nano-Rods on Silicon (111) Substrates by RF-Plasma-Assisted Molecular Beam Epitaxy

Strain-free gallium nitride (GaN) overgrowth on GaN nano-rods is realized by RF-plasma assisted molecular beam epitaxy (RF-MBE) on silicon (Si) substrate. The strain-free condition was identified by the strong free A exciton (FXA) photoluminescence (PL) peak at 3.478 eV and the E2 high phonon Raman shift of 567 cm-1. It is clearly demonstrated that the critical diameter of GaN nano-rods is around 80 nm for the overgrowth of strain-free GaN. The blue-shift of PL peak energy and phonon Raman energy with decreasing the diameter of nano-rod result from the strain relaxation of overgrowth GaN.

Coreshell InGaN/GaN MQW nanorod photovoltaic device

We report the fabrication and study of coreshell InGaN/GaN multiple quantum well (MQW) nanorod photovoltaic device. The nanorods were fabricated from a GaN substrate by top-down etch, followed by InGaN/GaN MQW growth. The 3D geometry allows higher Indium incorporation and extends the solar absorption spectral range as compared with a planar reference sample. The proof-of-concept coreshell nanorod photovoltaic device has a fill factor of about 54.2%, the short current density of 1.16 mA/cm2, the open circuit voltage of 0.68 V, and the power conversion efficiency of 0.38%, respectively.

Reduction of efficiency droop in InGaN-Based UV Light-Emitting Diodes with InAlGaN Barrier

The UV LEDs with quaternary InAlGaN barrier exhibit higher radiative recombination rate and low efficiency droop at a high injection current because of the better band-offset ratio and the higher carrier mobility.

On the doping effects for linearity improvement of InGaP/InGaAs PHEMT

In this paper, doping effects for linearity improvement of InGaP/InGaAs PHEMT devices are discussed. The doping techniques of interest are the light channel doping and the uniform doping introduced to the conventional 5-doped PHEMT structure. Circuit analysis is performed for estimation of the third-order intermodulation distortion levels (IM3). The linearity performance is compared through the extracted parameters from measurement.

The crystalline and optical properties of (1122) semipolar GaN and InGaN/GaN MQWs on (1100) M-sapphire

We report the growth temperature effect on the crystalline and optical properties of (112̅2) semipolar GaN and InGaN/GaN MQWs. It shows that a lower growth temperature at 1020 °C produces better crystalline and optical properties.