Donald F. Kimball

Design of wide-bandwidth envelope-tracking power amplifiers for OFDM applications

An efficiency-enhanced power-amplifier system design is presented based on wide-bandwidth envelope tracking (WBET) with application to orthogonal frequency-division multiplexing wireless local area network systems. Envelope elimination and restoration (EER) and WBET are compared in terms of the time mismatch sensitivity between the base-band amplitude path and the RF path, and it is demonstrated that WBET is much less sensitive than EER to these effects. An adaptive time-alignment algorithm for the WBET system is developed and demonstrated. The analysis and algorithm are verified by experimental results. The measurement shows that the peak drain efficiency of the complete system was 30% at a 2.4-GHz orthogonal frequency-division multiplexing output power of 20 dBm.

High-Efficiency Envelope-Tracking W-CDMA Base-Station Amplifier Using GaN HFETs

A high-efficiency wideband code-division multiple-access (W-CDMA) base-station amplifier is presented using high-performance GaN heterostructure field-effect transistors to achieve high gain and efficiency with good linearity. For high efficiency, class J/E operation was employed, which can attain up to 80% efficiency over a wide range of input powers and power supply voltages. For nonconstant envelope input, the average efficiency is further increased by employing the envelope-tracking architecture using a wide-bandwidth high-efficiency envelope amplifier. The linearity of overall system is enhanced by digital pre-distortion. The measured average power-added efficiency of the amplifier is as high as 50.7% for a W-CDMA modulated signal with peak-to-average power ratio of 7.67 dB at an average output power of 37.2 W and gain of 10.0 dB. We believe that this corresponds to the best efficiency performance among reported base-station power amplifiers for W-CDMA. The measured error vector magnitude is as low as 1.74% with adjacent channel leakage ratio of -51.0 dBc at an offset frequency of 5 MHz

Open-Loop Digital Predistorter for RF Power Amplifiers Using Dynamic Deviation Reduction-Based Volterra Series

In this paper, we propose an efficient open-loop digital predistorter (DPD) derived from the dynamic deviation reduction-based Volterra series that allows compensation for both nonlinear distortion and memory effects induced by RF power amplifiers in wireless transmitters. In this approach, the parameters of the predistorter can be directly extracted from an offline system identification process. This eliminates the usual requirement for a closed-loop real-time parameter adaptation, which dramatically reduces the implementation complexity of the system. It is shown that a further reduction in system complexity can be achieved by applying under-sampling theory in the model extraction and utilizing parameter interpolation in the DPD implementation. Experimental results show that by utilizing this technique with only a small number of parameters, nonlinear distortion induced by the PA can be significantly reduced, as evaluated by both adjacent channel power ratio reduction and normalized root mean square error improvement. A comparison with a memoryless polynomial function based predistorter and an analysis of the impact of decresting are also presented.

A Monolithic High-Efficiency 2.4-GHz 20-dBm SiGe BiCMOS Envelope-Tracking OFDM Power Amplifier

A monolithic SiGe BiCMOS envelope-tracking power amplifier (PA) is demonstrated for 802.11g OFDM applications at 2.4 GHz. The 4-mm2 die includes a high-efficiency high-precision envelope amplifier and a two-stage SiGe HBT PA for RF amplification. Off-chip digital predistortion is employed to improve EVM performance. The two-stage amplifier exhibits 12-dB gain, <5% EVM, 20-dBm OFDM output power, and an overall efficiency (including the envelope amplifier) of 28%.

Envelope tracking power amplifier with pre-distortion linearization for WLAN 802.11g

This paper presents a power amplifier based on envelope tracking (ET) with application to the WLAN 802.11g system. Baseband pre-distortion is implemented to improve the linearity. A high-efficiency wide-bandwidth envelope amplifier and a GaAs MESFET class AB RFPA are designed and implemented for the system. An overall system drain efficiency of 30% is obtained for an OFDM output power of 20 dBm at 2.4GHz.

