Lisa M. Portis

Bioaccumulation and toxicity of single-walled carbon nanotubes to benthic organisms at the base of the marine food chain

As the use of single-walled carbon nanotubes (SWNTs) increases over time, so does the potential for environmental release. This research aimed to determine the toxicity, bioavailability, and bioaccumulation of SWNTs in marine benthic organisms at the base of the food chain. The toxicity of SWNTs was tested in a whole sediment exposure with the amphipod Ampelisca abdita and the mysid Americamysis bahia. In addition, SWNTs were amended to sediment and/or food matrices to determine their bioavailability and bioaccumulation through these routes in A. abdita, A. bahia, and the estuarine amphipod Leptocheirus plumulosus. No significant mortality to any species via sediment or food matrices was observed at concentrations up to 100 ppm. A novel near-infrared fluorescence spectroscopic method was utilized to measure and characterize the body burdens of pristine SWNTs in nondepurated and depurated organisms. We did not detect SWNTs in depurated organisms but quantified them in nondepurated A. abdita fed SWNT-amended algae. After a 28-d exposure to [(14) C]SWNT-amended sediment (100 µg/g) and algae (100 µg/g), [(14) C]SWNT was detected in depurated and nondepurated L. plumulosus amphipods at 0.50 µg/g and 5.38 µg/g, respectively. The results indicate that SWNTs are bioaccessible to marine benthic organisms but do not appear to accumulate or cause toxicity.

Stability and aggregation of silver and titanium dioxide nanoparticles in seawater: Role of salinity and dissolved organic carbon

The behavior and fate of nanoparticles (NPs) in the marine environment are largely unknown and potentially have important environmental and human health implications. The aggregation and fate of NPs in the marine environment are greatly influenced by their interactions with seawater and dissolved organic carbon (DOC). In the present study, the stability and aggregation of 30-nm-diameter silver nanoparticles (AgNPs) capped with citrate and polyvinylpyrrolidone (PVP; AgNP-citrate and AgNP-PVP) and 21-nm-diameter titanium dioxide (TiO(2)) NPs as affected by seawater salinity and DOC were investigated by measuring hydrodynamic diameters and zeta potentials. The added DOC (in humic acid form) stabilized the 3 types of NPs when the seawater salinities were ≤5 parts per thousand (ppt), but the stabilizing effect of DOC was reduced by a higher salinity (e.g., 30 ppt). In addition, AgNP-PVP was more stable than AgNP-citrate in seawater, indicating that surface capping agents and stabilization mechanisms govern the stability and aggregation of NPs. Statistical analysis showed that salinity is the most dominant influence on the stability and aggregation of AgNPs and TiO(2) NPs, followed by DOC. These findings expand our knowledge on the behavior of AgNPs and TiO2 NPs in seawater and indicate that the fate of these NPs will be primarily to aggregate in the water column, precipitate, and accumulate in sediments following release into the marine environment.

Effects of single-walled carbon nanotubes on the bioavailability of PCBs in field-contaminated sediments

Abstract Adsorption of hydrophobic organic contaminants (HOCs) to black carbon is a well-studied phenomenon. One emerging class of engineered black carbon materials are single-walled carbon nanotubes (SWNTs). Little research has investigated the potential of SWNT to adsorb and sequester HOCs in complex environmental systems. This study addressed the capacity of SWNT, amended to polychlorinated biphenyl (PCB)-contaminated New Bedford Harbor (NBH) sediment, to reduce the toxicity and bioaccumulation of these HOCs to benthic organisms. Overall, SWNT amendments increased the survival of two benthic estuarine invertebrates, Americamysis bahia and Ampelisca abdita, and reduced the accumulation of PCBs to the benthic polychaete, Nereis virens. Reduction in PCB bioaccumulation by SWNT was independent of Kow. Further, passive sampling-based estimates of interstitial water concentrations indicated that SWNT reduced PCB bioavailability. Results from this study suggest that SWNT are a good adsorbent for PCBs and might be useful for remediation in the future once SWNT manufacturing technology improves and costs decrease.

Linkage of Genomic Biomarkers to Whole Organism End Points in a Toxicity Identification Evaluation (TIE)

Aquatic organisms are exposed to many toxic chemicals and interpreting the cause and effect relationships between occurrence and impairment is difficult. Toxicity Identification Evaluation (TIE) provides a systematic approach for identifying responsible toxicants. TIE relies on relatively uninformative and potentially insensitive toxicological end points. Gene expression analysis may provide needed sensitivity and specificity aiding in the identification of primary toxicants. The current work aims to determine the added benefit of integrating gene expression end points into the TIE process. A cDNA library and a custom microarray were constructed for the marine amphipod Ampelisca abdita. Phase 1 TIEs were conducted using 10% and 40% dilutions of acutely toxic sediment. Gene expression was monitored in survivors and controls. An expression-based classifier was developed and evaluated against control organisms, organisms exposed to low or medium toxicity diluted sediment, and chemically selective manipulations of highly toxic sediment. The expression-based classifier correctly identified organisms exposed to toxic sediment even when little mortality was observed, suggesting enhanced sensitivity of the TIE process. The ability of the expression-based end point to correctly identify toxic sediment was lost concomitantly with acute toxicity when organic contaminants were removed. Taken together, this suggests that gene expression enhances the performance of the TIE process.

