Sarah E. Minson

The 2011 Magnitude 9.0 Tohoku-Oki Earthquake: Mosaicking the Megathrust from Seconds to Centuries

Detailed geophysical measurements reveal features of the 2011 Tohoku-Oki megathrust earthquake. Geophysical observations from the 2011 moment magnitude (Mw) 9.0 Tohoku-Oki, Japan earthquake allow exploration of a rare large event along a subduction megathrust. Models for this event indicate that the distribution of coseismic fault slip exceeded 50 meters in places. Sources of high-frequency seismic waves delineate the edges of the deepest portions of coseismic slip and do not simply correlate with the locations of peak slip. Relative to the Mw 8.8 2010 Maule, Chile earthquake, the Tohoku-Oki earthquake was deficient in high-frequency seismic radiation—a difference that we attribute to its relatively shallow depth. Estimates of total fault slip and surface secular strain accumulation on millennial time scales suggest the need to consider the potential for a future large earthquake just south of this event.

Moment Tensor Inversions of Icequakes on Gornergletscher, Switzerland

We have determined seismic source mechanisms for shallow and intermediate-depth icequake clusters recorded on the glacier Gornergletscher, Switzerland, during the summers of 2004 and 2006. The selected seismic events are part of a large data set of over 80,000 seismic events acquired with a dense seismic network deployed in order to study the yearly rapid drainage of Gornersee lake, a nearby ice-marginal lake. Using simple frequency and distance scaling and Green’s functions for a homogeneous half-space, we calculated moment tensor solutions for icequakes with M_w-1.5 using a full-waveform inversion method usually applied to moderate seismic events (M_w>4) recorded at local to regional distances (≈50–700 km). Inversions from typical shallow events are shown to represent tensile crack openings. This explains well the dominating Rayleigh waves and compressive first motions observed at all recording seismograms. As these characteristics can be observed in most icequake signals, we believe that the vast majority of icequakes recorded in the 2 yr is due to tensile faulting, most likely caused by surface crevasse openings. We also identified a shallow cluster with somewhat atypical waveforms in that they show less dominant Rayleigh waves and quadrantal radiation patterns of first motions. Their moment tensors are dominated by a large double-couple component, which is strong evidence for shear faulting. Although less than a dozen such icequakes have been identified, this is a substantial result as it shows that shear faulting in glacier ice is generally possible even in the absence of extreme flow changes such as during glacier surges. A third source of icequakes was located at 100 m depth. These sources can be represented by tensile crack openings. Because of the high-hydrostatic pressure within the ice at these depths, these events are most likely related to the presence of water lenses that reduce the effective stress to allow for tensile faulting.

The 2013 Mw 7.7 Balochistan Earthquake: Seismic Potential of an Accretionary Wedge

Great earthquakes rarely occur within active accretionary prisms, despite the intense long‐term deformation associated with the formation of these geologic structures. This paucity of earthquakes is often attributed to partitioning of deformation across multiple structures as well as aseismic deformation within and at the base of the prism (Davis et al., 1983). We use teleseismic data and satellite optical and radar imaging of the 2013 M_w 7.7 earthquake that occurred on the southeastern edge of the Makran plate boundary zone to study this unexpected earthquake. We first compute a multiple point‐source solution from W‐phase waveforms to estimate fault geometry and rupture duration and timing. We then derive the distribution of subsurface fault slip from geodetic coseismic offsets. We sample for the slip posterior probability density function using a Bayesian approach, including a full description of the data covariance and accounting for errors in the elastic structure of the crust. The rupture nucleated on a subvertical segment, branching out of the Chaman fault system, and grew into a major earthquake along a 50° north‐dipping thrust fault with significant along‐strike curvature. Fault slip propagated at an average speed of 3.0  km/s for about 180 km and is concentrated in the top 10 km with no displacement on the underlying decollement. This earthquake does not exhibit significant slip deficit near the surface, nor is there significant segmentation of the rupture. We propose that complex interaction between the subduction accommodating the Arabia–Eurasia convergence to the south and the Ornach Nal fault plate boundary between India and Eurasia resulted in the significant strain gradient observed prior to this earthquake. Convergence in this region is accommodated both along the subduction megathrust and as internal deformation of the accretionary wedge.