Digital Predistortion for Envelope-Tracking Power Amplifiers Using Decomposed Piecewise Volterra Series

Due to dynamic changes of supply voltage, envelope-tracking (ET) power amplifiers (PAs) exhibit very distinct characteristics in different power regions. It is very difficult to compensate the distortion induced by these amplifiers by employing conventional digital predistortion techniques. In this paper, by introducing a new piecewise Volterra model based on a vector threshold decomposition technique, we first set several thresholds in the input power level according to the PA characteristics, and decompose the input complex envelope signal into several sub-signals by using these thresholds. We then process each sub-signal separately by employing the dynamic deviation reduction-based Volterra series, and finally recombine them together to produce the predistorted output. Experimental results show that by using this new decomposed piecewise digital predistorter model, the distinct characteristics of the ET system at different signal power levels can be accurately modeled, and thus, the distortion, including both static nonlinearities and memory effects, caused by the amplifier nonlinear behavior can be effectively compensated.

Wideband envelope elimination and restoration power amplifier with high efficiency wideband envelope amplifier for WLAN 802.11g applications

This paper presents the design of a silicon bipolar Class-E wideband envelope elimination and restoration (WBEER) power amplifier with a wideband high efficiency envelope amplifier. The envelope amplifier is composed of a linear op-amp stage and a switch buck converter, which achieves high fidelity and high efficiency amplification of wideband high peak to average (PAR) envelope signals. Experimental results show that the envelope amplifier has a bandwidth of 20MHz and 50-60% efficiency. An overall EER power added efficiency (PAE) of 28% at an output power of 19 dBm was achieved for a WEAN OFDM signal at 2.4 GHz.

Wideband Envelope Tracking Power Amplifiers With Reduced Bandwidth Power Supply Waveforms and Adaptive Digital Predistortion Techniques

This paper presents a new technique to reduce the bandwidth of the dynamic power supply waveform used in wideband envelope tracking power amplifiers (PAs). When the envelope tracking technique is applied to broadband signals such as WCDMA and 3GPP LTE, the wide bandwidth of the envelope signal makes it difficult to implement the dynamic supply modulator efficiently and accurately. We show here a technique to reduce the bandwidth of the power supply waveform, thereby allowing better efficiency for the supply modulator; and a linearization method for correcting the nonlinearity caused by the bandwidth reduction. The feasibility of this technique is demonstrated for a single carrier WCDMA signal with a 7.6-dB peak-to-average power ratio using a GaAs high-voltage HBT PA. The bandwidth of the power supply waveform is reduced from 20 to 4 MHz. After linearization, the reduced bandwidth envelope tracking PA exhibits an average output power of 28 W, an average gain of 12 dB and an overall power-added efficiency of 49%. The measured normalized rms error is as low as 0.67% with an adjacent channel leakage ratio of -53.9 and -54.2 dBc at offset frequencies of 5 and 10 MHz, respectively.

A Wideband CMOS/GaAs HBT Envelope Tracking Power Amplifier for 4G LTE Mobile Terminal Applications

A high-efficiency envelope tracking power amplifier for long-term evolution (LTE) handset mobile terminals is presented. The envelope amplifier consists of a wideband buffered linear amplifier as a voltage source and a hysteretically controlled switching amplifier as a dependent current source. The linear amplifier has a high current drive capability of approximately 500 mA while consuming only 12 mA of quiescent current. The impact of envelope shaping on system efficiency and stability is investigated. The envelope amplifier is implemented in a 0.15- μm CMOS process and tested with a GaAs HBT RF power amplifier. For a 20-MHz LTE signal with 6.6-dB peak-to-average power ratio, an overall efficiency of 43% is achieved at 29-dBm RF output power level with relative constellation error below 1.9% after digital pre-distortion.

High Efficiency Envelope Tracking LDMOS Power Amplifier for W-CDMA

A high performance W-CDMA base station power amplifier is presented, which uses an envelope tracking bias system along with an advanced 0.4mum gate length LDMOS transistor, to achieve high efficiency. High linearity is also achieved by employing digital predistortion. For a target WCDMA envelope with a peak-to-average power ratio of 7.6 dB, the measured overall power-added efficiency (PAE) is as high as 40.4 %. Within this system, the RF power amplifier has an average drain efficiency of approximately 64%, and the envelope amplifier has about 60% efficiency. After the memoryless digital predistortion the normalized power RMS error is 3.3%, at an average output power of 27 W and gain of 14.9 dB. After memory mitigation the normalized power RMS error drops to below 1.0%. The efficiency ranks among the highest reported for a single stage LDMOS W-CDMA base station amplifier