Use of a novel sediment exposure to determine the effects of triclosan on estuarine benthic communities

Triclosan (5-chloro-2-[2,4-dichlorophenoxy]phenol) is a relatively new, commonly used antimicrobial compound found in many personal care products. Triclosan is toxic to marine organisms at the micrograms per liter level, can photodegrade to a dioxin, can accumulate in humans, and has been found to be stable in marine sediments for over 30 years. To determine the effects of triclosan on marine benthic communities, intact sediment cores were brought into the laboratory and held under flowing seawater conditions. A 2-cm layer of triclosan-spiked sediment was applied to the surface, and after a two-week exposure the meio- and macrofaunal communities were assessed for differences in composition relative to nonspiked cores. A high triclosan treatment (180 mg/kg dry wt) affected both the meio- and the macrobenthic communities. There were no discernible differences with a low-triclosan treatment (14 mg/kg dry wt). This exposure method is effective for testing the benthic community response to sediment contaminants, but improvements should be made with regard to the amount and method of applying the overlying sediment to prevent smothering of fragile benthic organisms.

Distribution, magnitude and characterization of the toxicity of Ukrainian estuarine sediments

During the Soviet era, Ukraine was an important industrial and agricultural region of the Soviet Union. This industrial and agricultural activity resulted in contamination of Ukraines estuaries with legacy anthropogenic pollutants. Investigations on the toxicological effects of this estuarine contamination have been limited. For this research, we measured the toxicity of contaminated sediments from four Ukrainian estuaries to several aquatic organisms over 3 years. Sediment chemical analyses and whole sediment toxicity identification evaluations (TIEs) were also performed to determine the classes of contaminants contributing to toxicity. Toxic sediments were observed in several of the Ukrainian estuaries and chemical analyses of the sediments demonstrated anthropogenic contaminants were widely distributed. Contaminants were also detected in macrobenthic organisms collected from the sediments. Several lines of evidence, including TIEs, indicated hydrophobic organic chemicals (HOCs) were contributing substantially to observed toxicity. This information can guide environmental managers to prioritize portions of the estuaries requiring remediation.

Effects of micronized and nano‐copper azole on marine benthic communities

The widespread use of copper nanomaterials (CuNMs) as antibacterial and antifouling agents in consumer products increases the risk for metal contamination and adverse effects in aquatic environments. Information gaps exist on the potential toxicity of CuNMs in marine environments. We exposed field-collected marine meio- and macrobenthic communities to sediments spiked with micronized copper azole (MCA) using a novel method that brings intact benthic cores into the laboratory and exposes the organisms via surface application of sediments. Treatments included field and laboratory controls, 3 spiked sediments: low-MCA (51.9 mg/kg sediment), high-MCA (519 mg/kg sediment), and CuSO4 (519 mg/kg sediment). In addition, single-species acute testing was performed with both MCA and CuSO4. Our results indicate that meio- and macrofaunal assemblages exposed to High-MCA and CuSO4 treatments differed significantly from both the laboratory control and the low-MCA treatments. Differences in macrofauna were driven by decreases in 3 Podocopa ostracod species, the bivalve Gemma gemma, and the polychaetes Exogone verugera and Prionospio heterobranchia relative to the laboratory control. Differences in the meiofaunal community are largely driven by nematodes. The benthic community test results were more sensitive than the single-species test results. Findings of this investigation indicate that CuNMs represent a source of risk to marine benthic communities comparable to that of dissolved Cu. Environ Toxicol Chem 2018;37:362-375. Published 2017 Wiley Periodicals Inc. on behalf of SETAC. This article is a US government work and, as such, is in the public domain in the United States of America.

Assessing the release of copper from nanocopper‐treated and conventional copper‐treated lumber into marine waters II: Forms and bioavailability

One application of nanocopper is as a wood-preserving pesticide in pressure-treated lumber. Recent research has shown that pressure-treated lumber amended with micronized copper azole (MCA), which contains nanosized copper, releases copper under estuarine and marine conditions. The form of copper released (i.e., ionic, nanocopper [1-100 nm in size]) is not fully understood but will affect the bioavailability and toxicity of the metal. In the present study, multiple lines of evidence, including size fractionation, ion-selective electrode electrochemistry, comparative toxicity, and copper speciation were used to determine the form of copper released from lumber blocks and sawdust. The results of all lines of evidence supported the hypothesis that ionic copper was released from MCA lumber and sawdust, with little evidence that nanocopper was released. For example, copper concentrations in size fractionations of lumber block aqueous leachates including unfiltered, 0.1 μm, and 3 kDa were not significantly different, suggesting that the form of copper released was in the size range operationally defined as dissolved. These results correlated with the ion-selective electrode data which detects only ionic copper. In addition, comparative toxicity testing resulted in a narrow range of median lethal concentrations (221-257 μg/L) for MCA lumber blocks and CuSO4 . We conclude that ionic copper was released from the nanocopper pressure-treated lumber under estuarine and marine conditions. Environ Toxicol Chem 2018;37:1969-1979. Published 2018 Wiley Periodicals Inc. on behalf of SETAC. This article is a US government work and, as such, is in the public domain in the United States of America.

Magnitude of acute toxicity of marine sediments amended with conventional copper and nanocopper

It is well known that copper (Cu) is toxic to marine organisms. We measured and compared the acute toxicity of several forms of Cu (including nanoCu) amended into a marine sediment with mysids and amphipods. For all the forms of Cu tested, toxicity, measured as the median lethal concentration, ranged from 708 to > 2400 mg Cu/kg (dry sediment) for mysids and 258 to 1070 mg Cu/kg (dry sediment) for amphipods. Environ Toxicol Chem 2018;37:2677-2681.