Real-time inversions for finite fault slip models and rupture geometry based on high-rate GPS data

We present an inversion strategy capable of using real-time high-rate GPS data to simultaneously solve for a distributed slip model and fault geometry in real time as a rupture unfolds. We employ Bayesian inference to find the optimal fault geometry and the distribution of possible slip models for that geometry using a simple analytical solution. By adopting an analytical Bayesian approach, we can solve this complex inversion problem (including calculating the uncertainties on our results) in real time. Furthermore, since the joint inversion for distributed slip and fault geometry can be computed in real time, the time required to obtain a source model of the earthquake does not depend on the computational cost. Instead, the time required is controlled by the duration of the rupture and the time required for information to propagate from the source to the receivers. We apply our modeling approach, called Bayesian Evidence-based Fault Orientation and Real-time Earthquake Slip, to the 2011 Tohoku-oki earthquake, 2003 Tokachi-oki earthquake, and a simulated Hayward fault earthquake. In all three cases, the inversion recovers the magnitude, spatial distribution of slip, and fault geometry in real time. Since our inversion relies on static offsets estimated from real-time high-rate GPS data, we also present performance tests of various approaches to estimating quasi-static offsets in real time. We find that the raw high-rate time series are the best data to use for determining the moment magnitude of the event, but slightly smoothing the raw time series helps stabilize the inversion for fault geometry.

Seismically and geodetically determined nondouble‐couple source mechanisms from the 2000 Miyakejima volcanic earthquake swarm

The volcanic eruption on Miyakejima, Japan, in 2000 was marked by the largest earthquake swarm ever recorded in Japan, a seismicity migration accompanying a dike intrusion as the dike propagated from Miyakejima to the northwest, and formation of a caldera on Mount Oyama on Miyakejima. In this study, we propose a seismic source model which can be used to model both seismic and geodetic displacements from volcanic earthquakes. Our model, the “crack + double-couple” (CDC) model, combines tensile opening with shear slip along a single fault plane. We find that this model can fit both seismic and GPS data from the 1 July and 30 July earthquakes, the largest two in the Miyakejima sequence. The results of our GPS inversions for these two earthquakes are consistent with the seismic mechanisms and aftershock locations, and the GPS mechanisms successfully forward predict the observed regional seismograms. The 1 July earthquake, located near the northwest tip of the dike, has a large opening component and a geodetic moment about 5 times larger than that inferred from the seismic data alone. The source process for this event consists of tensile failure, which occurred quickly, and a much slower accumulation of shear slip. We apply the CDC model to 16 additional earthquakes from this sequence and find that the CDC model fits the seismic data for these earthquakes at least as well as established seismic moment tensor models.

Compositional variations in sands of the Bagnold Dunes, Gale crater, Mars, from visible‐shortwave infrared spectroscopy and comparison with ground truth from the Curiosity rover

During its ascent up Mount Sharp, the Mars Science Laboratory Curiosity rover traversed the Bagnold Dune Field. We model sand modal mineralogy and grain size at four locations near the rover traverse, using orbital shortwave infrared single-scattering albedo spectra and a Markov chain Monte Carlo implementation of Hapkes radiative transfer theory to fully constrain uncertainties and permitted solutions. These predictions, evaluated against in situ measurements at one site from the Curiosity rover, show that X-ray diffraction-measured mineralogy of the basaltic sands is within the 95% confidence interval of model predictions. However, predictions are relatively insensitive to grain size and are nonunique, especially when modeling the composition of minerals with solid solutions. We find an overall basaltic mineralogy and show subtle spatial variations in composition in and around the Bagnold Dunes, consistent with a mafic enrichment of sands with cumulative aeolian-transport distance by sorting of olivine, pyroxene, and plagioclase grains. Furthermore, the large variations in Fe and Mg abundances (~20 wt %) at the Bagnold Dunes suggest that compositional variability may be enhanced by local mixing of well-sorted sand with proximal sand sources. Our estimates demonstrate a method for orbital quantification of composition with rigorous uncertainty determination and provide key constraints for interpreting in situ measurements of compositional variability within Martian aeolian sandstones.

