K.W. Struve

Tungsten wire-array Z-pinch experiments at 200 TW and 2 MJ

Here Z, a 60 TW/5 MJ electrical accelerator located at Sandia National Laboratories, has been used to implode tungsten wire-array Z pinches. These arrays consisted of large numbers of tungsten wires (120–300) with wire diameters of 7.5 to 15 μm placed in a symmetric cylindrical array. The experiments used array diameters ranging from 1.75 to 4 cm and lengths from 1 to 2 cm. A 2 cm long, 4 cm diam tungsten array consisting of 240, 7.5 μm diam wires (4.1 mg mass) achieved an x-ray power of ∼200 TW and an x-ray energy of nearly 2 MJ. Spectral data suggest an optically thick, Planckian-like radiator below 1000 eV. One surprising experimental result was the observation that the total radiated x-ray energies and x-ray powers were nearly independent of pinch length. These data are compared with two-dimensional radiation magnetohydrodynamic code calculations.

Pulsed-power-driven high energy density physics and inertial confinement fusion research

The Z accelerator [R. B. Spielman, W. A. Stygar, J. F. Seamen et al., Proceedings of the 11th International Pulsed Power Conference, Baltimore, MD, 1997, edited by G. Cooperstein and I. Vitkovitsky (IEEE, Piscataway, NJ, 1997), Vol. 1, p. 709] at Sandia National Laboratories delivers ∼20MA load currents to create high magnetic fields (>1000T) and high pressures (megabar to gigabar). In a z-pinch configuration, the magnetic pressure (the Lorentz force) supersonically implodes a plasma created from a cylindrical wire array, which at stagnation typically generates a plasma with energy densities of about 10MJ∕cm3 and temperatures >1keV at 0.1% of solid density. These plasmas produce x-ray energies approaching 2MJ at powers >200TW for inertial confinement fusion (ICF) and high energy density physics (HEDP) experiments. In an alternative configuration, the large magnetic pressure directly drives isentropic compression experiments to pressures >3Mbar and accelerates flyer plates to >30km∕s for equation of state ...

FILTERED X-RAY DIODE DIAGNOSTICS FIELDED ON THE Z ACCELERATOR FOR SOURCE POWER MEASUREMENTS

Filtered x-ray diode (XRD) detectors are used as primary radiation flux diagnostics on Sandia’s Z accelerator, which generates nominally a 200-TW, 2-MJ, x-ray pulse. Given such flux levels and XRD sensitivities the detectors are being fielded 23 m from the source. The standard diagnostic setup and sensitivities are discussed. Vitreous carbon photocathodes are being used to reduce the effect of hydrocarbon contamination present in the Z-machine vacuum system. Nevertheless pre- and postcalibration data taken indicate spectrally dependent changes in the sensitivity of these detectors by up to factors of 2 or 3.

Development and characterization of a Z-pinch-driven hohlraum high-yield inertial confinement fusion target concept

Initial experiments to study the Z-pinch-driven hohlraum high-yield inertial confinement fusion (ICF) concept of Hammer, Tabak, and Porter [Hammer et al., Phys. Plasmas 6, 2129 (1999)] are described. The relationship between measured pinch power, hohlraum temperature, and secondary hohlraum coupling (“hohlraum energetics”) is well understood from zero-dimensional semianalytic, and two-dimensional view factor and radiation magnetohydrodynamics models. These experiments have shown the highest x-ray powers coupled to any Z-pinch-driven secondary hohlraum (26±5 TW), indicating the concept could scale to fusion yields of >200 MJ. A novel, single-sided power feed, double-pinch driven secondary that meets the pinch simultaneity requirements for polar radiation symmetry has also been developed. This source will permit investigation of the pinch power balance and hohlraum geometry requirements for ICF relevant secondary radiation symmetry, leading to a capsule implosion capability on the Z accelerator [Spielman et...

Compact single and nested tungsten-wire-array dynamics at 14–19MA and applications to inertial confinement fusiona)

Wire-array z pinches show promise as a high-power, efficient, reproducible, and low-cost x-ray source for high-yield indirect-drive inertial confinement fusion. Recently, rapid progress has been made in our understanding of the implosion dynamics of compact (20-mm-diam), high-current (11–19MA), single and nested wire arrays. As at lower currents (1–3MA), a single wire array (and both the outer and inner array of a nested system), show a variety of effects that arise from the initially discrete nature of the wires: a long wire ablation phase for 50%-80% of the current pulse width, an axial modulation of the ablation rate prior to array motion, a larger ablation rate for larger diameter wires, trailing mass, and trailing current. Compact nested wire arrays operate in current-transfer or transparent mode because the inner wires remain discrete during the outer array implosion, even for interwire gaps in the outer and inner arrays as small as 0.21mm. These array physics insights have led to nested arrays that...