Crowdsourced earthquake early warning

Consumer devices and real and simulated earthquake data demonstrate that earthquake early warning can be achieved via crowdsourcing. Earthquake early warning (EEW) can reduce harm to people and infrastructure from earthquakes and tsunamis, but it has not been implemented in most high earthquake-risk regions because of prohibitive cost. Common consumer devices such as smartphones contain low-cost versions of the sensors used in EEW. Although less accurate than scientific-grade instruments, these sensors are globally ubiquitous. Through controlled tests of consumer devices, simulation of an Mw (moment magnitude) 7 earthquake on California’s Hayward fault, and real data from the Mw 9 Tohoku-oki earthquake, we demonstrate that EEW could be achieved via crowdsourcing.

The Iquique earthquake sequence of April 2014: Bayesian modeling accounting for prediction uncertainty

The subduction zone in northern Chile is a well-identified seismic gap that last ruptured in 1877. On 1 April 2014, this region was struck by a large earthquake following a two week long series of foreshocks. This study combines a wide range of observations, including geodetic, tsunami, and seismic data, to produce a reliable kinematic slip model of the Mw=8.1 main shock and a static slip model of the Mw=7.7 aftershock. We use a novel Bayesian modeling approach that accounts for uncertainty in the Greens functions, both static and dynamic, while avoiding nonphysical regularization. The results reveal a sharp slip zone, more compact than previously thought, located downdip of the foreshock sequence and updip of high-frequency sources inferred by back-projection analysis. Both the main shock and the Mw=7.7 aftershock did not rupture to the trench and left most of the seismic gap unbroken, leaving the possibility of a future large earthquake in the region.

Slip rates and spatially variable creep on faults of the northern San Andreas system inferred through Bayesian inversion of Global Positioning System data

Fault creep, depending on its rate and spatial extent, is thought to reduce earthquake hazard by releasing tectonic strain aseismically. We use Bayesian inversion and a newly expanded GPS data set to infer the deep slip rates below assigned locking depths on the San Andreas, Maacama, and Bartlett Springs Faults of Northern California and, for the latter two, the spatially variable interseismic creep rate above the locking depth. We estimate deep slip rates of 21.5 ± 0.5, 13.1 ± 0.8, and 7.5 ± 0.7 mm/yr below 16 km, 9 km, and 13 km on the San Andreas, Maacama, and Bartlett Springs Faults, respectively. We infer that on average the Bartlett Springs fault creeps from the Earths surface to 13 km depth, and below 5 km the creep rate approaches the deep slip rate. This implies that microseismicity may extend below the locking depth; however, we cannot rule out the presence of locked patches in the seismogenic zone that could generate moderate earthquakes. Our estimated Maacama creep rate, while comparable to the inferred deep slip rate at the Earths surface, decreases with depth, implying a slip deficit exists. The Maacama deep slip rate estimate, 13.1 mm/yr, exceeds long-term geologic slip rate estimates, perhaps due to distributed off-fault strain or the presence of multiple active fault strands. While our creep rate estimates are relatively insensitive to choice of model locking depth, insufficient independent information regarding locking depths is a source of epistemic uncertainty that impacts deep slip rate estimates.

The Information Content of Pore Fluid δ18O and [Cl−]

AbstractPaleoceanographic proxies indicate that the ocean state during the Last Glacial Maximum (LGM) differed from the modern ocean state. Depth profiles of ocean sediment pore fluid δ18O and [Cl−] have been used to reconstruct the δ18O and salinity at the LGM. Here, it is investigated whether pore fluid profiles can constrain ocean δ18O and salinity at other times and, simultaneously, their ability to constrain the LGM δ18O and salinity. An inverse framework is developed that relies on Bayesian parameter estimation, thus allowing formal separation of prior assumptions from the information in observations. Synthetic problems are used to explore the information about past ocean tracers that can be recovered from pore fluid profiles. It is concluded that prior knowledge of deep ocean mixing time scales is essential to an accurate inverse estimate of LGM ocean salinity and δ18O from modern pore fluid profiles. The most recent 10 000 years of ocean salinity and δ18O and the error in their estimates are bette...