Insights and applications of two-dimensional simulations to Z-pinch experiments

A two-dimensional (2D) Eulerian radiation-magnetohydrodynamic code has been used to successfully simulate hollow metallic z-pinch experiments fielded on several facilities with a wide variety of drive conditions, time scales, and loads. The 2D simulations of these experiments reproduce important quantities of interest including the radiation pulse energy, power, and pulse width. This match is obtained through the use of an initial condition: the amplitude of a random density perturbation imposed on the initial plasma shell. The perturbations seed the development of magnetically driven Rayleigh–Taylor instabilities which greatly affect the dynamics of the implosion and the resulting production of radiation. Analysis of such simulations allows insights into the physical processes by which these calculations reproduce the experimental results. As examples, the insights gained from the simulations of Sandia “Z” accelerator [R. B. Spielman et al., Phys. Plasmas 5, 2105 (1998)] experiments have allowed for the ...

Effect of current rate on energy deposition into exploding metal wires in vacuum

This paper presents direct experimental proof of a significant increase of energy deposition into a metal core before voltage breakdown with the current rate for nanosecond exploding wires in a vacuum. This effect is demonstrated for nine different refractory and nonrefractory metals. The strongest influence of current rate was demonstrated for tungsten wires. Increasing the current rate from 20 to 150 A/ns changes the wire core from a solid to a cluster-like state. For nonrefractory metals such as Ag, Al, Cu, and Au, fast explosion allows deposition inside a metal core 1.5–2.9 times the atomization enthalpy before voltage breakdown. The slow explosion, with 20 A/ns, gives 2–3 times less energy deposition before voltage breakdown than the fast-explosion mode. The current-rate effect is important for optimization of wire ablation, reduction of the mass left behind in the wire-array load, and final x-ray yield in modern multi-MA wire-array Z-pinch facilities.

Titanium K-shell x-ray production from high velocity wire array implosions on the 20-MA Z accelerator

The advent of the 20-MA Z accelerator [R.B. Spielman, C. Deeney, G.A. Chandler, et al., Phys. Plasmas 5, 2105, (1997)] has enabled implosions of large diameter, high-wire-number arrays of titanium to begin testing Z-pinch K-shell scaling theories. The 2-cm long titanium arrays, which were mounted on a 40-mm diameter, produced between 75{+-}15 to 125{+-}20 kJ of K-shell x-rays. Mass scans indicate that, as predicted, higher velocity implosions in the series produced higher x-ray yields. Spectroscopic analyses indicate that these high velocity implosions achieved peak electron temperatures from 2.7{+-}0.1 to 3.2{+-}0.2 keV and obtained a K-shell emission mass participation of up to 12%.

Efficient argon K-shell radiation from a Z pinch at currents >15 MA

The first observations of gaseous load implosions with over 15 MA in >110 ns on the Z generator [R. B. Spielman et al., Phys. Plasmas 5, 2105 (1998)] are reported. Starting from a diameter of over 8 cm, an argon double-shell Z pinch imploded to under 0.5 cm K-shell emission diameter. With a load mass of 0.8 mg/cm, K-shell x-ray output reached 274±24 kJ in a 15 TW peak power, 12 ns pulse. This record-high yield is consistent with the current-squared scaling predicted for the “efficient” emission regime.

Self-consistent, two-dimensional, magnetohydrodynamic simulations of magnetically driven flyer plates

The intense magnetic field generated by the 20 megaampere Z machine [R. B. Spielman et al., Phys. Plasmas 5, 2105 (1998)] at Sandia National Laboratories is being used as a pressure source for material science studies. An application we have studied in great detail involves using the intense magnetic field to accelerate flyer plates (small metal disks) to very high velocities (>20 km/s) for use in shock loading experiments. We have used two-dimensional (2D) magnetohydrodynamic (MHD) simulation to investigate the physics of accelerating flyer plates using multi-megabar magnetic drive pressures. A typical shock physics load is comprised of conducting electrodes that are highly compressible at multi-megabar pressures. Electrode deformation that occurs during the rise time of the current pulse causes significant inductance increase, which reduces the peak current (drive pressure) relative to a static geometry. This important dynamic effect is modeled self-consistently by driving the MHD simulation with an acc...